Effect of whitening products on sound enamel and on artificial caries lesions during a cariogenic challenge.

OBJECTIVE: To investigate the effect of fluoride-containing whitening products on sound enamel and on artificial caries lesions during a cariogenic challenge. MATERIALS AND METHODS: Bovine enamel specimens (n = 120) with three areas [non-treated sound enamel (NSE), treated sound enamel (TSE), and treated artificial caries lesion (TACL)] were randomly assigned to the four groups: whitening mouthrinse (WM: 2.5% hydrogen peroxide-100 ppm F-), placebo mouthrinse (PM: 0% hydrogen peroxide-100 ppm F-), whitening gel (WG: 10% carbamide peroxide-1130 ppm F-), and deionized water (negative control; NC). The treatments (2 min for WM, PM, and NC, and 2 h for WG) were carried out during a 28-day pH-cycling model (6 × 60 min demineralization/day). Relative surface reflection intensity (rSRI) and transversal microradiography (TMR) analyses were performed. Fluoride uptake (surface and subsurface) was measured in additional enamel specimens. RESULTS: For TSE, a higher value of rSRI was observed in WM (89.99% ± 6.94), and a greater decrease in rSRI was observed for WG and NC, and no sign of mineral loss was verified for all groups (p > 0.05). For TACL, rSRI significantly decreased after pH-cycling for all experimental groups with no difference between them (p < 0.05). Higher amounts of fluoride were found in WG. WG and WM exhibited intermediate values of mineral loss, similar to PM. CONCLUSIONS: The whitening products did not potentialize the enamel demineralization under a severe cariogenic challenge, and they did not exacerbate mineral loss of the artificial caries lesions. CLINICAL RELEVANCE: Low concentrated hydrogen peroxide whitening gel and mouthrinse containing fluoride do not intensify the progression of caries lesions.

Glass Ionomer Versus Self-adhesive Cement and the Clinical Performance of Zirconia Coping/Press-on Porcelain Crowns.

OBJECTIVE: This split-mouth clinical study investigated the effect of luting cement on the performance of veneered yttrium-stabilized tetragonal zirconia polycrystal (Y-TZP) zirconia crowns. METHODS AND MATERIALS: A total of 60 crowns prepared with Y-TZP coping and press-on porcelain were made with a split-mouth design in 30 participants. The crowns were cemented either with glass ionomer cement (GIC) (Meron, Voco) or with self-adhesive resin cement (Bifix-SE, Voco). The restorations were assessed immediately after treatment and after 6, 12, 24, 36, and 48 months using the modified United States Public Health Service criteria. The parameters analyzed were retention, color stability, marginal discoloration, marginal adaptation, surface roughness, anatomic form, and secondary caries. The differences between the groups were analyzed by the Fisher exact test in each period of evaluation. The survival rate was analyzed with the Kaplan-Meier and log-rank test (α=0.05). RESULTS: After 48 months, 20 participants attended the recall. During the period of evaluation, 1 crown cemented with glass ionomer cement and 1 crown cemented with resin cement lost retention. Color match, marginal discoloration and adaptation, surface roughness, and anatomic form did not change in any of the periods evaluated, and no secondary caries was observed. No significant differences were found between the 2 luting cements for any of the clinical parameters analyzed, nor for the survival rates during the study. CONCLUSIONS: The type of cement did not influence the performance of the crowns after 48 months of clinical use. Both cements resulted in adequate retention rates, aesthetic and functional outcomes, and biological response.

Efficacy and Safety of Bleaching Gels According to Application Protocol.

OBJECTIVES: This study evaluated bleaching efficacy, enamel microhardness, and roughness of highly concentrated hydrogen peroxide (HP) gels (35%-40%) using different application protocols. Gel decomposition and pH alteration were also analyzed. METHODS AND MATERIALS: Bovine enamel/dentin specimens were divided into groups according to the bleaching gel-Pola Office Plus (POP-SDI, 37.5% HP), Opalescence Boost (OPB-Ultradent, 40% HP), Whiteness HP (WHP-FGM, 35% HP)-and application protocol-single application (SA) and multiple application (MA) during the in-office session. Deionized water was used in control group (no bleaching). Thus, seven final groups were obtained (n=15/group). Color (CIE L*a*b*), surface microhardness (SMH), and roughness (Ra) were assessed before/after treatments. The pH of gels was measured, and HP concentration was determined with potassium permanganate titration method in different times. Data were submitted to analysis of variance and Tukey tests (5%). RESULTS: All gels presented similar and clinically acceptable bleaching efficacy (ΔE>2.7) for both SA and MA, as well as no significant differences for SMH and Ra comparing the two protocols in the same gel. Peroxide decomposition significantly increased with time, but final gel concentrations were still high after 45 minutes (32.29% POP; 38.45% OPB; and 32.74% WHP). The pH decreased over time (initial - after 45 min) for WHP (6.83±0.07 - 5.81±0.06), but minimal alterations were observed for POP (8.09±0.09 - 7.88±0.07) and OPB (7.82±0.11 - 7.87±0.07). CONCLUSIONS: Peroxide decomposition was very low for all gels tested, and pH remained stable for POP and OPB gels. Bleaching protocol did not influence whitening efficacy and hazardous effects over enamel, thus potentially there was no clinical significance. Therefore, for the products tested, there is no evidence for recommending the gel change during the bleaching session.

Assessment of Peroxide in Saliva During and After At-home Bleaching With 10% Carbamide and Hydrogen Peroxide Gels: A Clinical Crossover Trial.

CLINICAL RELEVANCE: This study suggests that at-home bleaching systems are safe in relation to toxicity based on peroxide levels in saliva since the amount of peroxide potentially ingested is much lower than the estimated toxic dose.