MiRNA-4537 functions as a tumor suppressor in gastric cancer and increases the radiosensitivity of gastric cancer cells.

Radiotherapy is a common method to treat gastric cancer (GC). However, the clinical outcomes of GC radiotherapy face challenges, and the mechanisms of GC radioresistance remain unclear. Our study aimed to investigate the role and mechanism of miR-4537 in the radiation sensitivity of GC cells. Cell viability was determined by Cell Counting Kit-8. The proliferation of HGC27 and KATO III cells was measured using a colony formation assay. Flow cytometry was performed to examine the changes in cell apoptosis. Western blotting was conducted to detect the expression of zinc finger protein 587 (ZNF587) protein in HGC27 and KATO III cells. To confirm the relationship between miR-4537 and ZNF587, a luciferase reporter assay was performed. MiR-4537 was downregulated in GC tumors and cells and suppressed cell proliferation, while promoting cell apoptosis in GC. Importantly, we found that miR-4537 reduced the radioresistance of GC cells. In addition, we also confirmed that miR-4537 expression is negatively correlated with ZNF587 expression in GC tissues. MiR-4537 bound to ZNF587 and suppressed the expression level of ZNF587. Overexpression of ZNF587 partially counteracted the effects of miR-4537 on cell proliferation and apoptosis. In conclusion, in GC cells, miR-4537 inhibited the ability of cell proliferation, but on the contrary, it promoted the ability of cell apoptosis and improved radiosensitivity of the cells.

[Accuracy of 6D computed-derived implant guides made in China for dental implant surgery in edentulous patients].

PURPOSE: To evaluate the accuracy of 6D computed-derived implant guides made in China, in order to provide methods and basis for reducing deviation. METHODS: 3D rapid prototyping technique was used to fabricate implant guides for auxiliary surgical implantation in edentulous patients, and the position deviation between the preoperative design and the actual implant was measured. Sixteen edentulous patients with 172 implantation sites were measured. In 10 patients, six implants were implanted in the maxilla, 4 implants in the mandible, and 6 implants were implanted both in the maxilla and mandible of 6 patients. A total of 28 implants were tilted implant in 14 patients. Preoperative cone-beam CT(CBCT) data were imported into the 6D Dental Planning Software to design and make the implant guides. Digital guides were used to assist implant placement. Preoperative design and postoperative CBCT were imported into the software for 3D reconstruction and registration, and then exported to Geomagic Studio software for analysis to obtain the deviation between the preoperative design and the implantation, so as to analyze the accuracy of the guides. The differences were analyzed by SPSS 25.0 software package with paired t-test and single factor analysis of variance. RESULTS: The distance deviation of implant neck center point was (0.83±0.27) mm and the horizontal deviation was (0.60±0.21) mm. The distance deviation of implant bottom center point was (1.11±0.35) mm, and the vertical deviation was (0.45±0.19) mm. The angle deviation was (3.16±1.73)°. CONCLUSIONS: The 6D computed-derived implant guides made in China can improve the accuracy and efficiency of implant surgery for edentulous patients and obtain a better long-term clinical effect to meet clinical requirements well. Since the deviation is similar to other implant guide plate systems that reported aborad, it must be taken into account in the process of clinical design, in order to avoid risks and unnecessary complications. This method is worthy of wide clinical application.