RESUMEN
In many nations, particularly those experiencing water scarcity, novel approaches are being applied to clean wastewater. Heterogeneous photocatalysis is the most widely used of these approaches because it entails the decomposition of organic molecules into water and carbon dioxide, which is a more ecologically benign process. In our study, we studied the photocatalytic degradation process on the effluent flumequine. This treatment is made through a solar pilot reactor in the presence of immobilized titanium dioxide with three light intensities and two types of water as solvents. A variety of factors that might influence the rate of deterioration, such as flow rate, light intensity, and initial concentration, have been investigated. The maximal degradation of flumequine was achieved at more than 90% after 2.5 h under optimal conditions (an initial concentration of 5 mg/L, three lamp light intensities, and a flow rate of 29 L/h). By combining the oxidized agent H2O2 with this process, the photocatalytic activity was improved further to 97% under the same conditions. The mineralization of this product has also been tested using total organic carbon (TOC) analysis. A high mineralization rate has been recorded at around 50% for a high initial concentration (20 mg/L) at a flow rate of 126 L/h. The results demonstrated the highly effective removal of flumequine and the efficacy of this photocatalytic system.
RESUMEN
This study deals with the toxicity of the treated solutions of two types of dyes, namely, the anthraquinonic Reactive Bleu 19 dye (RB19) and the bi-azoic Direct Red 227 dye (DR227), which are treated in single and binary mixture systems. The target molecules were removed by the photocatalysis process using ZnO as a catalyst, which was calcined at two temperatures 250 and 420 °C (ZnO250 and ZnO420) prepared in the lab by the one-step calcination method. XRD, TEM, EDX, XPS, FT-IR, BET, RAMAN, and EPR analyses were carried out to characterize the catalyst material. While the phytotoxicity was being conducted using watercress seeds, the cytotoxicity took place using a cell line (raw) and an intestinal cell (caco-2). The XRD analysis showed the partial calcination of ZnO250 and the presence of anhydrous zinc acetate along with the ZnO nanoparticles (NPs). This result was not observed for ZnO420. Despite the complete discoloration (100%) of all the final solutions, ZnO250 exhibited a high cytotoxicity and phytotoxicity against the RB19 dye after the photocatalytic treatment; however, it was not the case of ZnO420 which was selected as an eco-friendly photocatalyst for the degradation of organic dyes based on the results of removal efficiency, cytotoxicity, and phytotoxicity.
Asunto(s)
Colorantes , Textiles , Células CACO-2 , Catálisis , Colorantes/toxicidad , Humanos , Procesos Fotoquímicos , Espectroscopía Infrarroja por Transformada de Fourier , Acetato de Zinc , Óxido de Zinc/toxicidadRESUMEN
Flax shives and beech wood residues represent biomass streams that are abundant in Northwest Europe. These primary feedstocks were evaluated for their suitability to produce biochar as a low environmental-impact adsorbent. The efficacy of the produced biochars was tested by their adsorption capacity towards methylene blue (MB). A series of adsorption tests with carbamazepine is also presented, focusing on the better performing beech wood biochar. Post treatment of the biochars with citric acid (CA) and oxidation of the surface by heating at 250 °C in a muffle oven were carried out to enhance the adsorption capacities of both flax shives biochar (FSBC) and beech biochar (BBC). The resulting physicochemical characteristics are described. The thermally treated biochars have specific surface areas of 388 m2·g-1 and 272 m2·g-1 compared to the untreated biochars with 368 and 142 m2·g-1 for BBC and FSBC, respectively. CA treatment leads to enhancement of the oxygenated surface functional groups and the adsorption capacities of both studied biochars. The non-linear Langmuir and Freundlich models show the best fit for both the isotherm data for MB and the CMZ adsorption with a good correlation between the experimental and calculated adsorption capacities. The effect of adsorbent dosages and initial concentrations of MB and CMZ on the adsorption efficiency is discussed. It can be concluded that beech biochar is a very promising pollutant adsorbent only requiring a mild, low-cost, and low-environmental impact activation treatment for best performance.
RESUMEN
BACKGROUND: Cranioplasties are an important neurosurgical procedure not only for improved cosmesis but also for improved functional recovery after craniectomy with a large cranial defect. The aim of this study was to identify predictive factors of postcranioplasty complications using custom-made porous hydroxyapatite cranioplasty. METHODS: Retrospective review was performed of all patients who underwent a reconstructive cranioplasty using custom-made hydroxyapatite at our institution between February 2008 and September 2017. Postoperative complications considered included bacterial infection, seizures, hydrocephalus requiring ventricular shunt placement, and cranioplasty-to-bone shift. Variables associated at P < 0.1 level in unadjusted analysis were entered into backward stepwise logistic regression models. RESULTS: Of 109 patients included, 15 (13.8%) experienced postoperative infection, with craniectomy performed at an outside institution (adjusted odds ratio [OR] 10.37 [95% confidence interval [CI], 2.03-75.27], P = 0.012) and a previous infection at the surgical site (adjusted OR 6.15 [95%CI, 1.90-19.92], P = 0.003) identified as independent predictors. Six patients (5.5%) experienced postoperative seizures, with stroke (ischemic and hemorrhagic) as a reason for craniectomy (adjusted OR 11.68 [95% CI, 2.56-24.13], P < 0.001) and the presence of seizures in the month before cranioplasty (adjusted OR 9.39 [95% CI, 2.04-127.67], P = 0.002) identified as independent predictors. Four patients (3.7%) experienced postcranioplasty hydrocephalus necessitating shunt placement, and 5 patients (4.6%) experienced cranioplasty-to-bone shift ≥5 mm, but no significant predictive factors were identified for either complication. CONCLUSIONS: This study identified possible predictive factors for postcranioplasty complications to help identify at-risk patients, guide prophylactic care, and improve morbidity of this important surgical procedure.