Removal of PAHs, TSS, oils and fats from ammonium-rich coke wastewater by granular filtration.

Coke wastewater is a complex industrial wastewater due to its high content of toxic compounds such as cyanides, thiocyanates, phenols, tar, oils, and fats. After a series of treatments, wastewater with a high ammonium content is obtained (around 4,150 mg·L-1). A stripping process is used to reduce it. Certain pollutants in the influent, such as tar, polycyclic aromatic hydrocarbons (PAHs), oils, fats and total suspended solids (TSS), interfere with stripping and therefore must be previously removed. In this study, the performance of a pilot-scale airlift sand filter was evaluated under real conditions for the reduction of the concentration of tar, PAHs, oils, fats and TSS, before stripping. Prior to the sand filter, a cationic flocculant was added to the influent (2 ppm). High (10 mm.min-1), medium (7.5 mm.min-1) and low sand speeds (1.9-2.6 mm.min-1) were assessed. The latter conditions gave the best results: a decrease of 98.2% in TSS, 99.7% in oils, fats and grease and 97.6% in PAHs. The final effluent (≤ 1.6 mg PAHs·L-1, ≤ 5 mg TSS·L-1 and ≤ 0.05 mg·L-1 of fats, oils and grease) was suitable for the stripping process.

Imaging Techniques and Scanning Electron Microscopy as Tools for Characterizing a Si-Based Material Used in Air Monitoring Applications.

This paper presents a study of the quartz fibrous filters used as a substrate for capturing the particulate matter (PM) present in the air. Although these substrates are widely used in environmental applications, their microstructure has been barely studied. The behavior of these devices during the filtration process was investigated in terms of their microstructure and the quartz fibers. Surface and cross sections were monitored. Scanning electronic microscopy with energy dispersive X-ray spectroscopy (SEM-EDX), imaging and stereology techniques were used as tools for this purpose. The results show that most of the quartz filter fibers have sizes that allow them to be classified as nanofibers. It was also observed that, while the mechanisms of the mechanical capture of particles via impaction, interception and diffusion operate simultaneously in the outer zones of the filter cross section, the mechanism of capture by impaction is virtually non-existent in the innermost zones. Particles between 0.1 and 0.5 µm are known to be the most difficult to have captured by means of fibrous substrates. The fibers in inner zones were highly efficient in capturing this type of particle.