Improved Poly(3,4-Ethylenedioxythiophene) (PEDOT) for Neural Stimulation.

OBJECTIVE: This study compares the stability of three variations of the conductive polymer poly(3,4-ethylenedioxythiophene) or PEDOT for neural micro-stimulation under both in vitro and in vivo conditions. We examined PEDOT films deposited with counter-ions tetrafluoroborate (TFB) and poly(styrenesulfonate) (PSS), and PEDOT: PSS combined with carbon nanotubes (CNTs). METHODS: For the in vitro stability evaluation, implantable micro-wires were coated with the polymers, placed in a vial containing phosphate buffered saline (PBS) under accelerated aging conditions (60°C), and current pulses were applied. The resulting voltage profile was monitored over time. Following the same polymer deposition protocol, chronic neural micro-probes were modified and implanted in the motor cortex of two rats for the in vivo stability comparison. Similar stimulating current pulses were applied and the output voltage was examined. The electrochemical impedance spectroscopic (EIS) data were also recorded and fit to an equivalent circuit model that incorporates and quantifies the time-dependent polymer degradation and impedance associated with tissue surrounding each micro-electrode site. RESULTS: Both in vitro and in vivo voltage output profiles show relatively stable behavior for the PEDOT: TFB modified micro-electrodes compared to the PEDOT: PSS and CNT: PEDOT: PSS modified ones. EIS modeling demonstrates that the time-dependent increase in the polymeric resistance is roughly similar to the rise in the respective voltage output in vivo and indicates that the polymeric stability and conductivity, rather than the impedance due to the tissue response, is the primary factor determining the output voltage profile. It was also noted that the number of electrodes showing unit activity post-surgery did not decay for PEDOT: TFB as was the case for PEDOT: PSS and CNT: PEDOT: PSS. PEDOT: TFB may be an enabling material for achieving long lasting micro-stimulation and recording.

Improving the performance of poly(3,4-ethylenedioxythiophene) for brain-machine interface applications.

Conducting polymers, especially poly(3,4-ethylenedioxythiophene) (PEDOT) based materials, are important for developing highly sensitive and microscale neural probes. In the present work, we show that the conductivity and stability of PEDOT can be significantly increased by switching the widely used counter anion poly(styrenesulfonate) (PSS) to the smaller tetrafluoroborate (TFB) anion during the electrodeposition of the polymer. Time-dependent impedance measurements of polymer modified implantable microwires were conducted in physiological buffer solutions under accelerated aging conditions and the relative stability of PEDOT:PSS and PEDOT:TFB modified microwires was compared over time. This study was also extended to carbon nanotube (CNT) incorporated PEDOT:PSS which, according to some reports, is claimed to enhance the stability and electrical performance of the polymer. However, no noticeable difference was observed between PEDOT:PSS and CNT:PEDOT:PSS in our measurements. At the biologically relevant frequency of 1kHz, PEDOT:TFB modified microwires exhibit approximately one order of magnitude higher conductivity and demonstrate enhanced stability over both PEDOT:PSS and CNT:PEDOT:PSS modified microwires. In addition, PEDOT:TFB is not neurotoxic and we show the proof-of-concept for both in vitro and in vivo neuronal recordings using PEDOT:TFB modified microelectrode arrays and chronic electrodes, respectively. Our findings suggest that PEDOT:TFB is a promising conductive polymer coating for the recording of neural activities.

Dynamic steering of in vitro cortical neurons using field stimulation.

Neurological disorders are often characterized by abnormal neuronal activity. In the case of epilepsy, this can manifest itself in the form of uncontrolled synchronous activity often in the form of bursting. Pattern steering is the ability to apply stimulation to a network that effectively changes its dynamical firing pattern. In an epileptic network, the stimulation would be used to move the seizing network from its abnormal state to a normal state. This idea is explored here in cultured networks of cortical neurons plated on microelectrode arrays. Stimulation was applied to the bath resulting in an electric field generated throughout the network. This field was verified as sub-threshold in strength using a finite element model simulation. Stimulated networks showed a significant suppression in the number of bursts and increase in the interburst interval as compared to control networks. This observed burst suppression suggests that the sub-threshold stimulating field moved networks from a state of high frequency bursting to a state of low frequency bursting.