Effect of Reducing Agent on Solution Synthesis of Li3V2(PO4)3 Cathode Material for Lithium Ion Batteries.

In this study, Li3V2(PO4)3 (LVP) powders are prepared by a solution synthesis method. The effects of two reducing agents on crystal structure and morphology and electrochemical properties are investigated. Preliminary studies on reducing agents such as oxalic acid and citric acid, are used to reduce the vanadium (V) precursor. The oxalic acid-assisted synthesis induces smaller particles (30 nm) compared with the citric acid-assisted synthesis (70 nm). The LVP powders obtained by the oxalic acid exhibit a higher specific capacity (124 mAh g-1 at 1C) and better cycling performance (122 mAh g-1 following 50 cycles at 1C rate) than those for the citric acid. This is due to their higher electronic conductivity caused by carbon coating and downsizing the particles. The charge-discharge plateaus obtained from cyclic voltammetry are in good agreement with galvanostatic cycling profiles.

Imaging of soft material with carbon nanotube tip using near-field scanning microwave microscopy.

In this manuscript, a near-field scanning microwave microscope (NSMM) of our own design is introduced while using a multi-walled carbon nanotube (MWCNT) bundle as the tip (referred to as 'CNT tip'). Clear images of gold-patterned numbers, photoresist stripes and corneal endothelial cells (cell line B4G12) were obtained by mapping the resonant frequency fr and S11 amplitude of a given area while the NSMM is operating in tapping mode. The CNT tip helps to improve image quality and reveals more information about the sample as compared to a traditional metallic tip. The CNT tip is flexible and does not scratch the surface of the sample during the scan, which is useful for imaging soft material in biological science. In the imaging of the B4G12 endothelial cells, the nuclei and cytoplasm can be clearly distinguished from the rest of the cell and its surrounding medium.

Super-resolution coherent anti-Stokes Raman scattering microscopy with photonic nanojets.

We demonstrate far-field super-resolution coherent anti-Stokes Raman scattering (CARS) microscopy by exciting the sample with photonic nanojets. The sub-diffraction photonic nanojets were formed on the surface of the sample by microspheres illuminated by laser beams, and images were acquired by a standard laser-scanning CARS microscope. When the laser beams were focused on the microspheres, the photonic nanojets determined the excitation volume instead of the diffraction-limited laser foci, leading to super-resolution. We imaged the sub-diffraction features of a Blu-ray disc using glass spheres with a refractive index of 1.46 and diameters in the 1-6 µm range. The microspheres provided a lateral magnification factor up to 5.0X and a lateral resolution of at least 200 nm at 796 nm laser wavelength, allowing us to resolve the features on the disc which were invisible under normal CARS imaging. The magnification factor depended on both the microsphere size and the focal plane position of the incident beams. To explain the magnification factor we performed theoretical simulations which showed excellent agreement with experimental results. This super-resolution technique could be very useful for the vibrational imaging of nano-scale objects on films and surfaces.

Lithium storage properties of pristine and (Mg, Cu) codoped ZnFe2O4 nanoparticles.

ZnFe2O4 and MgxCu0.2Zn0.82-xFe1.98O4 (where x = 0.20, 0.25, 0.30, 0.35, and 0.40) nanoparticles were synthesized by sol-gel assisted combustion method. X-ray diffraction (XRD), FTIR spectroscopy, Raman spectroscopy, scanning electron microscopy (SEM), transmission electron microscopy (TEM), and Brunauer-Emmett-Teller (BET) surface area studies were used to characterize the synthesized compounds. ZnFe2O4 and the doped compounds crystallize in Fd3m space group. The lattice parameter of ZnFe2O4 is calculated to be a = 8.448(3) Å, while the doped compounds show a slight decrease in the lattice parameter with an increase in the Mg content. The particle size of all the compositions are in the range of ∼50-80 nm, and the surface area of the compounds are in the range of 11-12 m(2) g(-1). Cyclic voltammetry (CV), galvanostatic cycling, and electrochemical impedance spectroscopy (EIS) studies were used to investigate the electrochemical properties of the different compositions. The as-synthesized samples at 600 °C show large-capacity fading, while the samples reheated at 800 °C show better cycling stability. ZnFe2O4 exhibits a high reversible capacity of 575 mAh g(-1) after 60 cycles at a current density of 100 mA g(-1). Mg0.2Cu0.2Zn0.62Fe1.98O4 shows a similar capacity of 576 mAh g(-1) after 60 cycles with better capacity retention.

Broadband microwave Luneburg lens made of gradient index metamaterials.

Luneburg lenses are able to form perfect focus that is free of aberration. Because of the varying refractive index throughout the lens, incoming electromagnetic waves can travel in a curved path and be guided to focus at the back of the lens. The implementation of Luneburg lenses is often difficult due to the challenges in creating a medium with varying refractive index using normal materials. This problem can be overcome with the use of gradient index metamaterials. We report a two dimensional Luneburg lens made of gradient index metamaterials. It consists of 17 concentric shells with etched patterns on a printed circuit board working in microwave X band frequency. The broad properties of the Luneburg lens are then discussed.

Tailoring wettability change on aligned and patterned carbon nanotube films for selective assembly.

The effects of oxygen reactive ion etching (RIE) on the surface wettability of aligned carbon nanotube (CNT) films have been systematically investigated. It was found that 3 s of RIE treatment could change the surface of CNT films from hydrophobic to more hydrophilic. The degree of modification in the surface wettability of the film could be controlled by the flow rate of O2 gas during the RIE process. It is proposed that such a surface hydrophobicity change is related to the opened structure and functionalized tip of as-treated CNTs by oxygen reactive ions. More importantly, after the RIE treatment, focused laser pruning was utilized to trim the surface layer of treated CNTs and revert them back to a hydrophobic surface. Combined with the laser pruning technique and O2 RIE treatment, CNT templates with interlaced wettability surfaces in a stripe pattern have been fabricated. It has been demonstrated that this interlaced and structured wettability pattern can be used to selectively assemble microspheres or quantum dots on the aligned CNT films with desired patterns.