Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 2 de 2
Filtrar
Más filtros












Base de datos
Intervalo de año de publicación
1.
Sci Total Environ ; 938: 173609, 2024 Aug 15.
Artículo en Inglés | MEDLINE | ID: mdl-38815826

RESUMEN

Wastewater-Based Epidemiology (WBE) is widely used to monitor the progression of SARS-CoV-2 pandemic. While there is a clear correlation between the number of COVID patients in a sewershed and the viral load in the wastewater, there is notable variability across different treatment plants. In particular, some facilities consistently exhibit higher viral content per diagnosed patient, implying a potential underestimation of the number of COVID patients, while others show a low viral load per diagnosed case, indicating potential attenuation of genetic material from the sewershed. In this study, we investigated the impact of nonylphenol ethoxylate (NPHE), linear alkylbenzene sulfonic acid (LABS), bisoctyl dimethyl ammonium chloride (BDAC), and didecyldimethylammonium chloride (DDAC), the surfactants that have been commonly used as detergents, emulsifiers, wetting agents on the stability of SARS-CoV-2 in wastewater. The results showed multiple and dynamic mechanisms, including degradation and desorption, can occur simultaneously during the interaction between SARS-CoV-2 and different chemicals depending on the physicochemical properties of each chemical. Through the elucidation of the dynamic interactions, the findings from this study could help the state health organizations and scientific community to optimize the SARS-CoV-2 wastewater-based epidemiology strategies.


Asunto(s)
COVID-19 , SARS-CoV-2 , Aguas Residuales , Aguas Residuales/virología , Aguas Residuales/química , COVID-19/epidemiología , Adsorción , Tensoactivos , Pandemias , Cinética , Humanos , Eliminación de Residuos Líquidos/métodos , Monitoreo Epidemiológico Basado en Aguas Residuales , Contaminantes Químicos del Agua/análisis , Ácidos Alcanesulfónicos
2.
Mikrochim Acta ; 189(5): 174, 2022 04 02.
Artículo en Inglés | MEDLINE | ID: mdl-35366715

RESUMEN

A label-free molecular imprinted polymer (MIP) sensor was fabricated for the detection of progesterone in aqueous solutions, by polymerization inside the void spaces of colloidal crystals, which gave them photonic properties. The prepolymerization mixture was prepared from acrylic acid as the functional monomer, ethylene glycol as the cross-linker agent, ethanol as solvent, and progesterone as the imprinted template. After polymerization, the colloidal crystal was removed by acid etching and the target eluted with a solvent. Material characterization included as follows: attenuated total reflectance-Fourier-transform infrared spectroscopy, dynamic light scattering, swelling experiments, and environmental scanning electron microscopy. MIPs were investigated by equilibrium binding, kinetics experiments, and UV-visible spectra to investigate Bragg diffraction peak shift that occurs with the rebinding at different progesterone concentrations in deionized water and 150-mM NaCl solutions. The MIP response was investigated with progesterone concentration in the 1-100 µg L-1 range, with LOD of 0.5 µg L-1, reaching the detected range of hormone in natural waters. Furthermore, hydrogel MIP films were successfully tested in various real water matrices with satisfactory results. Moreover, the MIP film exhibited good selectivity toward the progesterone hormone evidenced by a larger response than when exposed to structurally similar molecules. Computational studies suggested that size along with surface potential influenced the binding of analog compounds. Due to their ease of use and low cost, the sensors are promising as screening tools for the presence of progesterone in aqueous samples.


Asunto(s)
Impresión Molecular , Impresión Molecular/métodos , Polímeros Impresos Molecularmente , Polímeros/química , Progesterona , Agua
SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA
...