Novel method for the rapid and specific extraction of multiple ß2 -agonist residues in food by tailor-made Monolith-MIPs extraction disks and detection by gas chromatography with mass spectrometry.

A quick and specific pretreatment method based on a series of extraction clean-up disks, consisting of molecularly imprinted polymer monoliths and C18 adsorbent, was developed for the specific enrichment of salbutamol and clenbuterol residues in food. The molecularly imprinted monolithic polymer disk was synthesized using salbutamol as a template through a one-step synthesis process. It can simultaneously and specifically recognize salbutamol and clenbuterol. The monolithic polymer disk and series of C18 disks were assembled with a syringe to form a set of tailor-made devices for the extraction of target molecules. In a single run, salbutamol and clenbuterol can be specifically extracted, cleaned, and eluted by methanol/acetic acid/H2 O. The target molecules, after a silylation derivatization reaction were detected by gas chromatography-mass spectrometry. The parameters including solvent desorption, sample pH, and the cycles of reloading were investigated and discussed. Under the optimized extraction and clean-up conditions, the limits of detection and quantitation were determined as 0.018-0.022 and 0.042-0.049 ng/g for salbutamol and clenbuterol, respectively. The assay described was convenient, rapid, and specific; thereby potentially efficient in the high-throughput analysis of ß2 -agonists residues in real food samples.

Electro-deposited poly-luminol molecularly imprinted polymer coating on carboxyl graphene for stir bar sorptive extraction of estrogens in milk.

Electrochemical polymerization of luminol molecularly imprinted polymer on carboxyl graphene (MIP/CG) was developed as stir bar sorptive extraction (SBSE) coating for selective pre-concentration and specific recognition of bisphenol A (BPA), hexoestrol and diethylstilbestrol in milk samples. Luminol was employed as monomer and BPA as the template to prepare MIP under 0-0.6V electro-polymerization. Carboxyl graphene was modified on pencil lead as the substrate to increase extraction capacity. The preparation and extraction conditions affecting the extraction efficiency were optimized. Under the optimized conditions, a good linearity of three estrogens was obtained in the range of 4-1000ngmL(-1). The average recoveries at the three spiked levels of the three estrogens ranged from 83.4% to 96.3% with the relative standard deviations (RSD)≤7.1%. The limits of detection were in the range of 0.36-1.09ngmL(-1). The developed method with low cost, high selectivity and good reproducibility can be potentially applied for determining trace estrogens in complex food samples.

Selective dispersive solid phase extraction-chromatography tandem mass spectrometry based on aptamer-functionalized UiO-66-NH2 for determination of polychlorinated biphenyls.

In this paper, a novel dispersive solid phase extraction (dSPE) adsorbent based on aptamer-functionalized magnetic metal-organic framework material was developed for selective enrichment of the trace polychlorinated biphenyls (PCBs) from soil sample. Firstly, we developed a simple, versatile synthetic strategy to prepare highly reproducible magnetic amino-functionalized UiO-66 (Fe3O4@PDA@UiO-66-NH2) by using polydopamine (PDA) as covalent linker. Then amino-functionalized aptamers which can recognize 2,3',5,5'-tetrachlorobiphenyl (PCB72), 2',3',4',5,5'-pentachlorobiphenyl (PCB106) were covalent immobilized on UiO-66-NH2 through coupling reagent of glutaraldehyde. Aptamer-functionalized adsorbent (Fe3O4@PDA@UiO-66-Apt) can specifically capture PCBs from complex matrix with high adsorption capacity based on the specific affinity of aptamer towards target. Moreover, the adsorbent can be easily isolated from the solution through magnetic separation after extraction. Afterwards, the detection was carried out with gas chromatography tandem mass spectrometry (GC-MS). The selective dSPE pretreatment coupled with GC-MS possessed high selectivity, good binding capacity, stability, repeatability and reproducibility for the extraction of PCBs. Furthermore, the adsorbent possessed good mechanical stability which can be applied in replicate at least for 60 extraction cycles with recovery over 80%. It provided a linear range of 0.02-400ngmL(-1) with a good correlation coefficient (R(2)=0.9994-0.9996), and the limit of detection was found to be 0.010-0.015ngmL(-1). The method was successfully utilized for the determination of PCBs in soil samples.

Aptamer-functionalized stir bar sorptive extraction coupled with gas chromatography-mass spectrometry for selective enrichment and determination of polychlorinated biphenyls in fish samples.

In this paper, a novel aptamer-functionalized stir bar sorptive extraction (SBSE) was developed for selective enrichment of the low abundance polychlorinated biphenyls (PCBs) from fish samples. This approach was based on the immobilization of aptamer which could recognize 2,3',5,5'-tetrachlorobiphenyl (PCB72) and 2',3',4',5,5'-pentachlorobiphenyl (PCB106) on one kind of metal-organic frameworks (Zn4O(BDC)3, MOF-5). MOF-5 as a substrate was prepared by potential-controlled cathodic electrodeposition on stainless steel. This aptamer-functionalized stir bar sorptive extraction (Apt-MOF SBSE) fiber could be facile synthesized in one-step. PCB72 and PCB106 were employed as target analytes for selective extraction by the developed method. The adsorbed targets could be desorbed easily in pH 3.0 100mM glycine-HCl buffers and then extracted by the methylene chloride. Afterwards, the detection was carried out with gas chromatography-tandem mass spectrometry (GC-MS). The Apt-MOF SBSE pretreatment coupled with GC-MS exhibited high selectivity, good binding capacity, stability and reproducibility for the detection of PCBs. It provided a linear range of 0.02-250ngmL(-1) with a good coefficient of determination (R(2)=0.9991-0.9996) and the detection limit was 0.003-0.004ngmL(-1). More importantly, the method was successfully utilized for the determination of PCBs in fish samples with good enrichment factor (1930-2304). Therefore, this new SBSE coating opens up the possibility of selective enrichment of a given target PCBs from complex fish samples.

Magnetic metal-organic frameworks coated stir bar sorptive extraction coupled with GC-MS for determination of polychlorinated biphenyls in fish samples.

In this work, several kinds of the metal-organic framework (MOF) were evaluated the adsorption performance to PCB. Finally, MOF-5(Fe) was introduced in stir bar sorptive extraction (SBSE) as the adsorbent to extract six polychlorinated biphenyls (PCBs). Nd-Fe-B permanent magnet was employed as stir bar, which was then coated with Fe3O4-MOF-5(Fe) composite magnetic material, which was prepared by solvothermal method. The stir bar was then employed to extract and enrich six indicator PCBs (2,2',5,5'-tetrachlorobiphenyl, 2,2',4,5,5'-pentachlorobiphenyl, 2,2',3,4,4',5-hexachlorobiphenyl, 2,3,4,4,5-pentachlorobiphenyl, 2,2',4,4',5,5'-hexachlorobiphenyl, 2,2',3,4,4',5,5'-heptachlorobiphenyl) under stirring, then eluted by n-hexane under ultrasound. Its saturated adsorption amount was found to be 17.0-17.8 mg g(-1) and only 30 min were needed to reach adsorption equilibrium. The MOF-stir bar can be reused for 60 times with the recovery above 80%, which exhibited good stability. Under the optimal experimental conditions, MOF-5(Fe) based SBSE was coupled with GC-MS for detecting six PCBs. The limits of detection (S/N=3) of the developed method were 0.061-0.096 ng g(-1), with enrichment factors of 50-100 fold. And the linear ranges were 0.01-500 µg L(-1). The new method was successfully applied to assess PCBs in fish samples with satisfactory recovery ranging from 94.3% to 97.5%.

A novel reductive graphene oxide-based magnetic molecularly imprinted poly(ethylene-co-vinyl alcohol) polymers for the enrichment and determination of polychlorinated biphenyls in fish samples.

The novel reductive graphene oxide-based magnetic molecularly imprinted poly(ethylene-co-vinyl alcohol) polymers (rGO@m-MIPs) were successfully synthesized as adsorbents for six kinds of polychlorinated biphenyls (PCBs) in fish samples. rGO@m-MIPs was prepared by surface molecular imprinting technique. Besides, Fe3 O4 nanoparticles (NPs) were employed as magnetic supporters, and rGO@Fe3 O4 was in situ synthesis. Different from functional monomer and cross-linker in traditional molecularly imprinted polymer, here, 3,4-dichlorobenzidine was employed as dummy molecular and poly(ethylene-co-vinyl alcohol) was adopted as the imprinted polymers. After morphology and inner structure of the magnetic adsorbent were characterized, the adsorbent was employed for disperse solid phase extraction toward PCBs and exhibited great selectivity and high adsorption efficiency. This material was verified by determination of PCBs in fish samples combined with gas chromatography-mass spectrometry (GC-MS) method. According to the detection, the low detection limits (LODs) of PCBs were 0.0035-0.0070 µg l(-1) and spiked recoveries ranged between 79.90 and 94.23%. The prepared adsorbent can be renewable for at least 16 times and expected to be a new material for the enrichment and determination of PCBs from contaminated fish samples.

Separation and enrichment of six indicator polychlorinated biphenyls from real waters using a novel magnetic multiwalled carbon nanotube composite absorbent.

A novel and effective magnetic multiwalled carbon nanotube composite for the separation and enrichment of polychlorinated biphenyls was developed. Fe3 O4 @SiO2 core-shell structured nanoparticles were first synthesized, then the poly(sodium 4-styrenesulfonate) was laid on its surface to prepare the polyanionic magnetic nanoparticles. The above materials were then grafted with polycationic multiwalled carbon nanotubes, which were modified by polydiallyl dimethyl ammonium chloride through the layer-by-layer self-assembly approach. Its performance was tested by magnetic solid-phase extraction and gas chromatography with mass spectrometry for the determination of six kinds of indicator polychlorinated biphenyls in water samples. Under optimal conditions, the spiked recoveries of several real samples for six kinds of polychlorinated biphenyls (PCB28, PCB52, PCB101, PCB138, PCB153, PCB180) were in the range of 73.4-99.5% with relative standard deviations varying from 1.5 to 8.4%. All target compounds showed good linearities in the tested range with correlation coefficients higher than 0.9993. The limits of quantification for six kinds of indicator polychlorinated biphenyls were between 0.018 and 0.039 ng/mL. The proposed method was successfully applied to analyze polychlorinated biphenyls in real water samples. Satisfactory results were obtained using the effective magnetic absorbent.

Multi-walled carbon nanotube modified dummy-template magnetic molecularly imprinted microspheres as solid-phase extraction material for the determination of polychlorinated biphenyls in fish.

Novel multi-walled carbon nanotube modified dummy-template molecularly imprinted microspheres (MWCNTs@DMMIPs) were successfully synthesized as adsorbents for six kinds of polychlorinated biphenyls (PCBs). MWCNTs@DMMIPs were prepared by a surface molecular imprinting technique. Core-shell Fe3 O4 @SiO2 nanoparticles were employed as magnetic support. 3,4-Dichlorobenzene acetic acid was used as a dummy template instead of PCBs, methacrylic acid was used as functional monomer and ethylene glycol dimethacrylate was used as the cross-linker. The resulting absorbent was characterized by various methods. The adsorbent was employed for extracting PCBs and exhibited good selectivity and high adsorption efficiency. Furthermore, it was reusable and capable of magnetic separation. Adsorption kinetics fit well with a pseudo-second-order kinetic equation and also exhibited a three-stage intra-particle diffusion model. The Freundlich model was used to describe the adsorption isotherms. The materials were successfully applied to the magnetic dispersive solid-phase extraction of six kinds of PCBs followed by gas chromatography with mass spectrometry determination in fish samples, the limit of detection of six kinds of PCBs were 0.0028-0.0068 µg/L and spiked recoveries ranged between 73.41 and 114.21%. The prepared adsorbent was expected to be a new material for the removal and recovery of PCBs from contaminated foods.