RESUMEN
Recently, a great deal of interest has been focused on developing sensors that can measure both pressure and light. However, traditional sensors are difficult to integrate into silicon (Si)-based integrated circuits. Therefore, it is particularly important to design a sensor that operates on a new principle. In this paper, junction piezotronic transistor (JPT) arrays based on zinc oxide (ZnO) nanowire are demonstrated. And the JPT arrays show high spatial resolution pressure and light mapping with 195 dpi. Because ZnO nanowires are arranged vertically above the p-type Si channel's center of the transistor, the width of the heterojunction depletion region is constricted by the positive piezoelectric potential generated by strained ZnO. In addition, photogenerated charge carriers can be created in the Si channel when JPT is stimulated by light, which increases its electrical conductivity. Consequently, the external pressure and light distribution information can be obtained from the variation in the output current of the device. The prepared JPT arrays can be compatible with Si transistors, which make them highly competitive and make it possible to incorporate both pressure and light sensors into large integrated circuits. This work will contribute to many applications, such as intelligent clothing, human-computer interaction, and electronic skin.
RESUMEN
Touch is a general term to describe mechanical stimuli. It is extremely difficult to develop touch sensors that can detect different modes of contact forces due to their low sensitivity and data decoupling. Simultaneously conducting tactile and slip sensing presents significant challenges for the design, structure, and performance of sensors. In this work, a highly sensitive sandwich-structured sensor is achieved by exploiting the porosity and compressive modulus of the sensor's functional layer materials. The sensor shows an ultra-high sensitivity of 1167 kPa-1 and a low-pressure detection limit of 1.34 Pa due to its considerably low compression modulus of 23.8 Pa. Due to this ultra-high sensitivity, coupled with spectral analysis, it allows for dual-mode detection of both tactile and slip sensations simultaneously. This novel fabrication strategy and signal analysis method provides a new direction for the development of tactile/slip sensors.
RESUMEN
An all-fibrous large-area (20 × 50 cm2 ) tailorable triboelectric nanogenerator (LT-TENG) is prepared using a one-step solution blow spinning technology, which has the advantages of easy operation, scale-up in the area, and high production efficiency. The prepared LT-TENG is composed of polyvinylidene fluoride (PVDF)/MXene (Ti3 C2 Tx ) nanofibers (NFs) and conductive textile. Benefiting from the fibrous materials and large-area properties, the LT-TENG possesses the merits of good tailorability, breathability, hydrophobicity, and washability. When optimized by mixing the MXene into PVDF NFs, the LT-TENG has a preferable output and sensing property, with a detection range over 16 kPa and a relatively high sensitivity of 12.33 V KPa-1 . At maximum applied pressure, the voltage, current, and charge are 108 V, 38 µA, and 35 nC, respectively. This LT-TENG can serve as a biomechanical energy harvester when used as wearable devices with an output power density of 12.6 mW m-2 at an external load resistance of 500 MΩ, and it also has the ability of self-powered tactile sensing for pressure mapping and slide sensing. Thus, this LT-TENG exhibits great potential prospects in wearable devices, intelligent robots, and human-machine interaction.
