RESUMEN
Oxygen-ion conductors have traditionally been studied in the context of high temperature (≈ 873 to 1773 K) energy conversion and sensor technologies. However, there is growing interest in exploring ion-based electronics for harsh environments (400 to 573 K) that represents an emerging field. Here, we utilize a blocking electrode to modify the interface properties of oxygen-ion conducting yttria-stabilized zirconia (YSZ) thin film electrochemical cells. The modified YSZ cell exhibits negative differential resistance (NDR) in the current-voltage curves at 543 K in the air. A double-sweep method and analysis of the scan-rate dependence of the j-V characteristics clearly suggest that the NDR behavior is formed by the reduction reaction of adsorbed oxygen or platinum oxide at the YSZ/Pt interface. A stable and switchable YSZ NDR device is realized with a high peak-to-valley current ratio of 5.8 at 543 K. Utilizing the NDR effect, we demonstrate a proof-of-concept switchable ternary inverter by interfacing with a silicon transistor. Oxygen-ion conductors and their interfaces offer new directions to design electronics for extreme environments.
RESUMEN
Ordering of ferroelectric polarization1 and its trajectory in response to an electric field2 are essential for the operation of non-volatile memories3, transducers4 and electro-optic devices5. However, for voltage control of capacitance and frequency agility in telecommunication devices, domain walls have long been thought to be a hindrance because they lead to high dielectric loss and hysteresis in the device response to an applied electric field6. To avoid these effects, tunable dielectrics are often operated under piezoelectric resonance conditions, relying on operation well above the ferroelectric Curie temperature7, where tunability is compromised. Therefore, there is an unavoidable trade-off between the requirements of high tunability and low loss in tunable dielectric devices, which leads to severe limitations on their figure of merit. Here we show that domain structure can in fact be exploited to obtain ultralow loss and exceptional frequency selectivity without piezoelectric resonance. We use intrinsically tunable materials with properties that are defined not only by their chemical composition, but also by the proximity and accessibility of thermodynamically predicted strain-induced, ferroelectric domain-wall variants8. The resulting gigahertz microwave tunability and dielectric loss are better than those of the best film devices by one to two orders of magnitude and comparable to those of bulk single crystals. The measured quality factors exceed the theoretically predicted zero-field intrinsic limit owing to domain-wall fluctuations, rather than field-induced piezoelectric oscillations, which are usually associated with resonance. Resonant frequency tuning across the entire L, S and C microwave bands (1-8 gigahertz) is achieved in an individual device-a range about 100 times larger than that of the best intrinsically tunable material. These results point to a rich phase space of possible nanometre-scale domain structures that can be used to surmount current limitations, and demonstrate a promising strategy for obtaining ultrahigh frequency agility and low-loss microwave devices.
RESUMEN
The crystallization of amorphous germanium telluride (GeTe) thin films is controlled with nanoscale resolution using the heat from a thermal AFM probe. The dramatic differences between the amorphous and crystalline GeTe phases yield embedded nanoscale features with strong topographic, electronic, and optical contrast. The flexibility of scanning probe lithography enables the width and depth of the features, as well as the extent of their crystallization, to be controlled by varying probe temperature and write speed. Together, these technologies suggest a new approach to nanoelectronic and opto-electronic device fabrication.
RESUMEN
We show how finite-size scaling of a bulk photovoltaic effect-generated electric field in epitaxial ferroelectric insulating BaTiO_{3}(001) films and a photo-Hall response involving the bulk photovoltaic current reveal a large room-temperature mean free path of photogenerated nonthermalized electrons. Experimental determination of mesoscopic ballistic optically generated carrier transport opens a new paradigm for hot electron-based solar energy conversion, and for facile control of ballistic transport distinct from existing low-dimensional semiconductor interfaces, surfaces, layers, or other structures.
