Effect of Periodic Water Clusters on AISI 304 Welded Surfaces.

This study compared the effect of the interaction time of periodic water clusters on the surface integrity of AISI 304 tungsten inert gas (TIG) welded joints at different excitation frequencies, as the effect of the technological parameters of pulsating water jet (PWJ) on the mechanical properties of TIG welded joints are under-researched. The TIG welded joints were subjected to different frequencies (20 and 40 kHz) and traverse speeds (1-4 mm/s) at a water pressure of 40 MPa and a standoff distance of 70 mm. The effect of the interaction of the pulsating jet on the material and the enhancement in its mechanical properties were compared through residual stress measurements, surface roughness, and sub-surface microhardness. A maximum enhancement in the residual stress values of up to 480 MPa was observed in the heat-affected zone, along with a maximum roughness of 6.03 µm and a maximum hardness of 551 HV using a frequency of 40 kHz. The improvement in the surface characteristics of the welded joints shows the potential of utilizing pulsed water jet technology with an appropriate selection of process parameters in the treatment of welded structures.

Analysis of Welded Joint Properties on an AISI316L Stainless Steel Tube Manufactured by SLM Technology.

This work is focused on the analysis of the influence of welding on the properties and microstructure of the AISI316L stainless steel tube produced by 3D printing, specifically the SLM (Selective Laser Melting) method. Both non-destructive and destructive tests, including metallographic and fractographic analyses, were performed within the experiment. Microstructure analysis shows that the initial texture of the 3D print disappears toward the fuse boundary. It is evident that high temperature during welding has a positive effect on microstructure. Material failure occurred in the base material near the heat affected zone (HAZ). The results obtained show the fundamental influence of SLM technology in terms of material defects, on the properties of welded joints.

Disulfide chromophore and its optical activity.

The compounds I-IV derived from α-D-cyclodextrin moiety by bridging and/or interconnecting with various patterns of disulfide bonds were chosen as models for the spectroscopic study of conformation of the disulfide bridge. The energy gap between the disulfide and cyclodextrin's electronic transitions allows us to investigate absorption and electronic circular dichroism spectra without disturbing spectral overlaps with amides or aromatic amino acids in peptides or proteins. Raman optical activity (ROA) spectra were measured and the bands due to S-S and C-S stretching motion identified. Comparison with the quantum mechanical calculations of simple models indicates that sense of disulfide twist follows sign of the measured S-S ROA band.

Tubular duplex alpha-cyclodextrin triply bridged with disulfide bonds: synthesis, crystal structure and inclusion complexes.

Template-free oxidative dimerization of 6(I), 6(III), 6(V)-trisulfanyl-alpha-cyclodextrin proceeds with a remarkable efficiency (> or =94%) yielding an unprecedented duplex alpha-cyclodextrin triply bridged with disulfide linkages whose structure has been confirmed by X-ray analysis.