kV reference dosimetry in Australia and New Zealand: Survey results and trends.

PURPOSE: To assess the number of radiotherapy kilovoltage (kV) units in service, their clinical utilization, and methodology and equipment used for absorbed dose determination across Australia and New Zealand. METHODS: A survey was sent to 61 Australian and New Zealand radiotherapy providers in the second half of 2023. RESULTS: Fifty-seven responses were received, with 43 departments having kV units and providing beam quality data for 185 therapeutic kV beams 20-300 kVp. Percentage depth dose curves were compared between five clinical beams with 100 kVp and 2.13-6.28 mm Aluminum half value layers (HVLs), demonstrating large differences that can occur between beams with the same kVp. Eighteen departments provided clinical utilization data for their kV units, with a total of 4458 treatment courses and their corresponding kVp reported. All departments complied with national and international recommendations with respect to the equipment used for reference dosimetry of kV beams; 77% of ionization chambers used for absorbed dose determination were of Farmer-type, with the remaining 23% being plane parallel soft x-ray chambers. Methods of derivation of air-kerma calibration factors varied, with 73% of respondents using a draft document disseminated by the Australian Primary Standards laboratory, 23% using HVL alone, and 6% using other methods. CONCLUSIONS: The results of this survey provide a snapshot of kilovoltage radiation therapy use and the number of kV units across Australia and New Zealand. This data can be used as a point of reference for future investigations into clinical utilization and reference dosimetry methods across Australia and New Zealand or for comparisons with other countries, facilitating standardization of reference dosimetry practice for kilovoltage units.

Characterization of a flexible a-Si:H detector for in vivo dosimetry in therapeutic x-ray beams.

BACKGROUND: The increasing use of complex and high dose-rate treatments in radiation therapy necessitates advanced detectors to provide accurate dosimetry. Rather than relying on pre-treatment quality assurance (QA) measurements alone, many countries are now mandating the use of in vivo dosimetry, whereby a dosimeter is placed on the surface of the patient during treatment. Ideally, in vivo detectors should be flexible to conform to a patient's irregular surfaces. PURPOSE: This study aims to characterize a novel hydrogenated amorphous silicon (a-Si:H) radiation detector for the dosimetry of therapeutic x-ray beams. The detectors are flexible as they are fabricated directly on a flexible polyimide (Kapton) substrate. METHODS: The potential of this technology for application as a real-time flexible detector is investigated through a combined dosimetric and flexibility study. Measurements of fundamental dosimetric quantities were obtained including output factor (OF), dose rate dependence (DPP), energy dependence, percentage depth dose (PDD), and angular dependence. The response of the a-Si:H detectors investigated in this study are benchmarked directly against commercially available ionization chambers and solid-state diodes currently employed for QA practices. RESULTS: The a-Si:H detectors exhibit remarkable dose linearities in the direct detection of kV and MV therapeutic x-rays, with calibrated sensitivities ranging from (0.580 ± 0.002) pC/cGy to (19.36 ± 0.10) pC/cGy as a function of detector thickness, area, and applied bias. Regarding dosimetry, the a-Si:H detectors accurately obtained OF measurements that parallel commercially available detector solutions. The PDD response closely matched the expected profile as predicted via Geant4 simulations, a PTW Farmer ionization chamber and a PTW ROOS chamber. The most significant variation in the PDD performance was 5.67%, observed at a depth of 3 mm for detectors operated unbiased. With an external bias, the discrepancy in PDD response from reference data was confined to ± 2.92% for all depths (surface to 250 mm) in water-equivalent plastic. Very little angular dependence is displayed between irradiations at angles of 0° and 180°, with the most significant variation being a 7.71% decrease in collected charge at a 110° relative angle of incidence. Energy dependence and dose per pulse dependence are also reported, with results in agreement with the literature. Most notably, the flexibility of a-Si:H detectors was quantified for sample bending up to a radius of curvature of 7.98 mm, where the recorded photosensitivity degraded by (-4.9 ± 0.6)% of the initial device response when flat. It is essential to mention that this small bending radius is unlikely during in vivo patient dosimetry. In a more realistic scenario, with a bending radius of 15-20 mm, the variation in detector response remained within ± 4%. After substantial bending, the detector's photosensitivity when returned to a flat condition was (99.1 ± 0.5)% of the original response. CONCLUSIONS: This work successfully characterizes a flexible detector based on thin-film a-Si:H deposited on a Kapton substrate for applications in therapeutic x-ray dosimetry. The detectors exhibit dosimetric performances that parallel commercially available dosimeters, while also demonstrating excellent flexibility results.

Experience with an online helpdesk for equipment fault reporting in a radiation oncology department.

The safe and accurate delivery of radiotherapy requires that the various items of equipment used in the treatment process are in proper working order. Unusual equipment behavior, interlocks, and faults need to be communicated promptly to the appropriate personnel, the issue investigated, and information regarding the nature of faults and any subsequent reparative measures recorded in a readily accessible location. At the Illawarra Cancer Care Centre, an online help desk was introduced for the purposes of reporting and tracking equipment faults. In the three years since its introduction, there have been in excess of 1,300 entries made, and it has proven to be a suitable alternative to the use of a physical logbook. Key benefits identified were improved accessibility, automated fault notification, and the ability to search, review and update entries for particular equipment faults. It has been a useful tool for assessing the long-term performance of each piece of equipment, identifying specific servicing needs, and for substantiating the effectiveness of the service performed. The online help desk has not replaced the need for direct methods of verbal communication between the various professional groups involved with monitoring equipment performance. However, it is a very useful tool for supporting that communication.

Effective photodynamic therapy against microbial populations in human deep tissue abscess aspirates.

BACKGROUND AND OBJECTIVE: The primary therapy for deep tissue abscesses is drainage accompanied by systemic antimicrobial treatment. However, the long antibiotic course required increases the probability of acquired resistance, and the high incidence of polymicrobial infections in abscesses complicates treatment choices. Photodynamic therapy (PDT) is effective against multiple classes of organisms, including those displaying drug resistance, and may serve as a useful adjunct to the standard of care by reduction of abscess microbial burden following drainage. STUDY DESIGN/MATERIALS AND METHODS: Aspirates were obtained from 32 patients who underwent image-guided percutaneous drainage of the abscess cavity. The majority of the specimens (24/32) were abdominal, with the remainder from liver and lung. Conventional microbiological techniques and nucleotide sequence analysis of rRNA gene fragments were used to characterize microbial populations from abscess aspirates. We evaluated the sensitivity of microorganisms to methylene blue-sensitized PDT in vitro both within the context of an abscess aspirate and as individual isolates. RESULTS: Most isolates were bacterial, with the fungus Candida tropicalis also isolated from two specimens. We examined the sensitivity of these microorganisms to methylene blue-PDT. Complete elimination of culturable microorganisms was achieved in three different aspirates, and significant killing (P < 0.0001) was observed in all individual microbial isolates tested compared to controls. CONCLUSIONS: These results and the technical feasibility of advancing optical fibers through catheters at the time of drainage motivate further work on including PDT as a therapeutic option during abscess treatment.

Comparing and evaluating the efficacy of the TOR18FG Leeds test X-ray phantom for T-rays.

The commercially available X-ray fluoroscopy quality assurance phantom, the Leeds test object TOR18FG, was found to be suitable to assess T-ray image quality in the range (0.1-0.4) THz at a depth of 0.5 cm. Previous to this only custom made phantoms, made especially for the T-ray region, assessed T-ray spatial resolution. However, if sub-wavelength techniques are used, the Leeds test phantom may be implemented to measure the T-ray systems spatial resolution, allowing us to directly compare X-ray and T-ray spatial resolution. The systems compared include a Gulmay Orthovoltage machine (X-ray), the On Board Imager (OBI) of a Varian linear accelerator (X-ray), a two-colour system (T-ray) and Terahertz Time Domain Spectroscopy (THz-TDS) system. X-rays were found to have a spatial resolution of 1.25 lp/mm using the On Board Imager of a Varian Linear Accelerator whilst T-rays imaged using a broadband source imaged through a spatial pinhole had a spatial resolution of 0.56 lp/mm. The TOR18FG background material was found to block, 90% and 99% of the broadband T-rays emitted from a THz-TDS photo-conductive emitter, at 0.4 THz and 0.53 THz respectively. Contrast sensitivity was found to be 3% for 25 cm × 25 cm X-ray field at 65 kV, whilst this value could not be established for T-rays using the TOR18FG. All contrast circles were found to be the same for T-rays i.e. all 40% at 0.1 THz. Images of the same leaf were taken with diagnostic X-rays and both broadband and continuous wave (CW) T-ray systems. T-rays proved superior in providing image contrast, for a hydrated leaf, over X-rays.

The use of PET in assessing tumor response after neoadjuvant chemoradiation for rectal cancer.

PURPOSE: To assess the correlation of 18F-FDG-PET (PET) response to pathological response after neoadjuvant chemoradiation (CRT) for locally advanced rectal cancer. METHODS AND MATERIALS: Twenty patients with locally advanced rectal cancer were identified between 2001 and 2005. The median age was 57 years (range 37-72) with 14 males and 6 females. All patients were staged with endorectal ultrasound and/or MRI, CT, and PET. The clinical staging was T3N0M0 (16), T3N1M0 (2), and T3N0M1 (2). Restaging PET was performed after CRT, and prior to definitive surgery. The response on PET and pathology was assessed and correlated. Patient outcome according to PET response was also assessed. RESULTS: Following CRT, a complete PET response occurred in 7 patients, incomplete response in 10, and no response in 3 patients. At surgery, complete pathological response was recorded in 7 patients, incomplete response in 10 and no response in 3. There was a good correlation of PET and pathological responses in complete responders (5/7 cases) and non-responders (3/3 cases). After a median follow-up of 62 months (range 7-73), twelve patients were alive with no evidence of disease. All patients achieving complete metabolic response were alive with no evidence of disease, while as those who had no metabolic response, all died as a result of metastatic disease. CONCLUSIONS: PET is a promising complementary assessment tool for assessing tumor response after CRT if there is a complete or no response. PET response may also predict for outcome.

Intermediate follow-up after endovascular aneurysm repair: can we forgo CT scanning in certain patients?

Current recommendations for follow-up after endovascular repair of abdominal aortic aneurysms (EVAR) include yearly computed tomographic (CT) scans after the first year. We hypothesize that this is unnecessary for patients who have aneurysm sacs that are stable or shrinking at 1 year and no evidence of endoleak. To explore this hypothesis, we reviewed the records of all patients undergoing EVAR at our institution who were implanted with grafts that are currently commercially available and had a minimum of 18 months' follow-up. Of 415 patients who underwent EVAR over an 8-year period, 93 met the entry criteria. At a mean follow-up of approximately 3 years, secondary interventions were required in 13%, 39%, and 25% of patients undergoing EVAR with Zenith, AneuRx, and Excluder devices, respectively, and secondary interventions after the first year were required in 3%, 22%, and 8% of such grafts, respectively. Seventy-one patients (76%) had aneurysm sacs that were stable or shrinking at 1 year and no endoleak. Only two of these patients subsequently required reintervention. Both patients had AneuRx grafts, and both problems could have easily been identified without CT scanning. Our data support the hypothesis that patients who meet these criteria at 1 year are unlikely to have problems that cannot be identified by ultrasound and/or clinical evaluation alone and, thus, that CT scans are not necessary after this point, especially in patients with Zenith or reengineered Excluder devices.

Technical considerations for late removal of aortic endografts.

INTRODUCTION: The endovascular repair of abdominal aortic aneurysms has become increasingly common during the past decade. Despite aggressive attempts to treat endoleak and graft failure with endovascular salvage procedures, some grafts necessitate surgical removal. We reviewed our experience with late endograft explantation in an effort to identify technical maneuvers critical for success. METHODS: Of 110 patients treated with aortic abdominal endografts at the University of Rochester Medical Center between August 1997 and June 2001, five (4.5%) needed late graft removal. Medical records, radiographic files, and case report forms were retrospectively reviewed. RESULTS: One Talent (Medtronic AVE, Santa Rosa, Calif) and four Vanguard (Boston Scientific, Natick, Mass) grafts were removed at a mean of 32.7 months (range, 18 to 44 months) after implantation. One patient underwent conversion for rupture, three for endoleaks (one each with types I, II, and III), and one for stent separation from the graft material without endoleak or aneurysm expansion. Three cases were approached via the midline, one through a bilateral subcostal incision, and one through a retroperitoneal incision. Supraceliac aortic control was used in all patients. Removal of two of the Vanguard grafts necessitated extension of the aortotomy above the level of the renal orifices. One perioperative death occurred. The mean operative blood loss was 4700 mL (range, 1850 to 9000 mL), and length of stay was 19.8 days (range, 7 to 42 days). CONCLUSION: The morbidity and mortality rates associated with late removal of endografts are significant. Removal of Vanguard devices can necessitate extension of the aortotomy above the renal arteries. We believe that control of the aorta well above the proximal fixation site is the key to removal and that continuous aortic exposure via retroperitoneal exposure is the best option in this situation.