[Source Analysis and Health Risk Assessment of PAHs in PM2.5, Lüliang City].

To investigate the seasonal variation, health risks, and potential sources of polycyclic aromatic hydrocarbons(PAHs) in PM2.5 in the Lüliang area, PM2.5 samples were collected in Lishi District(downtown area) and Xiaoyi City(suburban area) from October 23, 2018 to July 1, 2019, and the concentrations of 14 PAHs were determined using gas chromatography-mass spectrometry(GC-MS). The annual average concentration of PAHs was 95.50 ng·m-3, and the concentration of 5-6 ring PAHs was mainly(49.7%), with 3 ring PAHs accounting for a relatively low proportion(8.3%).The concentration of PAHs in Lüliang City showed a seasonal pattern of winter>autumn>spring>summer. The results of the ILCRs model and Monte Carlo simulation showed that the toxicity of PAHs in Lüliang City followed the rule of adults>youth>children. Except in summer, the ILCRs values in the Lishi area were between 10-6 and 10-4, much higher than those in Xiaoyi City, indicating that there was a high potential risk of polycyclic aromatic hydrocarbons in the urban area. Through the characteristic ratio method and positive matrix factorization(PMF), it was shown that the PAHs in Lüliang City were mainly from the combustion of coal and biomass(61.9%) and vehicle exhaust emissions(38.1%). Based on the backward trajectory and potential source factor contribution analysis model, it was determined that the potential sources of PAHs in Lüliang City were mainly distributed in southern Shanxi, northern Shaanxi, and western Inner Mongolia.

[Characteristics, Sources, and Health Risks of Elements in PM2.5 in Shanxi University Town].

In order to investigate the pollution characteristics and sources of elements in PM2.5 in the Shanxi University Town in 2017, an energy dispersive X-ray fluorescence spectrometer (ED-XRF) was used to analyze 21 kinds of elements in PM2.5 samples. A health risk assessment was conducted for Mn, Zn, Cu, Sb, Pb, Cr, Co, and Ni. The main sources of elements were identified by the principal component analysis (PCA) and positive matrix factorization (PMF). The results found that, among the 21 kinds of elements in PM2.5 in Shanxi University Town, the mass concentration of Ca was the highest, followed by Si, Fe, Al, S, K, and Cl. These seven elements accounted for 95.71% of the total element concentrations. The concentration of Cr exceeded the annual average concentration limit of ambient air quality standards in China by 104 times. The concentration of Ca in PM2.5 was the highest in spring, summer, and winter, while in autumn the concentration of S was the highest. Mn was the element that had non-carcinogenic risks to the three population types, and the level of risks were in the order of children > adult men > adult women. Cr and Co had tolerable carcinogenic risks, and the risk levels were in the order of adult men > adult women > children. The main sources of elements in PM2.5 in Shanxi University Town in 2017 were natural mineral dust, urban dust, coal combustion, and traffic.