RESUMEN
The design and fabrication of lithium secondary batteries with a high energy density and shape flexibility are essential for flexible and wearable electronics. In this study, we fabricated a high-voltage (5 V class) flexible lithium polymer battery using a lithium nickel manganese oxide (LiNi0.5Mn1.5O4) cathode. A LiNi0.5Mn1.5O4-hybridized gel polymer cathode (GPC) and a gel polymer electrolyte (GPE) membrane, both containing a sulfolane (SL)-based highly concentrated electrolyte (HCE), enabled the fabrication of a polymer battery by simple lamination with a metallic lithium anode, where the injection of the electrolyte solution was not required. GPC with high flexibility has a hierarchically continuous three-dimensional porous architecture, which is advantageous for forming continuous ion-conduction paths. The GPE membrane has significant ionic conductivity enough for reliable capacity delivery. Therefore, the fabricated lithium polymer pouch cells demonstrated excellent capacity retention under continuous deformation conditions. This study provides a promising strategy for the fabrication of scalable and flexible 5 V class batteries using GPC and GPE containing SL-based HCE.
RESUMEN
Flexible solid-state electrolyte membranes are beneficial for feasible construction of solid-state batteries. In this study, a flexible composite electrolyte was prepared by combining a Li+-ion-conducting solid electrolyte Li1.5Al0.5Ti1.5(PO4)3 (LATP) and a poly(vinylidene fluoride-co-hexafluoropropylene) (PVDF-HFP) gel containing a highly concentrated electrolyte of Li[N(SO2CF3)2] (LiTFSA)/sulfolane using a solution casting method. We successfully demonstrated the operation of Li/LiCoO2 cells with the composite electrolyte; however, the rate capability of the cell degraded with increasing LATP content. We investigated the Li-ion transport properties of the composite electrolyte and found that the gel formed a continuous phase in the composite electrolyte and Li-ion conduction mainly occurred in the gel phase. Solid-state 6Li magic-angle spinning NMR measurements for LATP treated with the 6LiTFSA/sulfolane electrolyte suggested that the Li+-ion exchange occurred at the interface between LATP and 6LiTFSA/sulfolane. However, the kinetics of Li+ transfer at the interface between LATP and the PVDF-HFP gel was relatively slow. The interfacial resistance of LATP/gel was evaluated to be 67 Ω·cm2 at 30 °C, and the activation energy for interfacial Li+ transfer was 39 kJ mol-1. The large interfacial resistance caused the less contribution of LATP particles to the Li-ion conduction in the composite electrolyte.
RESUMEN
In this work, bismuth sodium titanate, Bi0.5±xNa0.5±yTiO3 (BNT, x, y = -0.05-0.08) nanopowders were produced using the low-temperature sol-gel technique. The effects of deficient and excess amounts of Bi and Na on BNT structure were systemically examined through X-ray powder diffraction (XRD), energy dispersive analysis (EDS) and scanning electron microscope (SEM). The optimized composition of the BNT nanopowder was pelletized and sintered at different temperatures (950°C-1150 °C). Highly dense ceramics possessing pure perovskite phase was observed for the sample sintered at an optimum sintering temperature (1100 °C). The ferroelectric properties were found to increase with an increase in sintering temperature up to 1100 °C and then decrease. This study justifies that Bi and Na non-stoichiometry (proper excess), processing and sintering temperatures play important role in the successful synthesis of BNT ceramics.