RESUMEN
A fully integrated 24-GHz radar transceiver with one transmitter (TX) and two receivers (RXs) for compact frequency modulated continuous wave (FMCW) radar applications is here presented. The FMCW synthesizer was realized using a fractional-N phase-locked loop (PLL) and programmable chirp generator, which are completely integrated in the proposed transceiver. The measured output phase noise of the synthesizer is -80 dBc/Hz at 100 kHz offset. The TX consists of a three-bit bridged t-type attenuator for gain control, a two-stage drive amplifier (DA) and a one-stage power amplifier (PA). The TX chain provides an output power of 13 dBm while achieving <0.5 dB output power variation within the range of 24 to 24.25 GHz. The RX with a direct conversion I-Q structure is composed of a two-stage low noise amplifier (LNA), I-Q generator, mixer, transimpedance amplifier (TIA), a two-stage biquad band pass filter (BPF), and a differential-to-single (DTS) amplifier. The TIA and the BPF employ a DC offset cancellation (DCOC) circuit to suppress the strong reflection signal and TX-RX leakage. The RX chain exhibits an overall gain of 100 dB. The proposed radar transceiver is fabricated using a 65 nm CMOS technology. The transceiver consumes 220 mW from a 1 V supply voltage and has 4.84 mm2 die size including all pads. The prototype FMCW radar is realized with the proposed transceiver and Yagi antenna to verify the radar functionality, such as the distance and angle of targets.
RESUMEN
An 18.8-33.9 GHz, 2.26 mW current-reuse (CR) injection-locked frequency divider (ILFD) for radar sensor applications is presented in this paper. A fourth-order resonator is designed using a transformer with a distributed inductor for wideband operating of the ILFD. The CR core is employed to reduce the power consumption compared to conventional cross-coupled pair ILFDs. The targeted input center frequency is 24 GHz for radar application. The self-oscillated frequency of the proposed CR-ILFD is 14.08 GHz. The input frequency locking range is from 18.8 to 33.8 GHz (57%) at an injection power of 0 dBm without a capacitor bank or varactors. The proposed CR-ILFD consumes 2.26 mW of power from a 1 V supply voltage. The entire die size is 0.75 mm × 0.45 mm. This CR-ILFD is implemented in a 65 nm complementary metal-oxide semiconductor (CMOS) technology.