The new SQUID biosusceptometer at Oakland: first year of experience.

Liver iron measurements using biosusceptometers have been validated on two low-TC SQUID (Superconducting Quantum Interference Device) systems (New York and Hamburg) built in the 1980's. Recently, two new instruments have been installed in Torino, Italy (2001), and Oakland, California (2003). The design of the Oakland system is similar to those in Hamburg and Torino. Improvements were made to adjust for significant environmental noise, moreover, an active electronic noise cancellation, a computer controlled water coupling reference system using a pressure feedback and a faster data acquisition system using software lockin amplifiers have been implemented. All 3 systems (Hamburg, Torino, Oakland) are using the same standardized operational protocol. Presented herein are the data collected from 276 patients measured with the SQUID biosusceptometer at Oakland since installation. The results from 149 patients with beta-thalassemia (beta-Thal, age: 2-66 y), 76 patients with sickle-cell disease (SCD, age: 5-55 y), 35 patients with various rare diseases (RD, age: 2-80 y), and 16 patients with hereditary hemochromatosis (HHC, age: 6-74 y) are reported. The liver iron concentration in the different groups are 222 - 7570 (beta-Thal), 518 - 7918 (SCD), 511 - 6234 (RD), 258 - 2041 (HHC) microg/g-liver (in vivo wet weight). The long-term reproducibility (12 months) in a patient on constant treatment regimen demonstrated a mean liver iron of 1141 +/- 133 microg/g-liver. The new SQUID Ferritometer located on the US West coast will give more patients access to this non-invasive liver iron assessment.

HTS magnetometers for fetal magnetocardiography.

High temperature superconducting (HTS) SQUID sensors have adequate magnetic field sensitivity for adult magnetocardiography (MCG) measurements, but it remains to be seen how well they perform for fetal MCG (fMCG), where the heart signals are typically ten times smaller than the adult signals. In this study, we assess the performance of a prototype HTS SQUID system; namely, a three-SQUID gradiometer formed from three vertically-aligned HTS dc-SQUID magnetometers integrated into a fiberglass liquid nitrogen dewar of diameter 12.5 cm and height 30 cm. Axial gradiometers with short or long baseline, as well as a second order gradiometer, can be formed out of these magnetometers via electronic subtraction. The calibrated magnetometer sensitivities at 1 kHz are 109 fT/square root of Hz, 155 fT/square root of Hz and 51 fT/square root of Hz. Direct comparison is made between the HTS SQUID system and a LTS SQUID system by making recordings with both systems during the same session on adult and fetal subjects. Although the fMCG could be resolved with the HTS SQUID system in most near-term subjects, the signal-to-noise ratio was relatively low and the system could not be operated outside of a shielded room.

Some heat engine cycles in which liquids can work.

Liquids can work in heat engine cycles that employ regeneration. Four such cycles are discussed: Stirling, Malone, Stirling-Malone, and Brayton. Both regeneration and the role of the second thermodynamic medium are treated, and the principles are verified by quantitative measurements with propylene in a Stirling-Malone cycle.

Principles of liquids working in heat engines.

The thermodynamic and thermophysical properties of liquids suggest that they should be powerful working fluids in heat engines. Their use requires heat engines based conceptually on the Stirling and Malone principles. The principles are explained, and then experiments on propylene are presented that demonstrate the principles and confirm the thermodynamic analysis.

Superconducting switch for large heat flow below 50 mK.

We describe both the method of fabrication and the performance of a zinc superconducting heat switch used to couple thermally the mixing chamber of a dilution refrigerator and a nuclear demagnetization refrigerator.