RESUMEN
This work explored the zinc nanoparticles obtained by the one-stage induction flow levitation method. A 10 kW tube generator with an operating frequency of 440 kHz was used. The process used 8 mm diameter zinc granules (2 g weight) with a purity of 99.9%. Zinc wire was fed to replace the evaporated metal from the granule surface. This method productivity was 30 g/h of nanoparticles. In addition, various methods were used to characterize the resulting nanoparticles: scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-Ray fluorescence analysis (XRF), dynamic light scattering (DLS), porosimetry and inductively coupled plasma atomic emission spectroscopy (ICP-MS). The resulting nanoparticle size, determined by SEM and porosimetry, was 350 nm, while the size of the primary crystallites was 21 nm. The amount of impurities in the resulting nanoparticles did not exceed 1000 ppm.
RESUMEN
The current investigation is focused on the development of composite membranes based on polymeric ionic liquids (PILs) containing imidazolium and pyridinium polycations with various counterions, including hexafluorophosphate, tetrafluoroborate, and bis(trifluoromethylsulfonyl)imide. A combination of spectroscopic methods was used to identify the synthesized PILs and characterize their interaction with carbon dioxide. The density and surface free energy of polymers were performed by wettability measurements, and the results are in good agreement with the permeability and selectivity obtained within the gas transport tests. It was shown that the membranes with a selective layer based on PILs exhibit relatively high permeability with CO2 and high ideal selectivity CO2/CH4 and CO2/N2. Additionally, it was found that the type of an anion significantly affects the performance of the obtained membranes, with the most pronounced effect from bis-triflimide-based polymers, showing the highest permeability coefficient. These results provide valuable insights into the design and optimization of PIL-based membranes for natural and flue gas treatment.
RESUMEN
A mesoporous silica support was synthesized using the sol-gel method from trichlorosilane. There is a tendency for the specific surface area and the proportion of silica particles mesopores to increase during all stages of sol-gel synthesis. It has been shown that the insertion of hexane and toluene, as additional solvents, into the structure-forming polyethylene glycol, makes it possible to regulate the pore size and specific surface area of silica. Silica functionalization was carried out using SILP technology. The activities of the catalytic systems based on polymer and inorganic supports immobilized by imidazole-based ionic liquids during the trichlorosilane disproportionation reaction were compared. There is a tendency for the monosilane yield for catalytic systems based on an inorganic support to increase. We identified the most promising catalyst in terms of monosilane yield and proposed a bifunctional catalyst that exhibited activity in two parallel reactions: trichlorosilane disproportionation and silicon tetrachloride hydrogenation.
