Averting cumulative lifetime attributable risk (LAR) of cancer by decontamination of residential areas affected by a large-scale nuclear power plant fallout: time aspects of radiological benefits for newborns and adults.

The averted cumulative lifetime attributable risk (LAR), the residual dose and highest ground deposition of 137Cs complying with a reference dose level of 20 mSv yr-1 to an individual returning after one year to an area contaminated by unfiltered releases of fission products from a nuclear power plant (NPP) were evaluated by applying an existing exposure model designed to compute age- and gender-dependent time-integrated LAR. The model was applied to four types of nuclear fallout scenarios, partly based on data from the Chernobyl and Fukushima releases and from theoretical source terms from Swedish NPPs. For rapid decontamination measures that achieve a 50% relative reduction in external dose rate within 1 year, compliance with the reference level 20 mSv yr-1 can be attained for an initial 137Cs ground deposition of up to 2 MBq m-2 with relaxed food restrictions. This compliance can be attained at even higher ground deposition (up to 4.5 MBq m-2) if using the strict food restrictions employed in Japan after 2011. Considering longer than 1 year return times it was also found that the benefit of implementing decontamination decreases rapidly with time (2-3 years half-time), especially if the fallout has a high initial 134Cs to 137Cs activity ratio and if the ecological half-time of the external dose rate is short (<5 years). Depending on fallout scenario the averted cumulative LAR for newborn girls by decontamination that is achieved after 5 years is only between 6% and 11% of that obtained by evacuation alone during the same time, indicating a rather limited radiological benefit of decontamination if delayed more than a few years. We conclude that decision makers and emergency response planners need to consider that protracted decontamination measures may have limited radiological benefit compared with evacuation in terms of averted future cancer cases, albeit it may have other societal benefits.

Diesel soot aging in urban plumes within hours under cold dark and humid conditions.

Fresh and aged diesel soot particles have different impacts on climate and human health. While fresh diesel soot particles are highly aspherical and non-hygroscopic, aged particles are spherical and hygroscopic. Aging and its effect on water uptake also controls the dispersion of diesel soot in the atmosphere. Understanding the timescales on which diesel soot ages in the atmosphere is thus important, yet knowledge thereof is lacking. We show that under cold, dark and humid conditions the atmospheric transformation from fresh to aged soot occurs on a timescale of less than five hours. Under dry conditions in the laboratory, diesel soot transformation is much less efficient. While photochemistry drives soot aging, our data show it is not always a limiting factor. Field observations together with aerosol process model simulations show that the rapid ambient diesel soot aging in urban plumes is caused by coupled ammonium nitrate formation and water uptake.

Evolution of In-Cylinder Diesel Engine Soot and Emission Characteristics Investigated with Online Aerosol Mass Spectrometry.

To design diesel engines with low environmental impact, it is important to link health and climate-relevant soot (black carbon) emission characteristics to specific combustion conditions. The in-cylinder evolution of soot properties over the combustion cycle and as a function of exhaust gas recirculation (EGR) was investigated in a modern heavy-duty diesel engine. A novel combination of a fast gas-sampling valve and a soot particle aerosol mass spectrometer (SP-AMS) enabled online measurements of the in-cylinder soot chemistry. The results show that EGR reduced the soot formation rate. However, the late cycle soot oxidation rate (soot removal) was reduced even more, and the net effect was increased soot emissions. EGR resulted in an accumulation of polycyclic aromatic hydrocarbons (PAHs) during combustion, and led to increased PAH emissions. We show that mass spectral and optical signatures of the in-cylinder soot and associated low volatility organics change dramatically from the soot formation dominated phase to the soot oxidation dominated phase. These signatures include a class of fullerene carbon clusters that we hypothesize represent less graphitized, C5-containing fullerenic (high tortuosity or curved) soot nanostructures arising from decreased combustion temperatures and increased premixing of air and fuel with EGR. Altered soot properties are of key importance when designing emission control strategies such as diesel particulate filters and when introducing novel biofuels.

Impacts of Combustion Conditions and Photochemical Processing on the Light Absorption of Biomass Combustion Aerosol.

The aim was to identify relationships between combustion conditions, particle characteristics, and optical properties of fresh and photochemically processed emissions from biomass combustion. The combustion conditions included nominal and high burn rate operation and individual combustion phases from a conventional wood stove. Low temperature pyrolysis upon fuel addition resulted in "tar-ball" type particles dominated by organic aerosol with an absorption Ångström exponent (AAE) of 2.5-2.7 and estimated Brown Carbon contributions of 50-70% to absorption at the climate relevant aethalometer-wavelength (520 nm). High temperature combustion during the intermediate (flaming) phase was dominated by soot agglomerates with AAE 1.0-1.2 and 85-100% of absorption at 520 nm attributed to Black Carbon. Intense photochemical processing of high burn rate flaming combustion emissions in an oxidation flow reactor led to strong formation of Secondary Organic Aerosol, with no or weak absorption. PM1 mass emission factors (mg/kg) of fresh emissions were about an order of magnitude higher for low temperature pyrolysis compared to high temperature combustion. However, emission factors describing the absorption cross section emitted per kg of fuel consumed (m(2)/kg) were of similar magnitude at 520 nm for the diverse combustion conditions investigated in this study. These results provide a link between biomass combustion conditions, emitted particle types, and their optical properties in fresh and processed plumes which can be of value for source apportionment and balanced mitigation of biomass combustion emissions from a climate and health perspective.

Complete post-separation of overlapping ultrasonic signals by combining hard and soft modeling.

In some ultrasonic measurement situations, an adequate signal separation is difficult to achieve. A typical situation is material characterization of thin media using pulse-echo or through-transmission techniques, when the time-of-flight in the media is shorter than the emitted signal's time support. Separated signals are necessary to obtain accurate estimates of material properties and transit times. In this paper a new method is proposed that enables complete post-separation of measured coinciding signals. The method is based on a combination of hard physical and soft empirical models, which allows for a description of both known and unknown properties making a complete separation possible. The validity and limitations of the model and the separation results are thoroughly addressed. The proposed technique is verified using real measurements on thin dispersive samples and validated using residual analysis. The experimental results show a complete separation with uncorrelated and normally distributed residuals. The method enables characterization and/or flow analysis in difficult overlapping situations.

Treatment with paclitaxel 1-h infusion and carboplatin of patients with advanced non-small-cell lung cancer: a phase II multicentre trial. Joint Lung Cancer Study Group.

The primary aim of this phase II study was to determine the response rate of a combination of paclitaxel and carboplatin in advanced non-small cell lung cancer (NSCLC) in a multicentre setting. The secondary aim was to determine time to progression (TTP), 1-year survival rate and toxicity. 65 patients were treated and all of them were included in the follow up for survival and toxicity. 60 patients were followed for response rate and time to progression. 55% were stage IV patients and 45% stage IIIB patients. The treatment consisted of paclitaxel 200 mg/m2 given as a 1-h i.v. infusion and carboplatin given as a 30 min i.v. infusion and the latter was dosed by using the Calvert formula at an area under the concentration time curve (AUC) of 5. The glomerular filtration rate (GFR) was determined by iohexol clearance and was not calculated from the serum creatinine level. The chemotherapy courses were given every third week with a maximum number of six or eight courses for patients who responded late. As premedication we used 8 mg betamethasone 40 min prior to infusion and then 10 min later clemastin and cimetidine. One complete response and 18 partial responses were seen giving a response rate of 29%. 40% of the patients progressed during the treatment and 28% had stable disease. The median TTP was 22 weeks. At a minimum follow up of 1 year, the 1-year survival rate was 38% and the median survival rate was 41 weeks. Haematological toxicity was mild with no grade 4 leucopenia and only seven patients (11%) had grade 3 leucopenia. There was no grade 4 toxicity. Grade 3 toxicity was seen as myalgia 5%, allergic reaction 3% and peripheral neuropathy 6%. 15% of the patients had a dose reduction due to neurotoxicity. The haematological toxicity was much milder than we expected, probably because of more exact determination of the GFR. This trial confirms the results of earlier reported trials of the efficacy and the ease of the regimen as an out-patient treatment option in advanced NSCLC. The main problem with this treatment is peripheral neuropathy.