Prediction of in-vitro dissolution and tablet hardness from optical porosity measurements.

Advanced manufacturing technologies such as continuous processing require fast information on the quality of intermediates and products. Process analytical technologies (PAT) to monitor many critical quality attributes (CQAs) have been developed and successfully implemented in pharmaceutical industry. However, there are some CQAs, which still have to be measured off-line with significant effort due to the lack of suitable PAT sensors. Two prominent examples are the in-vitro dissolution and the tablet hardness. Both are obtained via destructive measurement, and the dissolution is tedious and time-consuming to determine. In this study, these two CQAs were predicted via correlation with the optical porosity of tablets. The optical porosity was measured via a novel combination of gas in scattering media absorption spectroscopy (GASMAS) and photon time of flight spectroscopy (pTOFS) with a SpectraPore instrument. The approach was tested in a continuous tableting line and showed promising results in predicting the amount of drug released after specific dissolution times as well as the tablet hardness. This indicates that the measurement of optical porosity can support control strategies within the real-time release testing (RTRT) concept.

Single-tablet-scale direct-compression: An on-demand manufacturing route for personalized tablets.

Today's pharmaceutical industry is facing various challenges. Two of them are issues with supply chain security and the increasing demand for personalized medicine. Both can be addressed by increasing flexibility and a more decentralized approach to pharmaceutical manufacturing. In this study, we present a setup that provides flexibility in terms of supplied raw materials and the product, i.e., a direct-compression setup for personalized tablets operating at a single-tablet-scale. The performance of the implemented single-tablet-scale technology for dosing and mixing was investigated. In addition, an analysis of the critical quality attributes (CQAs) of immediate release ibuprofen and loratadine tablets was performed. The developed dosing device achieved acceptance rates of > 90 % for doses ≥ 20 mg for various pharmaceutical powders. Regarding the vibratory mixing process, a dependency of the performance on the applied frequencies and acceleration was observed, with 100 Hz and âˆ¼ 90 G performing best, yet still exhibiting varying mixing efficacies depending on the granular system. The tablets produced met U.S. Pharmacopeia requirements regarding mechanical stability and dissolution characteristics. Given these results, we consider the developed setup a proof of concept of a tool to provide personalized tablets to patients while minimizing the dependency on complex supply chains.

Continuous Processing of Micropellets via Hot-Melt Extrusion.

Microparticulate drug delivery systems, e.g., micropellets (MPs), are used in a variety of pharmaceutical formulations such as suspensions, injectable systems, and capsules. MPs are currently manufactured mainly via batch, solvent-based processes, e.g., spray-drying and solvent evaporation-extraction. In this paper, we present a novel, solvent-free, continuous hot-melt extrusion-based approach with an inline cold pelletization step and the potential of unprecedented on-the-fly formulation changes, aiming at producing the smallest particles usable for injectable applications. A biodegradable, crystalline dispersion consisting of poly(DL-lactic acid) (PLA) filled with metformin as the model drug was chosen on purpose to elucidate the broad applicability of the process also to formulations with limited stretchability and complex pelletizability. Next to optical/statistical particle analyses and in-line high-speed camera investigations providing insights into the pelletization process, the injectability of the most promising micropellets was compared to that of one marketed formulation. Fast extrudate haul-off speeds and high numbers of pelletizer knives resulted in particles with a narrow and small particle size distribution with a d50 below 270 µm and aspect ratios close to 1. To omit protruding drug particles to ensure sufficient extrudate stretchability and allow for the smallest MPs, it was found that the d90 of the embedded drug must be significantly below the extrudate diameter. Upon adapting the syringe diameter, the produced micropellets revealed similar injectability parameters to the marketed formulation, showcasing the potential that the proposed setup has for the manufacturing of novel microparticulate formulations.