Conceptual system for sustainable and next-generation wastewater resource recovery facilities.

Shifting the concept of municipal wastewater treatment to recover resources is one of the key factors contributing to a sustainable society. A novel concept based on research is proposed to recover four main bio-based products from municipal wastewater while reaching the necessary regulatory standards. The main resource recovery units of the proposed system include upflow anaerobic sludge blanket reactor for the recovery of biogas (as product 1) from mainstream municipal wastewater after primary sedimentation. Sewage sludge is co-fermented with external organic waste such as food waste for volatile fatty acids (VFAs) production as precursors for other bio-based production. A portion of the VFA mixture (product 2) is used as carbon sources in the denitrification step of the nitrification/denitrification process as an alternative for nitrogen removal. The other alternative for nitrogen removal is the partial nitrification/anammx process. The VFA mixture is separated with nanofiltration/reverse osmosis membrane technology into low-carbon VFAs and high-carbon VFAs. Polyhydroxyalkanoate (as product 3) is produced from the low-carbon VFAs. Using membrane contactor-based processes and ion-exchange techniques, high-carbon VFAs are recovered as one-type VFA (pure VFA) and in ester forms (product 4). The nutrient-rich fermented and dewatered biosolid is applied as a fertilizer. The proposed units are seen as individual resource recovery systems as well as a concept of an integrated system. A qualitative environmental assessment of the proposed resource recovery units confirms the positive environmental impacts of the proposed system.

Long-term SARS-CoV-2 surveillance in the wastewater of Stockholm: What lessons can be learned from the Swedish perspective?

Wastewater-based epidemiology (WBE) can be used to track the spread of SARS-CoV-2 in a population. This study presents the learning outcomes from over two-year long monitoring of SARS-CoV-2 in Stockholm, Sweden. The three main wastewater treatment plants in Stockholm, with a total of six inlets, were monitored from April 2020 until June 2022 (in total 600 samples). This spans five major SARS-CoV-2 waves, where WBE data provided early warning signals for each wave. Further, the measured SARS-CoV-2 content in the wastewater correlated significantly with the level of positive COVID-19 tests (r = 0.86; p << 0.0001) measured by widespread testing of the population. Moreover, as a proof-of-concept, six SARS-CoV-2 variants of concern were monitored using hpPCR assay, demonstrating that variants can be traced through wastewater monitoring. During this long-term surveillance, two sampling protocols, two RNA concentration/extraction methods, two calculation approaches, and normalization to the RNA virus Pepper mild mottle virus (PMMoV) were evaluated. In addition, a study of storage conditions was performed, demonstrating that the decay of viral RNA was significantly reduced upon the addition of glycerol to the wastewater before storage at -80 °C. Our results provide valuable information that can facilitate the incorporation of WBE as a prediction tool for possible future outbreaks of SARS-CoV-2 and preparations for future pandemics.

Pure cultures for synthetic culture development: Next level municipal waste treatment for polyhydroxyalkanoates production.

Polyhydroxyalkanoates (PHAs), as bio-based plastics, promise a transition from petroleum products to green and sustainable alternatives. However, their commercial production is yet impeded by high production costs. In this study, we assessed synthetic culture in mono and co-culture modes for bacterial PHA production. It was demonstrated that volatile fatty acids (VFAs) derived from food waste and primary sludge are cheap carbon sources for maintaining high production yields in the synthetic cultures. The maximum obtained PHA was 77.54 ± 5.67% of cell dried weight (CDW) (1.723 g/L) from Cupriavidus necator and 54.9 ± 3.66% of CDW (1.088 g/L) from Burkholderia cepacia. The acquired results are comparable to those in literature using sugar substrates. Comparatively, lower PHA productions were obtained from the co-cultivations ranging between 36-45 CDW% (0.39-0.48 g/L). Meanwhile, the 3-hydroxyvalerate content in the biopolymers were increased up to 21%.

Bioconversion of food waste to volatile fatty acids: Impact of microbial community, pH and retention time.

Bio-based production of materials from waste streams is a pivotal aspect in a circular economy. This study aimed to investigate the influence of inoculum (three different sludge taken from anaerobic digestors), pH (5 & 10) and retention time on production of total volatile fatty acids (VFAs), VFA composition as well as the microbial community during anaerobic digestion of food waste. The highest VFA production was ∼22000 ± 1036 mg COD/L and 12927 ± 1029 mg COD/L on day 15 using the inoculum acclimated to food waste at pH 10 and pH 5, respectively. Acetic acid was the dominant VFA in the batch reactors with initial alkaline conditions, whereas both propionic and acetic acids were the dominant products in the acidic condition. Firmicutes, Chloroflexi and Bacteroidetes had the highest relative abundance in the reactors. VFA generation was positively correlated to the relative abundance of Firmicutes.

Bio-based conversion of volatile fatty acids from waste streams to polyhydroxyalkanoates using mixed microbial cultures.

Production of polyhydroxyalkanoates is an important field in the biorefinery as bio-alternative to conventional plastics. However, its commercialization is still limited by high production cost. In this study, a process with the potential to reduce the production cost of polyhydroxyalkanoates was proposed. Mixed cultures accumulated polyhydroxyalkanoates using volatile fatty acid-rich effluents from waste streams, without pH and temperature control. In addition, the impact of two types of carbon sources was investigated by analyzing the microbial community as well as the polyhydroxyalkanoate accumulation capacity. Mixed cultures successfully adapted to different substrates, consuming the volatile fatty acids in their totality. The phyla Proteobacteria, Bacteroidetes and Firmicutes dominated the bacterial community. The highest polyhydroxyalkanoate content was 43.5% w/w, which is comparable to contents reported from mixed cultures using synthetic carbon sources. The biopolymer consisted of (R)-3-hydroxybutyrate 94.8 ± 1.7% w/w and (R)-3-hydroxyvaletare 5.2 ± 1.7% w/w.

Benchmarking virus concentration methods for quantification of SARS-CoV-2 in raw wastewater.

Wastewater-based epidemiology offers a cost-effective alternative to testing large populations for SARS-CoV-2 virus, and may potentially be used as an early warning system for SARS-CoV-2 pandemic spread. However, viruses are highly diluted in wastewater, and a validated method for their concentration and further processing, and suitable reference viruses, are the main needs to be established for reliable SARS-CoV-2 municipal wastewater detection. For this purpose, we collected wastewater from two European cities during the Covid-19 pandemic and evaluated the sensitivity of RT-qPCR detection of viral RNA after four concentration methods (two variants of ultrafiltration-based method and two adsorption and extraction-based methods). Further, we evaluated one external (bovine corona virus) and one internal (pepper mild mottle virus) reference virus. We found a consistently higher recovery of spiked virus using the modified ultrafiltration-based method. This method also had a significantly higher efficiency (p-value <0.01) for wastewater SARS-CoV-2 detection. The ultracentrifugation method was the only method that detected SARS-CoV-2 in the wastewater of both cities. The pepper mild mottle virus was found to function as a potentially suitable internal reference standard.

Waste to bioplastics: How close are we to sustainable polyhydroxyalkanoates production?

Increased awareness of environmental sustainability with associated strict environmental regulations has incentivized the pursuit of novel materials to replace conventional petroleum-derived plastics. Polyhydroxyalkanoates (PHAs) are appealing intracellular biopolymers and have drawn significant attention as a viable alternative to petrochemical based plastics not only due to their comparable physiochemical properties but also, their outstanding characteristics such as biodegradability and biocompatibility. This review provides a comprehensive overview of the recent developments on the involved PHA producer microorganisms, production process from different waste streams by both pure and mixed microbial cultures (MMCs). Bio-based PHA production, particularly using cheap carbon sources with MMCs, is getting more attention. The main bottlenecks are the low production yield and the inconsistency of the biopolymers. Bioaugmentation and metabolic engineering together with cost effective downstream processing are promising approaches to overcome the hurdles of commercial PHA production from waste streams.