Effects of Processing-Induced Contamination on Organic Electronic Devices.

Organic semiconductors are a family of pi-conjugated compounds used in many applications, such as displays, bioelectronics, and thermoelectrics. However, their susceptibility to processing-induced contamination is not well understood. Here, it is shown that many organic electronic devices reported so far may have been unintentionally contaminated, thus affecting their performance, water uptake, and thin film properties. Nuclear magnetic resonance spectroscopy is used to detect and quantify contaminants originating from the glovebox atmosphere and common laboratory consumables used during device fabrication. Importantly, this in-depth understanding of the sources of contamination allows the establishment of clean fabrication protocols, and the fabrication of organic field effect transistors (OFETs) with improved performance and stability. This study highlights the role of unintentional contaminants in organic electronic devices, and demonstrates that certain stringent processing conditions need to be met to avoid scientific misinterpretation, ensure device reproducibility, and facilitate performance stability. The experimental procedures and conditions used herein are typical of those used by many groups in the field of solution-processed organic semiconductors. Therefore, the insights gained into the effects of contamination are likely to be broadly applicable to studies, not just of OFETs, but also of other devices based on these materials.

Transmission-based charge modulation microscopy on conjugated polymer blend field-effect transistors.

Charge modulation microscopy (CMM) is an electro-optical method that is capable of mapping the spatial distribution of induced charges in an organic field-effect transistor (OFET). Here, we report a new (and simple) implementation of CMM in transmission geometry with camera-based imaging. A significant improvement in data acquisition speed (by at least an order of magnitude) has been achieved while preserving the spatial and spectral resolution. To demonstrate the capability of the system, we measured the spatial distribution of the induced charges in an OFET with a polymer blend of indacenodithiophene-co-benzothiadiazole and poly-vinylcarbazole that shows micrometer-scale phase separation. We were able to resolve spatial variations in the accumulated charge density on a length scale of 500 nm. We demonstrated through a careful spectral analysis that the measured signal is a genuine charge accumulation signal that is not dominated by optical artifacts.

Improving OFF-State Bias-Stress Stability in High-Mobility Conjugated Polymer Transistors with an Antisolvent Treatment.

Conjugated polymer field-effect transistors are emerging as an enabling technology for flexible electronics due to their excellent mechanical properties combined with sufficiently high charge-carrier mobilities and compatibility with large-area, low-temperature processing. However, their electrical stability remains a concern. ON-state (accumulation mode) bias-stress instabilities in organic semiconductors have been widely studied, and multiple mitigation strategies have been suggested. In contrast, OFF-state (depletion mode) bias-stress instabilities remain poorly understood despite being crucial for many applications in which the transistors are held in their OFF-state for most of the time. Here, a simple method of using an antisolvent treatment is presented to achieve significant improvements in OFF-state bias-stress and environmental stability as well as general device performance for one of the best performing polymers, solution-processable indacenodithiophene-co-benzothiadiazole (IDT-BT). IDT-BT is weakly crystalline, and the notable improvements to an antisolvent-induced, increased degree of crystallinity, resulting in a lower probability of electron trapping and the removal of charge traps is attributed. The work highlights the importance of the microstructure in weakly crystalline polymer films and offers a simple processing strategy for achieving the reliability required for applications in flexible electronics.

Charge transport physics of a unique class of rigid-rod conjugated polymers with fused-ring conjugated units linked by double carbon-carbon bonds.

We investigate the charge transport physics of a previously unidentified class of electron-deficient conjugated polymers that do not contain any single bonds linking monomer units along the backbone but only double-bond linkages. Such polymers would be expected to behave as rigid rods, but little is known about their actual chain conformations and electronic structure. Here, we present a detailed study of the structural and charge transport properties of a family of four such polymers. By adopting a copolymer design, we achieve high electron mobilities up to 0.5 cm2 V-1 s-1 Field-induced electron spin resonance measurements of charge dynamics provide evidence for relatively slow hopping over, however, long distances. Our work provides important insights into the factors that limit charge transport in this unique class of polymers and allows us to identify molecular design strategies for achieving even higher levels of performance.

Optical and Electronic Properties of Colloidal CdSe Quantum Rings.

Luminescent colloidal CdSe nanorings are a recently developed type of semiconductor structure that have attracted interest due to the potential for rich physics arising from their nontrivial toroidal shape. However, the exciton properties and dynamics of these materials with complex topology are not yet well understood. Here, we use a combination of femtosecond vibrational spectroscopy, temperature-resolved photoluminescence (PL), and single-particle measurements to study these materials. We find that on transformation of CdSe nanoplatelets to nanorings, by perforating the center of platelets, the emission lifetime decreases and the emission spectrum broadens due to ensemble variations in the ring size and thickness. The reduced PL quantum yield of nanorings (∼10%) compared to platelets (∼30%) is attributed to an enhanced coupling between (i) excitons and CdSe LO-phonons at 200 cm-1 and (ii) negatively charged selenium-rich traps, which give nanorings a high surface charge (∼-50 mV). Population of these weakly emissive trap sites dominates the emission properties with an increased trap emission at low temperatures relative to excitonic emission. Our results provide a detailed picture of the nature of excitons in nanorings and the influence of phonons and surface charge in explaining the broad shape of the PL spectrum and the origin of PL quantum yield losses. Furthermore, they suggest that the excitonic properties of nanorings are not solely a consequence of the toroidal shape but also a result of traps introduced by puncturing the platelet center.