RESUMEN
A single-longitudinal-mode (SLM), narrow linewidth thulium-doped fiber laser with a sampled fiber Bragg grating (SFBG), switchable among three wavelengths, with a cascade dual-coupler-ring-based compound cavity (DCR-CC) filter, is proposed and demonstrated. The coupling design, simulation analysis, and characterization of the DCR-CC filter provide the foundation for the experiment. A nonlinear polarization rotation system was injected into the cavity to suppress gain competition and achieve a laser switchable among three wavelengths. The fluctuations of the wavelength and power of the output laser are less than 0.60 nm and 0.91 dBm, respectively. For demonstration, the laser maintained in SLM operation measured by the delayed self-heterodyne method has a linewidth of <3.7k H z and relative intensity noise of <-114d B/H z.
RESUMEN
We demonstrate the two-dimensional tunable orbital angular momentum (OAM) generation in a ring-core (vortex) fiber. The LP11 mode generated by an all fiber fused coupler is coupled into a vortex fiber. Because the vector modes of the LP11 mode group in the vortex fiber are no longer degenerate, the mode status will change between linearly polarized modes (LPMs) and complex OAM modes periodically during propagation. The generated OAM can be tuned smoothly by filtering the mixed mode with different polarization directions or changing the wavelength at a certain polarization directions. The two-dimensional tuning of OAM from l=-1 to l=+1 is experimentally demonstrated in an all fiber OAM generator.
RESUMEN
We propose an approach to directly measure the bending effect on individual modes in few-mode fibers using a wavelength-scanning spatially and spectrally resolved imaging technique. By collecting a fiber output beam profile with a scanning wavelength at different bending diameters and analyzing the peaks of its Fourier transformation, we have distinguished higher-order modes (HOMs) of the fiber and investigated their group delay, beam profile, bend loss, and mode splitting individually. We have experimentally verified with a multilayer core fiber at 1-8 cm bending diameters that its HOMs experience more loss compared to lower-order modes, but delay at approximately the same speed as the bending diameter decreases. Mode splitting of the LP11 mode at a small bending diameter due to bending-induced birefringence is also observed and discussed. This method provides an efficient tool to study the bending effect on individual HOMs in fibers and could be extended to studying fiber stretching and twisting.
RESUMEN
We presented a simple method for measuring the mode purity of linearly polarized orbital angular momentum (OAM) modes in optical fibers. The method is based on the analysis of OAM beam projections filtered by a polarizer. The amplitude spectrum and phase spectrum of a data ring derived from the beam pattern are obtained by Fourier transform. Then the coefficients of the mixed electric field expression can be determined and the mode purity can be obtained. The proposed method is validated and it is experimentally demonstrated in a two-mode fiber.
RESUMEN
We present a method in this Letter to generate optical vortices with tunable orbital angular momentum (OAM) in optical fibers. The tunable OAM optical vortex is produced by combining different vector modes HE2,meven (HE2,modd) and TE0,m (TM0,m) when l=1 or combining HEl+1,meven (HEl+1,modd) and EHl-1,modd (EHl-1,meven) when l>1 with a π/2 phase shift. The vortex can be regarded as a result of overlapping two orthogonal optical vortex beams of equal helicity but opposite chirality with a π/2 phase shift. We have experimentally demonstrated the smooth variation of OAM from l=-1 to l=+1 by adjusting a polarizer at the output end of the fiber.