RESUMEN
Wireless capsule endoscopy has been used for the clinical examination of the gastrointestinal (GI) tract for two decades. However, most commercially available devices only utilise optical imaging to examine the GI wall surface. Using this sensing modality, pathology within the GI wall cannot be detected. Micro-ultrasound (µUS) using high-frequency (>20 MHz) ultrasound can provide a means of transmural or cross-sectional image of the GI tract. Depth of imaging is approximately 10 mm with a resolution of between 40-120 µm that is sufficient to differentiate between subsurface histologic layers of the various regions of the GI tract. Ultrasound capsule endoscopy (USCE) uses a capsule equipped with µUS transducers that are capable of imaging below the GI wall surface, offering thereby a complementary sensing technique to optical imaging capsule endoscopy. In this work, a USCE device integrated with a â¼30 MHz ultrasonic transducer was developed to capture a full 360° image of the lumen. The performance of the device was initially evaluated using a wire phantom, indicating an axial resolution of 69.0 µm and lateral resolution of 262.5 µm. Later, in vivo imaging performance was characterised in the oesophagus and small intestine of anaesthetized pigs. The reconstructed images demonstrate clear layer differentiation of the lumen wall. The tissue thicknesses measured from the B-scan images show good agreement with ex vivo images from the literature. The high-resolution ultrasound images in the in vivo porcine model achieved with this device is an encouraging preliminary step in the translation of these devices toward future clinical use.
Asunto(s)
Endoscopía Capsular/métodos , Tracto Gastrointestinal/diagnóstico por imagen , Animales , Femenino , Porcinos , Ultrasonografía/métodosRESUMEN
Diagnostic endoscopy in the gastrointestinal tract has remained largely unchanged for decades and is limited to the visualization of the tissue surface, the collection of biopsy samples for diagnoses, and minor interventions such as clipping or tissue removal. In this work, we present the autonomous servoing of a magnetic capsule robot for in-situ, subsurface diagnostics of microanatomy. We investigated and showed the feasibility of closed-loop magnetic control using digitized microultrasound (µUS) feedback; this is crucial for obtaining robust imaging in an unknown and unconstrained environment. We demonstrated the functionality of an autonomous servoing algorithm that uses µUS feedback, both on benchtop trials as well as in-vivo in a porcine model. We have validated this magnetic-µUS servoing in instances of autonomous linear probe motion and were able to locate markers in an agar phantom with 1.0 ± 0.9 mm position accuracy using a fusion of robot localization and µUS image information. This work demonstrates the feasibility of closed-loop robotic µUS imaging in the bowel without the need for either a rigid physical link between the transducer and extracorporeal tools or complex manual manipulation.
RESUMEN
Lead zirconate titanate (PZT)-based piezoelectric micromachined ultrasonic transducers (PMUTs) for particle manipulation applications were designed, fabricated, characterized, and tested. The PMUTs had a diaphragm diameter of 60 [Formula: see text], a resonant frequency of ~8 MHz, and an operational bandwidth (BW) of 62.5%. Acoustic pressure output in water was 9.5 kPa at 7.5 mm distance from a PMUT element excited with a unipolar waveform at 5 Vpp . The element consisted of 20 diaphragms connected electrically in parallel. Particle trapping of 4 [Formula: see text] silica beads was shown to be possible with 5 Vpp unipolar excitation. Trapping of multiple beads by a single element and deterministic control of particles via acoustophoresis without the assistance of microfluidic flow were demonstrated. It was found that the particles move toward diaphragm areas of highest pressure, in agreement with literature and simulations. Unique bead patterns were generated at different driving frequencies and were formed at frequencies up to 60 MHz, much higher than the operational BW. Levitation planes were generated above the 30 MHz driving frequency.
RESUMEN
Clinical endoscopy and colonoscopy are commonly used to investigate and diagnose disorders in the upper gastrointestinal tract and colon, respectively. However, examination of the anatomically remote small bowel with conventional endoscopy is challenging. This and advances in miniaturization led to the development of video capsule endoscopy (VCE) to allow small bowel examination in a noninvasive manner. Available since 2001, current capsule endoscopes are limited to viewing the mucosal surface only due to their reliance on optical imaging. To overcome this limitation with submucosal imaging, work is under way to implement microultrasound (µUS) imaging in the same form as VCE devices. This paper describes two prototype capsules, termed Sonocap and Thermocap, which were developed respectively to assess the quality of µUS imaging and the maximum power consumption that can be tolerated for such a system. The capsules were tested in vivo in the oesophagus and small bowel of porcine models. Results are presented in the form of µUS B-scans as well as safe temperature readings observed up to 100 mW in both biological regions. These results demonstrate that acoustic coupling and µUS imaging can be achieved in vivo in the lumen of the bowel and the maximum power consumption that is possible for miniature µUS systems.
Asunto(s)
Endoscopios en Cápsulas , Endoscopía Capsular/instrumentación , Termometría/instrumentación , Ultrasonografía/instrumentación , Animales , Endoscopía Capsular/métodos , Colon/diagnóstico por imagen , Colon/fisiología , Diseño de Equipo , Femenino , Humanos , Miniaturización/instrumentación , Seguridad del Paciente , Porcinos , Termometría/métodos , Ultrasonografía/métodosRESUMEN
Video capsule endoscopy (VCE) has significantly advanced visualization of the gastrointestinal tract since its introduction in the last 20 years. Work is now under way to combine VCE with microultrasound imaging. However, small maximum capsule dimensions, coupled with the electronics required to integrate ultrasound imaging capabilities, pose significant design challenges. This paper describes a simulation process for testing transducer geometries and imaging methodologies to achieve satisfactory imaging performance within the physical limitations of the capsule size and outlines many of the tradeoffs needed in the design of this new class of ultrasound capsule endoscopy (USCE) device. A hybrid MATLAB model is described, incorporating Krimholtz-Leedom-Matthaei circuit elements and digitizing and beamforming elements to render a gray-scale B-mode. This model is combined with a model of acoustic propagation to generate images of point scatterers. The models are used to demonstrate the performance of a USCE transducer configuration comprising a single, unfocused transmit ring of radius 5 mm separated into eight segments for electrical impedance control and a 512-element receive linear array, also formed into a ring. The MATLAB model includes an ultrasonic pulser circuit connected to a piezocrystal composite transmit transducer with a center frequency of 25 MHz. B-scan images are simulated for wire target phantoms, multilayered phantoms, and a gut wall model. To demonstrate the USCE system's ability to image tissue, a digital phantom was created from single-element ultrasonic transducer scans of porcine small bowel ex vivo obtained at a frequency of 45 MHz.
Asunto(s)
Endoscopía Capsular/instrumentación , Ultrasonografía/instrumentación , Algoritmos , Animales , Diseño de Equipo , Procesamiento de Imagen Asistido por Computador , Intestino Delgado/diagnóstico por imagen , Modelos Biológicos , Fantasmas de Imagen , Porcinos , TransductoresRESUMEN
This paper describes the design, fabrication, packaging, and performance characterization of a conformal helix antenna created on the outside of a capsule endoscope designed to operate at a carrier frequency of 433 MHz within human tissue. Wireless data transfer was established between the integrated capsule system and an external receiver. The telemetry system was tested within a tissue phantom and in vivo porcine models. Two different types of transmission modes were tested. The first mode, replicating normal operating conditions, used data packets at a steady power level of 0 dBm, while the capsule was being withdrawn at a steady rate from the small intestine. The second mode, replicating the worst-case clinical scenario of capsule retention within the small bowel, sent data with stepwise increasing power levels of -10, 0, 6, and 10 dBm, with the capsule fixed in position. The temperature of the tissue surrounding the external antenna was monitored at all times using thermistors embedded within the capsule shell to observe potential safety issues. The recorded data showed, for both modes of operation, a low error transmission of 10-3 packet error rate and 10-5 bit error rate and no temperature increase of the tissue according to IEEE standards.
Asunto(s)
Endoscopía Capsular/instrumentación , Tecnología de Sensores Remotos , Tecnología Inalámbrica/instrumentación , Animales , Endoscopía Capsular/métodos , Tecnología de Sensores Remotos/instrumentación , Tecnología de Sensores Remotos/métodos , PorcinosRESUMEN
Video capsule endoscopy (VCE) is now a clinically accepted diagnostic modality in which miniaturized technology, an on-board power supply and wireless telemetry stand as technological foundations for other capsule endoscopy (CE) devices. However, VCE does not provide therapeutic functionality, and research towards therapeutic CE (TCE) has been limited. In this paper, a route towards viable TCE is proposed, based on multiple CE devices including important acoustic sensing and drug delivery components. In this approach, an initial multimodal diagnostic device with high-frequency quantitative microultrasound that complements video imaging allows surface and subsurface visualization and computer-assisted diagnosis. Using focused ultrasound (US) to mark sites of pathology with exogenous fluorescent agents permits follow-up with another device to provide therapy. This is based on an US-mediated targeted drug delivery system with fluorescence imaging guidance. An additional device may then be utilized for treatment verification and monitoring, exploiting the minimally invasive nature of CE. While such a theranostic patient pathway for gastrointestinal treatment is presently incomplete, the description in this paper of previous research and work under way to realize further components for the proposed pathway suggests it is feasible and provides a framework around which to structure further work.
Asunto(s)
Endoscopía Capsular , Diagnóstico por Computador , Humanos , Telemetría , Nanomedicina Teranóstica , UltrasonidoRESUMEN
Video capsule endoscopy (VCE) has been of immense benefit in the diagnosis and management of gastrointestinal (GI) disorders since its introduction in 2001. However, it suffers from a number of well recognized deficiencies. Amongst these is the limited capability of white light imaging, which is restricted to analysis of the mucosal surface. Current capsule endoscopes are dependent on visual manifestation of disease and limited in regards to transmural imaging and detection of deeper pathology. Ultrasound capsule endoscopy (USCE) has the potential to overcome surface only imaging and provide transmural scans of the GI tract. The integration of high frequency microultrasound (µUS) into capsule endoscopy would allow high resolution transmural images and provide a means of both qualitative and quantitative assessment of the bowel wall. Quantitative ultrasound (QUS) can provide data in an objective and measurable manner, potentially reducing lengthy interpretation times by incorporation into an automated diagnostic process. The research described here is focused on the development of USCE and other complementary diagnostic and therapeutic modalities. Presently investigations have entered a preclinical phase with laboratory investigations running concurrently.
RESUMEN
High resolution, microultrasound (µUS) scanning of the gastrointestinal (GI) tract has potential as an important transmural imaging modality to aid in diagnosis. Operating at higher frequencies than conventional clinical ultrasound instruments, µUS is capable of providing scanned images of the GI tract with higher resolution. To investigate the use of µUS for this application, a phantom which is cost effective, within ethical guidelines and, most importantly, similar in histology to the human GI tract is necessary. Therefore, a phantom utilizing porcine small bowel tissue has been developed for custom assembled µUS scanning systems. Two such systems, a stepping scanner and a continuous sweep scanner were utilized to repeatedly scan regions of prepared samples of porcine small bowel tissue. The porcine small bowel tissue phantom was perfused with degassed phosphate buffer saline (dPBS) solution through a cannula inserted in its mesenteric vessel to simulate in vivo conditions and achieve better µUS mucosal characterization. The µUS system scans a transducer across the tissue phantom to acquire RF echo data, which is then processed using MATLAB. A B-scan reconstruction produces 2D images with relative echo strength mapped to a color map of the user's choice. The phantom developed also allows for modifications such as the insertion of fiducial markers to detect tissue change over time and simultaneous perfusion and scanning, providing a platform for more detailed research and investigation into µUS scanning of the GI tract.
Asunto(s)
Tracto Gastrointestinal/diagnóstico por imagen , Ultrasonografía/métodos , Algoritmos , Animales , Diseño de Equipo , Procesamiento de Imagen Asistido por Computador , Intestino Delgado/diagnóstico por imagen , Fantasmas de Imagen , Programas Informáticos , Porcinos , Ultrasonografía/instrumentación , Ultrasonografía/normasRESUMEN
Fabricating arrays for high-frequency image applications such as ophthalmic imaging, intravascular imaging, and small animal imaging is challenging. For example, an array for intravascular imaging must be small enough to fit within the lumen of a catheter and inexpensive enough to be discarded after a single use. This article presents a new method for fabricating high-frequency annular arrays that is simple and inexpensive. The annular array elements are defined by the electrode pattern on a back surface of a polyimide quarter-wavelength matching layer that is glued to the front face of a ceramic transducer substrate (PZT5H). Electrical losses associated with bonding the matching layer to the transducer substrate are reduced by fabricating a second set of electrodes on the transducer substrate and then bonding the substrates using an anisotropic conductive epoxy. The feasibility of this technique was established by fabricating a seven-element, 20-MHz, 5-mm diameter annular array. The prototype array produced a pulse with a -6-dB factional bandwidth of 50%, an insertion loss of 22 dB, and secondary lobes in the radiation pattern at f/2 that decreased to -65 dB with respect to the main lobe with a peak amplitude of -53 dB.