Biomechanical comparison of successful snatch and unsuccessful frontward barbell drop in world-class male weightlifters.

This study aimed to clarify the success factor of snatch based on barbell trajectory and lifter's motion among elite male weightlifters. Motion analysis of snatch was conducted using digital videos recorded at the 2015 World Weightlifting Championships. Data on successful and unsuccessful snatch lifts of 22 lifters, each using the same weights, were analysed; the unsuccessful lift was due to a frontward barbell drop. Results revealed that the difference in backward barbell displacement between the turnover to catch phase (DxL) and peak backward barbell velocity (pVx-) was significantly greater in successful snatch than in frontward barbell drops (DxL: p < 0.001, d > 5.0, pVx-: p < 0.01, d > 2.0). Backward displacement of the lifters' centre of mass (COM) between the transition to turnover phase in a successful snatch lift was significantly smaller than that in an unsuccessful lift (p < 0.05, d > 2.0). It is considered that there was excessive backward leaning during unsuccessful lifts. However, no significant difference in maximum barbell height (Dy1) was found. Based on these findings, DxL and pVx- are success factors for snatch, whereas Dy1 is not. It is suggested that avoiding excessive backward-leaning of the body in the turnover phase may vary the chances of successful snatch among elite male weightlifters.

Validation of video analysis of marker-less barbell auto-tracking in weightlifting.

We determined the marker-less barbell auto-tracking accuracy using the Kanade-Lucas-Tomasi (KLT) algorithm in a digital video for two-dimensional analysis (2D-AT). The position coordinates of the barbell's right end during multiple loads (60%-90% of one-repetition maximum) of snatch motion in eight participants were recorded using a three-dimensional motion capture system. Simultaneously, the snatch motion was recorded by a digital camera from the right side. Based on the digital video, the center of the barbell's right end was auto-tracked using the KLT algorithm. Six barbell kinematic variables (forward, backward, and vertical displacement, peak forward, backward, and vertical velocity) were calculated. Intraclass correlation coefficient (ICC) analysis was performed to establish the agreement level between the methods. The Bland-Altman plots and regression were used to examine the agreement between the methods. ICCs of 0.999-0.971 revealed a strong agreement level between the methods. The Bland-Altman plot showed small bias (-0.001-0.001 m, -0.034 --0.005 m/s). We considered that 2D-AT could obtain barbell position coordinates with sufficient accuracy to discriminate the difference in the lifter's level and a successful or unsuccessful lift.

Characteristics of the Shrug Motion and Trapezius Muscle Activity During the Power Clean.

ABSTRACT: Nagao, H and Ishii, Y. Characteristics of the shrug motion and trapezius muscle activity during the power clean. J Strength Cond Res 35(12): 3288-3295, 2021-Although the shrug motion and trapezius muscle activity are commonly considered as important in Olympic weightlifting exercises, there are no data on the shrug motion in Olympic weightlifting. Providing objective data on shrug motion and upper trapezius muscle (TZ) activity during power clean (PC) will help coaches properly evaluate technique and select accessory exercises. The purpose of this study was to clarify the role of the shrug motion and TZ activity during PC. Twenty trained men performed the PC at 50, 70, and 90% of 1 repetition maximum (1RM). Kinematics motion data and TZ surface electromyography were recorded. The range of motion of the shrug angle (sROM) and scapular adduction angle (aROM) were calculated during each phase of the PC. The TZ activity of each phase was evaluated by the root-mean-square of TZ activity (TZ%RMS), normalized by the maximal voluntary contraction. In the first pull and transition phases, TZ%RMS was significantly larger (p < 0.05; η2 = 0.10, 0.11) at 90% 1RM than at 50% 1RM. In the second pull phase, the sROM and aROM were significantly larger (p < 0.01; η2 = 0.19, 0.19) at 50% 1RM than at 90% 1RM, and the TZ%RMS was significantly larger (p < 0.01; η2 = 0.30) at 50% 1RM than at 70% 1RM and 90% 1RM, and at 70% 1RM than at 90% 1RM. Trapezius muscle activity appears to work to maintain scapular position, especially in the first pull and transition phases. In the second pull phase, the TZ was aggressively contracted to elevate the scapula and pull the barbell, but the sROM decreased as the load increased.

First Report of Environmental Isolation of Exophiala spp. in Malaysia.

The opportunistic pathogen Exophiala dermatitidis has been frequently isolated from tropical regions of the world. However, there is no report of environmental isolation of Exophiala spp. from Malaysia. The information regarding the ecology of this microbe is important for a better understanding of the opportunism. This study aims to conduct a survey of natural distribution of Exophiala spp. in Malaysia. Forty-seven strains of Exophiala-like was isolated by using selective media. These isolates from the fields were molecularly identified based on the ITS region. The biochemical activity of these microbes was tested by conducting various tests, i.e. DNase test, proteinase activity, and urea hydrolysis. Overall, 22 strains of E. dermatitidis were successfully obtained and identified from burnt tree bark, oil dripped soil sample, hot spring biofilm, railway track stones, tar road contaminated with petrol hydrocarbon, drain and deep mud of Sungai Pinang besides the new discovery from pigeon droppings. A single strain of E. heteromorpha was identified from tar road contaminated with petrol hydrocarbon. Genotypes of the isolated E. dermatitidis were identified by the neighbor-joining tree and grouped into Genotype A, A2 and B. The existence of new Genotype A4 was confirmed by a similar cladogram position in both neighbor-joining and maximum likelihood tree. The survival of E. dermatitidis in the hydrocarbon contaminated environment was studied by supplying engine oil and observing the growth pattern. The results of this study suggest that the opportunistic Exophiala spp. was isolated from nutrient limited and harsh conditions in the natural environment.

A Biomechanical Comparison of Successful and Unsuccessful Snatch Attempts among Elite Male Weightlifters.

The success factor of the snatch has not been identified. Determining the success factors of the snatch among elite weightlifters might help to attain a successful snatch. This study aimed at clarifying the factors that lead to a successful snatch based on barbell trajectory among elite male weightlifters. Data were collected at the 2017 World and Junior World Weightlifting Championships. We digitized the barbell trajectory of the successful and unsuccessful snatch attempts of 61 lifters-an unsuccessful lift would be as a result of a frontward barbell drop-and calculated the kinematic and kinetic parameters of the barbell. No significant difference was found in the barbell maximum height (Dy1) between the successful and unsuccessful lifts. The amount of backward displacement of the barbell in the second pull phase to the catch position (DxL) of the successful lift was significantly larger than that of the unsuccessful lift (successful: 0.11 ± 0.05 m; unsuccessful: 0.10 ± 0.06 m; p < 0.01; d = 0.278). The barbell drop distance in the catch phase (Dy3) of the successful lift was significantly smaller than that in the unsuccessful lift (successful: 0.17 ± 0.04 m; unsuccessful: 0.18 ± 0.04 m; p < 0.001, d = 0.361). These results suggest that DxL and Dy3 are factors leading to a successful snatch lift, but not Dy1. The relative position in the sagittal axis of the barbell and the lifter in the catch position, and catching the barbell when its momentum was low, are important in order to achieve a successful snatch.

Selection of inactivation medium for fungal spores in clinical wastes by supercritical carbon dioxide.

The present study aimed to select the best medium for inactivation of Aspergillus fumigatus, Aspergillus spp. in section Nigri, A. niger, A. terreus var. terreus, A. tubingensis, Penicillium waksmanii, P. simplicissimum, and Aspergillus sp. strain no. 145 spores in clinical wastes by using supercritical carbon dioxide (SC-CO2). There were three types of solutions used including normal saline, seawater, distilled water, and physiological saline with 1% of methanol; each solution was tested at 5, 10, and 20 mL of the water contents. The experiments were conducted at the optimum operating parameters of supercritical carbon dioxide (30 MPa, 75 °C, 90 min). The results showed that the inactivation rate was more effective in distilled water with the presence of 1% methanol (6 log reductions). Meanwhile, the seawater decreases inactivation rate more than normal saline (4.5 vs. 5.1 log reduction). On the other hand, the experiments performed with different volumes of distilled water (5, 10, and 20 mL) indicated that A. niger spores were completely inactivated with 10 mL of distilled water. The inactivation rate of fungal spores decreased from 6 to 4.5 log as the amount of distilled water increased from 10 to 20 mL. The analysis for the spore morphology of A. fumigatus and Aspergillus spp. in section Nigri using scanning electron microscopy (SEM) has revealed the role of temperature and pressure in the SC-CO2 in the destruction of the cell walls of the spores. It can be concluded that the distilled water represent the best medium for inactivation of fungal spores in the clinical solid wastes by SC-CO2.

Glucosamine-containing supplement improves locomotor functions in subjects with knee pain - a pilot study of gait analysis.

BACKGROUND: Previously, we demonstrated that glucosamine-containing supplementation was effective for improving locomotor functions, especially walking speed. However, the biomechanical mechanism of efficacy has not been elucidated. This study aimed to address this challenge in subjects with knee pain, using a motion capture system. METHODS: An open label study was conducted in 30 Japanese subjects with knee pain. The subjects were administered a daily supplement containing 1,200 mg of glucosamine hydrochloride, 60 mg of chondroitin sulfate, 45 mg of type II collagen peptides, 90 mg of quercetin glycosides, 10 mg of imidazole peptides, 1 mg of proteoglycan, and 5 µg of vitamin D (GCQID). The intervention continued for 16 weeks. Efficacy for locomotor functions involving the knee joint was evaluated mainly using the Japanese Knee Osteoarthritis Measure (JKOM) and the 5-question Geriatric Locomotive Function Scale (GLFS-5). To examine the biomechanical mechanism of efficacy for locomotor functions, motions of subjects in a normal walking state were captured. Gait analysis was conducted and efficacy for gait parameters such as normal walking speed, stride length, cadence, and angle of soles was evaluated. RESULTS: GCQID significantly improved total scores on the JKOM and GLFS-5. In gait analysis, normal walking speed, stride length, and angle of soles at the end of the stance phase were all significantly increased, but cadence did not change significantly during the intervention period. There were significant intercorrelations of changes in normal walking speed, stride length, and angle of soles at the end of the stance phase, and between changes in stride length and total JKOM score. CONCLUSION: A GCQID supplement may increase walking speed through increased stride length and angle of kicking from the ground during steps, which might be mainly associated with alleviated knee pain.

Genetic, morphological, and virulence characterization of the entomopathogenic fungus Verticillium lecanii.

In order to clarify relationships among genetic diversity, virulence, and other characteristics of conidia, 46 isolates of Verticillium lecanii from various hosts and geographical locations were examined. The internal transcribed spacer (ITS) and intergenic spacer (IGS) regions of ribosomal DNA (rDNA), mitochondrial small subunit rDNA (mt-SrDNA) and beta-tubulin were analyzed by PCR-RFLP. PCR-single stranded conformational polymorphism (SSCP) was performed on regions of the mitochondrial large subunit rDNA, mt-SrDNA, beta-tubulin and histone 4. There were no relationships among the results of RFLP, SSCP, isolation source, and location. However, amplified product size of IGS did have relationships with conidia size and sporulation. Six isolates with 4.0-kb IGS products had large conidia dimensions, and yielded low numbers of conidia compared with other isolates. Three out of the six isolates were high virulence (over 90%) against green peach aphids. Furthermore, double-stranded RNA (dsRNA) was detected in 22 out of 35 V. lecanii isolates and related with the amplicon sizes of IGS, though not with virulence or isolation location. Isolates containing dsRNA were divided into six distinct types based on banding pattern. These data demonstrate the level of genetic diversity of V. lecanii, and suggest relations among the genetic properties and conidial morphology.

The genus Thecotheus (Pezizales) in Australia: T. urinamans sp. nov. from urea-treated jarrah (Eucalyptus marginata) forest.

The genus Thecotheus is reported in Australia for the first time. A new species, Thecotheus urinamans is described and illustrated and included in a key to all known species of the genus. Critical macro- and micromorphological comparisons are presented to distinguish the new species from several closely related species, particularly the widespread fungus Thecotheus crustaceus. Thecotheus urinamans was growing on rotting, moist, plant litter from an experimental plot treated with urea (ammonia) in the indigenous jarrah (Eucalyptus marginata) forest of Western Australia.