RESUMEN
Peanut shells (PSs) generated from agricultural waste contain valuable compounds with bioactive properties such as anti-aging, antimicrobial, and antioxidant properties, making it desirable to recycle them as a sustainable resource. The aim of this study is to design an effective luteolin recovery process as the first step of an integrated biorefinery utilizing PSs as raw material. The major extraction variables and their ranges for luteolin recovery from PSs were determined (0-60 °C, 1-5 h, 0-100% MeOH concentration) and a predictive model was derived through a response surface methodology (RSM). Based on the predictive model, the equation determined for the maximal extraction of luteolin at 1 h was as follows: y = -1.8475x + 159.57, and the significant range of variables was as follows: 33.8 °C ≤ temperature (x) ≤ 48.5 °C and 70.0% ≤ MeOH concentration (y) ≤ 97.5%, respectively. High antioxidant and elastase inhibitory activities of PS extracts were confirmed, and these results support their potential to be used as functional materials. In addition, 39.2% of the solid residue after extraction was carbohydrate, which has potential as a carbon source for fermentation. This study provides a useful direction on an integrated biorefinery approach for sustainable agricultural waste valorization.
Asunto(s)
Antioxidantes , Arachis , Antioxidantes/farmacología , Luteolina , Temperatura , FermentaciónRESUMEN
Biofuel policies are currently being implemented globally to reduce greenhouse gas emissions. The recent European regulation, Renewable Energy Directive (RED) II, states that renewable resources should be used as raw materials. In this study, chestnut shell (CNS), a food processing residue, was utilized as a feedstock for bioethanol production. Statistical optimization was performed to improve biomass-to-glucose conversion (BtG) from the CNS. In order to design an energy-efficient process, the pretreatment was fixed at room temperature in the numerical optimization. The optimal conditions derived from the predicted model are as follows: temperature of 25 °C, reaction time of 2.8 h, and NaOH concentration of 1.9% (w/w). Under optimal conditions, both predicted and experimental BtG were 31.0%, while BtG was approximately 3.3-fold improved compared to the control group (without pretreatment). The recovered glucose was utilized for bioethanol fermentation by Saccharomyces cerevisiae K35 and the ethanol yield was achieved to be 98%. Finally, according to the mass balance based on 1000 g CNS, glucose of 310 g can be recovered by the pretreatment; the bioethanol production was approximately 155 g. This strategy suggests a direction to utilize CNS as a potential feedstock for biorefinery through the design of an economical and energy-efficient pretreatment process by lowering the reaction temperature to room temperature.
Asunto(s)
Biocombustibles , Glucosa , Biomasa , Fermentación , Hidrólisis , Hidróxido de Sodio , TemperaturaRESUMEN
The microbial food fermentation industry requires real-time monitoring and accurate quantification of cells. However, filamentous fungi are difficult to quantify as they have complex cell types such as pellet, spores, and dispersed hyphae. In this study, numerous data of microscopic image intensity (MII) were used to develop a simple and accurate quantification method of Cordyceps mycelium. The dry cell weight (DCW) of the sample collected during the fermentation was measured. In addition, the intensity values were obtained through the ImageJ program after converting the microscopic images. The prediction model obtained by analyzing the correlation between MII and DCW was evaluated through a simple linear regression method and found to be statistically significant (R2 = 0.941, p < 0.001). In addition, validation with randomly selected samples showed significant accuracy, thus, this model is expected to be used as a valuable tool for predicting and quantifying fungal growth in various industries.
Asunto(s)
Cordyceps , Modelos Biológicos , Micelio , Cordyceps/citología , Cordyceps/crecimiento & desarrollo , Micelio/citología , Micelio/crecimiento & desarrolloRESUMEN
Worldwide, about one-third of food produced for human consumption is wasted, which includes byproducts from food processing, with a significant portion of the waste still being landfilled. The aim of this study is to convert chestnut shells (CNSs) from food processing into a valuable resource through bioprocesses. Currently, one of the highest barriers to bioprocess commercialization is low conversion of sugar from biomass, and KOH pretreatment was suggested to improve enzymatic digestibility (ED) of CNS. KOH concentration of 3% (w/w) was determined as a suitable pretreatment solution by a fundamental experiment. The reaction factors including temperature, time and solid/liquid (S/L) ratio were optimized (77.1 g/L CNS loading at 75 °C for 2.8 h) by response surface methodology (RSM). In the statistical model, temperature and time showed a relatively significant effect on the glucan content (GC) and ED, but S/L ratio was not. GC and ED of the untreated CNS were 45.1% and 12.7%, respectively. On the other hand, GC and ED of pretreated CNS were 83.2% and 48.4%, respectively, and which were significantly improved by about 1.8-fold and 3.8-fold compared to the control group. The improved ED through the optimization is expected to contribute to increasing the value of byproducts generated in food processing.
Asunto(s)
Carbohidratos , Glucosa , Biomasa , Humanos , Hidrólisis , TemperaturaRESUMEN
Carbon-neutral and eco-friendly biomass-based processes are recognized as a frontier technology for sustainable development. In particular, biopolymers are expected to replace petrochemical-based films that are widely used in food packaging. In this study, the fabrication conditions of functional (antioxidant and antibacterial) bioelastomers were investigated using by-products from the juice processing (experimental group) and freeze-dried whole fruit (control group). Bioelastomer was fabricated by a casting method in which polydimethylsiloxane (PDMS) was mixed with 25 or 50 wt% aronia powder (juice processing by-products and freeze-dried whole fruit). The mechanical properties of the bioelastomers were measured based on tensile strength and Young's modulus. When the mixture contained 50 wt% aronia powder, the strength was not appropriate for the intended purpose. Next, the surface and chemical properties of the bioelastomer were analyzed; the addition of aronia powder did not significantly change these properties when compared to PDMS film (no aronia powder). However, the addition of aronia powder had a significant effect on antioxidant and antimicrobial activities and showed higher activity with 50 wt% than with 25 wt%. In particular, bioelastomers fabricated from aronia juice processing by-products exhibited approximately 1.4-fold lower and 1.5-fold higher antioxidant and antimicrobial activities, respectively, than the control group (bioelastomers fabricated from freeze-dried aronia powder).
RESUMEN
Cordycepin, a beneficial bioactive product specifically found in Cordyceps, has received attention in various bioindustrial applications such as in pharmaceuticals, functional foods, and cosmetics, due to its significant functions. However, low productivity of cordycepin is a barrier to commercialization. In this study, Cordyceps militaris was mutated by UV irradiation to improve the cordycepin production. The highest producer KYL05 strain was finally selected and its cordycepin production was increased about 1.5-fold compared to wild type. In addition, the effects of culture conditions were fundamentally investigated. Optimal conditions were as follows: pH 6, temperature of 25 °C, shaking speed of 150 rpm, and culture time of 6 days. Effects of medium component on cordycepin production were also investigated by using various carbon and nitrogen sources. It was found that glucose and casein hydrolysate (CH) were most effective as carbon and nitrogen sources in cordycepin production (2.3-fold improvement) with maximum cordycepin production of about 445 mg/L. In particular, production was significantly affected by CH. These results should be of value in improving the efficiency of mass production of cordycepin.
Asunto(s)
Caseínas/metabolismo , Cordyceps/metabolismo , Técnicas de Cultivo/métodos , Desoxiadenosinas/biosíntesis , Cordyceps/crecimiento & desarrollo , Cordyceps/efectos de la radiación , Concentración de Iones de Hidrógeno , Inmersión , Mutación/efectos de la radiación , Temperatura , Rayos UltravioletaRESUMEN
Conductive biopolymers, an important class of functional materials, have received attention in various fields because of their unique electrical, optical, and physical properties. In this study, the polymerization of heme into hemozoin was carried out in an in vitro system by the newly developed heme polymerase (histidine-rich protein 2 (HRP-II)). The HRP-II was produced by recombinant E. coli BL21 from the Plasmodium falciparum gene. To improve the hemozoin production, the reaction conditions on the polymerization were investigated and the maximum production was achieved after about 790 µM at 34 °C with 200 rpm for 24 h. As a result, the production was improved about two-fold according to the stepwise optimization in an in vitro system. The produced hemozoin was qualitatively analyzed using the Fourier transform infrared (FTIR) spectroscopy, energy dispersive X-ray spectroscopy (EDS), and scanning electron microscopy (SEM). Finally, it was confirmed that the enzymatically polymerized hemozoin had similar physical properties to chemically synthesized hemozoin. These results could represent a significant potential for nano-biotechnology applications, and also provide guidance in research related to hemozoin utilization.
RESUMEN
Chlorella vulgaris is considered as one of the potential sources of biomass for bio-based products because it consists of large amounts of carbohydrates. In this study, hydrothermal acid hydrolysis with five different acids (hydrochloric acid, nitric acid, peracetic acid, phosphoric acid, and sulfuric acid) was carried out to produce fermentable sugars (glucose, galactose). The hydrothermal acid hydrolysis by hydrochloric acid showed the highest sugar production. C. vulgaris was hydrolyzed with various concentrations of hydrochloric acid [0.5-10 % (w/w)] and microalgal biomass [20-140 g/L (w/v)] at 121 °C for 20 min. Among the concentrations examined, 2 % hydrochloric acid with 100 g/L biomass yielded the highest conversion of carbohydrates (92.5 %) into reducing sugars. The hydrolysate thus produced from C. vulgaris was fermented using the yeast Brettanomyces custersii H1-603 and obtained bioethanol yield of 0.37 g/g of algal sugars.