Functionalized manganese iron oxide nanoparticles: a dual potential magneto-chemotherapeutic cargo in a 3D breast cancer model.

Localized heat generation from manganese iron oxide nanoparticles (MIONPs) conjugated with chemotherapeutics under the exposure of an alternating magnetic field (magneto-chemotherapy) can revolutionize targeted breast cancer therapy. On the other hand, the lack of precise control of local temperature and adequate MIONP distribution in laboratory settings using the conventional two-dimensional (2D) cellular models has limited its further translation in tumor sites. Our current study explored advanced 3D in vitro tumor models as a promising alternative to replicate the complete range of tumor characteristics. Specifically, we have focused on investigating the effectiveness of MIONP-based magneto-chemotherapy (MCT) as an anticancer treatment in a 3D breast cancer model. To achieve this, chitosan-coated MIONPs (CS-MIONPs) are synthesized and functionalized with an anticancer drug (doxorubicin) and a tumor-targeting aptamer (AS1411). CS-MIONPs with a crystallite size of 16.88 nm and a specific absorption rate (SAR) of 181.48 W g-1 are reported. In vitro assessment of MCF-7 breast cancer cell lines in 2D and 3D cell cultures demonstrated anticancer activity. In the 2D and 3D cancer models, the MIONP-mediated MCT reduced cancer cell viability to about 71.48% and 92.2%, respectively. On the other hand, MIONP-mediated MCT under an AC magnetic field diminished spheroids' viability to 83.76 ± 2%, being the most promising therapeutic modality against breast cancer.

Application of Mn x Fe1-x Fe2O4 (x = 0-1) Nanoparticles in Magnetic Fluid Hyperthermia: Correlation with Cation Distribution and Magnetostructural Properties.

Optimization of manganese-substituted iron oxide nanoferrites having the composition Mn x Fe1-x Fe2O4 (x = 0-1) has been achieved by the chemical co-precipitation method. The crystallite size and phase purity were analyzed from X-ray diffraction. With increases in Mn2+ concentration, the crystallite size varies from 5.78 to 9.94 nm. Transmission electron microscopy (TEM) analysis depicted particle sizes ranging from 10 ± 0.2 to 13 ± 0.2 nm with increasing Mn2+ substitution. The magnetization (M s) value varies significantly with increasing Mn2+ substitution. The variation in the magnetic properties may be attributed to the substitution of Fe2+ ions by Mn2+ ions inducing a change in the superexchange interaction between the A and B sublattices. The self-heating characteristics of Mn x Fe1-x Fe2O4 (x = 0-1) nanoparticles (NPs) in an AC magnetic field are evaluated by specific absorption rate (SAR) and intrinsic loss power, both of which are presented with varying NP composition, NP concentration, and field amplitudes. Mn0.75Fe0.25Fe2O4 exhibited superior induction heating properties in terms of a SAR of 153.76 W/g. This superior value of SAR with an optimized Mn2+ content is presented in correlation with the cation distribution of Mn2+ in the A or B position in the Fe3O4 structure and enhancement in magnetic saturation. These optimized Mn0.75Fe0.25Fe2O4 NPs can be used as a promising candidate for hyperthermia applications.

Synthesis, Characterization, and Cytotoxicity Evaluation of Polyethylene Glycol-Coated Iron Oxide Nanoparticles for Radiotherapy Application.

BACKGROUND: Treatment methods for cancer that are widely being utilized affect both normal and cancerous cells. We report synthesis polyethylene glycol (PEG)-coated Fe3O4 nanoparticles (NPs) and its characteristic properties and appraise its potential as a promising radiation sensitizer candidate in radiotherapy that improves cancer treatment and reduces side effects of radiation. MATERIALS AND METHODS: PEG-coated Fe3O4 NPs were synthesized by chemical coprecipitation method and characterized by studying their size, structure, functional group, stability, magnetization, and cytotoxicity using different techniques. X-ray powder diffraction, Fourier transform infrared spectroscopy, and thermogravimetric analysis results show that Fe3O4 NPs have been functionalized with PEG molecules during the course of synthesis. RESULTS: Synthesized NPs have good stability based on zeta-potential study. Dynamic light-scattering results reveal that PEG-coated Fe3O4 has a greater hydrodynamic size than bare Fe3O4. Transmission electron microscopy (TEM) micrograph exhibited that NPs are roughly spherical with size in range of 10-20 nm. Saturation magnetization value of PEG-coated and bare Fe3O4 also confirms coating and shows superparamagnetic behavior. Cytotoxicity evaluation study indicated that PEG-coated Fe3O4 is biocompatible on L929 and toxic on Michigan Cancer Foundation-7 (MCF-7) (breast cancer cells). CONCLUSION: These characterized properties of PEG-coated Fe3O4 NPs show that it could be used as a potential radiosensitizer candidate in radiotherapy to significantly improve cancer treatment and minimize painful side effects of radiation.

Nanomedicine-driven molecular targeting, drug delivery, and therapeutic approaches to cancer chemoresistance.

Cancer cell resistance to chemotherapeutics (chemoresistance) poses a significant clinical challenge that oncology research seeks to understand and overcome. Multiple anticancer drugs and targeting agents can be incorporated in nanomedicines, in addition to different treatment modalities, forming a single nanoplatform that can be used to address tumor chemoresistance. Nanomedicine-driven molecular assemblies using nucleic acids, small interfering (si)RNAs, miRNAs, and aptamers in combination with stimuli-responsive therapy improve the pharmacokinetic (PK) profile of the drugs and enhance their accumulation in tumors and, thus, therapeutic outcomes. In this review, we highlight nanomedicine-driven molecular targeting and therapy combination used to improve the 3Rs (right place, right time, and right dose) for chemoresistant tumor therapies.

MRI Guided Magneto-chemotherapy with High-Magnetic-Moment Iron Oxide Nanoparticles for Cancer Theranostics.

Elevating and monitoring the temperature of tumors using magnetic nanoparticles (MNPs) still presents a challenge in magnetic hyperthermia therapy. The efficient heating of tumor volume can be achieved by preparing MNPs with high magnetization values. The next-generation approach to magnetic resonance image (MRI)-guided magneto-chemotherapy of cancer based on high-magnetic-moment iron oxide nanoparticles is proposed. The proof of concept is validated by cellular MRI experiments on breast cancer cells. To explore magneto-chemotherapy, we developed high-magnetic-moment iron oxide (Fe3O4) nanoparticles (NPs) using base diisopropylamine (DIPA), which plays a dual role as reducing agent and surface stabilizer. Spherical NPs with ∼12 nm size and a high magnetization value of about 92 emu g-1 at room temperature are obtained by this unique method. A high specific absorption rate value of ∼717 wg-1 was obtained for Fe3O4 NPs in water at an alternating magnetic field of 20 kAm-1 and frequency of 267 kHz, which is attributed to the high magnetization value. The magneto-polymeric micelle structure is formed by using Pluronic F127, and anticancer drug doxorubicin is conjugated in the micelle by electrostatic interactions for magneto-chemotherapy. Finally, the magnetic resonance imaging (MRI)-guided magneto-chemotherapy was achieved on breast cancer (MCF7) cells with an overall ∼96% killing of cancer cells attained in 30 min of magneto-chmeotherapy.

Superparamagnetic MFe2O 4 (M = Ni, Co, Zn, Mn) nanoparticles: synthesis, characterization, induction heating and cell viability studies for cancer hyperthermia applications.

Superparamagnetic nanoferrites are prepared by simple and one step refluxing in polyol synthesis. The ferrite nanoparticles prepared by this method exhibit particle sizes below 10 nm and high degree of crystallinity. These ferrite nanoparticles are compared by means of their magnetic properties, induction heating and cell viability studies for its application in magnetic fluid hyperthermia. Out of all studied nanoparticles in present work, only ZnFe2O4 and CoFe2O4 MNPs are able to produce threshold hyperthermia temperature. This rise in temperature is discussed in detail in view of their magneto-structural properties. Therefore ZnFe2O4 and CoFe2O4 MNPs with improved stability, magnetic induction heating and cell viability are suitable candidates for magnetic hyperthermia.