Dissipative Kerr soliton generation at 2µm in a silicon nitride microresonator.

Chip-scale optical frequency combs enable the generation of highly-coherent pulsed light at gigahertz-level repetition rates, with potential technological impact ranging from telecommunications to sensing and spectroscopy. In combination with techniques such as dual-comb spectroscopy, their utilization would be particularly beneficial for sensing of molecular species in the mid-infrared spectrum, in an integrated fashion. However, few demonstrations of direct microcomb generation within this spectral region have been showcased so far. In this work, we report the generation of Kerr soliton microcombs in silicon nitride integrated photonics. Leveraging a high-Q silicon nitride microresonator, our device achieves soliton generation under milliwatt-level pumping at 1.97 µm, with a generated spectrum encompassing a 422 nm bandwidth and extending up to 2.25 µm. The use of a dual pumping scheme allows reliable access to several comb states, including primary combs, modulation instability combs, as well as multi- and single-soliton states, the latter exhibiting high stability and low phase noise. Our work extends the domain of silicon nitride based Kerr microcombs towards the mid-infrared using accessible factory-grade technology and lays the foundations for the realization of fully integrated mid-infrared comb sources.

Thermorefractive noise reduction of photonic molecule frequency combs using an all-optical servo loop.

Phase and frequency noise originating from thermal fluctuations is commonly a limiting factor in integrated photonic cavities. To reduce this noise, one may drive a secondary "servo/cooling" laser into the blue side of a cavity resonance. Temperature fluctuations which shift the resonance will then change the amount of servo/cooling laser power absorbed by the device as the laser moves relatively out of or into the resonance, and thereby effectively compensate for the fluctuation. In this paper, we use a low noise laser to demonstrate this principle for the first time in a frequency comb generated from a normal dispersion photonic molecule micro-resonator. Significantly, this configuration can be used with the servo/cooling laser power above the usual nonlinearity threshold since resonances with normal dispersion are available. We report a 50 % reduction in frequency noise of the comb lines in the frequency range of 10 kHz to 1 MHz and investigate the effect of the secondary servo/cooling noise on the comb.