Solution-Processed Cu2S Nanostructures for Solar Hydrogen Production.

Cu2S is a promising solar energy conversion material due to its suitable optical properties, high elemental earth abundance, and nontoxicity. In addition to the challenge of multiple stable secondary phases, the short minority carrier diffusion length poses an obstacle to its practical application. This work addresses the issue by synthesizing nanostructured Cu2S thin films, which enables increased charge carrier collection. A simple solution-processing method involving the preparation of CuCl and CuCl2 molecular inks in a thiol-amine solvent mixture followed by spin coating and low-temperature annealing was used to obtain phase-pure nanostructured (nanoplate and nanoparticle) Cu2S thin films. The photocathode based on the nanoplate Cu2S (FTO/Au/Cu2S/CdS/TiO2/RuO x ) reveals enhanced charge carrier collection and improved photoelectrochemical water-splitting performance compared to the photocathode based on the non-nanostructured Cu2S thin film reported previously. A photocurrent density of 3.0 mA cm-2 at -0.2 versus a reversible hydrogen electrode (V RHE) with only 100 nm thickness of a nanoplate Cu2S layer and an onset potential of 0.43 V RHE were obtained. This work provides a simple, cost-effective, and high-throughput method to prepare phase-pure nanostructured Cu2S thin films for scalable solar hydrogen production.

Drop-casted Platinum Nanocube Catalysts for Hydrogen Evolution Reaction with Ultrahigh Mass Activity.

Platinum hydrogen evolution reaction (HER) electrocatalysts in the form of nanocubes (NCs) were synthesized at 50 °C by aqueous-based colloidal synthesis and were applied to electrochemical (EC) and photoelectrochemical (PEC) systems by a fast and simple drop-casting method. A remarkable Pt mass activity of 1.77 A mg-1 at -100 mV was achieved in EC systems (fluorine-doped tin oxide/Pt NC cathode) with neutral electrolyte while maintaining low overpotential and Tafel slope. In the Cu(In,Ga)(S,Se)2 (CIGS)-based PEC system, a carefully chosen amount of Pt NC loading to achieve a compromise between the catalytic activity (more Pt NCs) and better light transmittance (fewer Pt NCs) led to a maximum onset potential of 0.678 V against the reference hydrogen electrode. The photoelectrodes with Pt NCs also exhibited good long-term operational stability over 9.5 h with negligible degradation of the photocurrent. This study presents an effective strategy to greatly reduce the use of expensive Pt without compromising the catalytic performance because the drop-casting of Pt NC solutions to form electrocatalysts is expected to waste less raw material than vacuum deposition.