RESUMEN
A software-defined optical receiver is implemented on an off-the-shelf commercial graphics processing unit (GPU). The receiver provides real-time signal processing functionality to process 1 GBaud minimum phase (MP) 4-, 8-, 16-, 32-, 64-, 128-ary quadrature amplitude modulation (QAM) as well as geometrically shaped (GS) 8- and 128-QAM signals using Kramers-Kronig (KK) coherent detection. Experimental validation of this receiver over a 91 km field-deployed optical fiber link between two Tokyo locations is shown with detailed optical signal-to-noise ratio (OSNR) investigations. A net data rate of 5 Gbps using 64-QAM is demonstrated.
RESUMEN
This work demonstrates the use of bidirectional Raman amplification to achieve an unrepeatered 234 km link using standard single mode fibers and with a capacity×distance product of 21.132 Pb/s·km. A throughput above 90 Tb/s is achieved with an 87 nm wavelength-division multiplexed signal carrying 424 PDM-64QAM signals at 24.5 GBaud across C and L bands. Transmission is supported using up to 12 Raman pumps per propagation direction, covering a wavelength range between 1410.8 nm and 1502.7 nm and with total power under 2.6 W.
RESUMEN
We investigate optical transmission of an ultra-wideband signal in a standard single mode fiber. Using a near continuous optical bandwidth exceeding 157â nm across the S-, C- and L-bands, we combine doped-fiber amplifiers covering S, C and L-bands with distributed Raman amplification to enable high-quality transmission of polarization division multiplexed (PDM)-256-quadrature-amplitude modulation (QAM) signals over a 54â km standard single-mode fiber. We receive 793 × 24.5 GBd signals from 1466.34â nm to 1623.57â nm and measure a data rate estimated from the generalized mutual information (GMI) of 256.4 Tb/s and an LDPC decoded throughput of 244.3 Tb/s. The measured data rates exceed the highest previously measured in a single mode fiber, showing the potential for S-band transmission to enhance achievable data rates in optical fibers.
RESUMEN
This work proposes an approach for the compensation of inter-core skew in homogeneous single-mode multi-core fiber links. We adjust the wavelengths of the transmitted spatial channels in such a way that the skew induced by group velocity counters inter-core skew. This approach is demonstrated experimentally using a 111 Gb/s spatial super channel (4 spatial channels at 27.8 Gb/s) on a 10.1 km 19-core multi-core fiber. It is shown that inter-core skew may be compensated without the need for devices such as variable optical delay lines or electronic buffers.
RESUMEN
Data rates in optical fiber networks have increased exponentially over the past decades and core-networks are expected to operate in the peta-bit-per-second regime by 2030. As current single-mode fiber-based transmission systems are reaching their capacity limits, space-division multiplexing has been investigated as a means to increase the per-fiber capacity. Of all space-division multiplexing fibers proposed to date, multi-mode fibers have the highest spatial channel density, as signals traveling in orthogonal fiber modes share the same fiber-core. By combining a high mode-count multi-mode fiber with wideband wavelength-division multiplexing, we report a peta-bit-per-second class transmission demonstration in multi-mode fibers. This was enabled by combining three key technologies: a wideband optical comb-based transmitter to generate highly spectral efficient 64-quadrature-amplitude modulated signals between 1528 nm and 1610 nm wavelength, a broadband mode-multiplexer, based on multi-plane light conversion, and a 15-mode multi-mode fiber with optimized transmission characteristics for wideband operation.
RESUMEN
This work compares the random time-varying crosstalk in homogeneous multi-core fibers measured using different types of light sources with linewidths ranging from 100 Hz to 2.5 MHz. We show that the frequency stability of the light source plays a significant role on the quality of short-term average crosstalk measurements with no observable impact from laser linewidth. We also compare the use of filtered amplified spontaneous emission noise and coherent light sources for crosstalk measurements. The former are shown to enable average crosstalk measurements in short time periods. In contrast, measurements using coherent light sources require long measurement periods to reach similar results.
RESUMEN
Transmission of highly spectral efficient 24.5 GBaud quadrature phase shift keying and 16- and 64-quadrature amplitude modulated signals in the S-band between 1492 nm and 1518 nm wavelength is demonstrated over 55 km few-mode fibers. The carrier lines for S-band transmission were generated by a single wideband optical comb source with more than 120 nm optical bandwidth. While the three-mode fiber was originally optimized for C- and L-band transmission, we show that differential mode delay and mode-dependent loss show only a minor wavelength dependence within the measured S-band channels. However, the transceiver sub-system, including S-band optical amplifiers as well as a reduced optical signal-to-noise ratio of the comb source, leads to a significant Q-factor penalty for channels towards the edges of the S-band optical amplifiers below 1495 nm and above 1515 nm wavelength.
RESUMEN
We propose and evaluate a method to estimate the DC bias required for AC-coupled Kramers-Kronig receivers. The proposed method is based on a spectral analysis of the reconstructed signal without requiring an evaluation of the signal quality. The proposed method is described analytically and demonstrated experimentally using 12.5 GBaud 16-ary quadrature-amplitude modulated signals in back-to-back and after 100 km transmission.
RESUMEN
Master-slave carrier recovery is a digital signal processing technique that uses correlated phase noise in multi-channel receivers to eliminate redundant carrier recovery blocks. In this paper we experimentally investigate the performance of master-slave carrier recovery for multicore fiber transmission in the presence of inter-channel nonlinear interference. Using a triple parallel loop setup we jointly receive three spatial channels in a 7-core fiber for transmission distances of up to 1600 km. We find that an increased launch power causes a moderate penalty on the slave channels. Furthermore, we study the penalty from a non-zero inter-core skew.
RESUMEN
We propose and evaluate the use of spatial-division multiplexing (SDM) multiple input multiple output (MIMO) systems to support long distance transmission using single-mode homogeneous multicore fibers. We show that on a uniform link with per-span inter-core skew compensation, the required SDM-MIMO memory length corresponds to the largest inter-core skew per span on the link. Furthermore, we show that with inter-core skew compensation, the required memory length of the SDM-MIMO is nearly constant with the transmission distance for accumulated crosstalk below -11 dB. We experimentally demonstrate the use of SDM-MIMO with a memory length of 20 ns on a long distance transmission link using 20 GBaud PDM-QPSK signals. We achieve a reach of 9780 km, which corresponds to a 9% improvement over the case without SDM-MIMO. We also show that the use of SDM-MIMO is applicable to the transmission of signals with higher modulation order, achieving transmission reach improvements of 14% for 20 GBaud PDM-16QAM and PDM-64QAM signals.
RESUMEN
Inter-core crosstalk is a potential limitation on the achievable data-rates in optical fiber transmission systems using multi-core fibers. Crosstalk arises from unwanted coupling between cores of a homogenous multi-core fiber and it's average power has been observed to vary over time by 10s of decibels, potentially requiring an additional performance margin to achieve acceptable outage probability. Most investigations of crosstalk have so far only considered continuous wave laser light or amplified spontaneous emission as sources of crosstalk. In this paper, we theoretically and experimentally investigate the time-dependence of inter-core crosstalk in a homogeneous multi-core fiber when considering signals with various modulation formats and symbol rates. We find that crosstalk power fluctuations depend on the symbol rate, modulation and skew between cores. For carrier-free signals, such as quadrature amplitude modulation, the crosstalk power is nearly constant for expected conditions of multi-core transmission systems. However, carrier-supported signals, such as OOK, always induce time-varying crosstalk powers.
RESUMEN
We analyze the impact of Differential Mode Delay (DMD) Management on the nonlinear impairments in mode-division multiplexed transmission systems. It is found out that DMD Management can lead to a degraded performance, due to enhanced intermodal nonlinear interaction. This can be attributed to an increased correlation of co-propagating channels, similar to the effects that show up in dispersion managed single-mode systems.
RESUMEN
We show that Kerr nonlinearity induced intermodal power transfer in a particular mode group of a multimode fiber can be formulated by the same type of equation used to describe the effect of cross polarization modulation in single-mode fibers.
