Municipal Solid and Plastic Waste Co-pyrolysis Towards Sustainable Renewable Fuel and Carbon Materials: A Comprehensive Review.

This review tackles the challenges of worldwide waste management, focusing on renewable and sustainable fuels and waste recycling through the exploration of co-pyrolysis as an innovative method. It explores the characteristics and environmental impact of municipal solid waste (MSW) and plastic waste (PW), delving into pyrolysis fundamentals, processes, and challenges. The primary emphasis is on co-pyrolysis, elucidating its integration of municipal and plastic waste, synergistic effects, and advantages. The manuscript thoroughly analyzes reaction kinetics, thermodynamics, and the feasibility of co-pyrolysis for energy recovery. It also delves into the synthesis of renewable fuels and valuable chemical intermediates, considering optimization of product distribution. Environmental and economic sustainability aspects, including impact assessment, greenhouse gas emissions, life cycle analysis, and cost analysis of co-pyrolysis processes, are comprehensively investigated. The review underscores the economic benefits of renewable fuel and chemical materials synthesis. The conclusion addresses challenges, proposes future directions, outlines limitations, technical challenges, environmental considerations, and recommends further exploration and integration with other waste management techniques.

Comparative evaluation of low-cost ceramic membrane and polymeric micro membrane in algal membrane photobioreactor for wastewater treatment.

Algal-bacterial membrane photobioreactor (AMPBR) is proven as a highly energy-efficient process for treating domestic wastewater. This study compared the application of polymeric micro-membrane (PMM) and a low-cost ceramic membrane (LCM) to the AMPBR process for treating domestic wastewater with low and high organic pollution levels. Experiments were conducted over 57 days using two PMM-AMPBRs and two LCM-AMPBRs, operating on a 12-h dark/light cycle in a continuous mode. Simulated wastewater containing varying levels of chemical oxygen demand (COD) was fed to reactors for a consistent hydraulic residence time (HRT) of 7 d and a flux rate of 100 L/m2/d. PMM and LCM-AMPBRs demonstrated efficient wastewater treatment capabilities, achieving COD removal rates exceeding 94% and 95% for high and low COD loadings, respectively. PMM-AMPBR achieved 54.1% TN removal at low COD loading, while LCM-AMPBR achieved 57.2%. These removal efficiencies decreased to 45.6% and 47.0% under high COD loading. Total Phosphorus (TP) removal reached 29-33% for PMM-AMPBRs and 21-24% for LCM-AMPBRs, irrespective of COD loading. LCM-AMPBRs showed significantly lower fouling frequency than PMM-AMPBRs. The biomass production rate decreased with increasing COD loading and achieved 40 mg/L/d at low COD loading for both AMPBRs. Net energy return (NER) values for both AMPBRs were close to 0.87, indicating them as energy-efficient processes. Considering the cost-effectiveness and comparable performance, LCM-AMPBR could be a viable alternative to PMM-AMPBR for wastewater treatment, particularly under low COD loading conditions.

Assessment of CO2 biofixation and bioenergy potential of microalga Gonium pectorale through its biomass pyrolysis, and elucidation of pyrolysis reaction via kinetics modeling and artificial neural network.

This study investigates CO2 biofixation and pyrolytic kinetics of microalga G. pectorale using model-fitting and model-free methods. Microalga was grown in two different media. The highest rate of CO2 fixation (0.130 g/L/day) was observed at a CO2 concentration of 2%. The pyrokinetics of the biomass was performed by a thermogravimetric analyzer (TGA). Thermogravimetric (TG) and derivative thermogravimetric (DTG) curves at 5, 10 and 20°C/min indicated the presence of multiple peaks in the active pyrolysis zones. The activation energy was calculated by different model-free methods such as Friedman, Flynn-Wall-Ozawa (FWO), Kissinger-Akahira-Sunose (KAS), and Popescu. The obtained activation energy which are 61.7-287 kJ/mol using Friedman, 40.6-262 kJ/mol using FWO, 35-262 kJ/mol using KAS, and 66.4-255 kJ/mol using Popescu showed good agreement with the experimental values with higher than 0.96 determination coefficient (R2). Moreover, it was found that the most probable reaction mechanism for G. pectorale pyrolysis was a third-order function. Furthermore, the multilayer perceptron-based artificial neural network (MLP-ANN) regression model of the 4-10-1 architecture demonstrated excellent agreement with the experimental values of the thermal decomposition of the G. pectoral. Therefore, the study suggests that the MLP-ANN regression model could be utilized to predict thermogravimetric parameters.

Characterisation and microbial community analysis of lipid utilising microorganisms for biogas formation.

In the anaerobic process, fat-oil-grease (FOG) is hydrolysed to long-chain fatty acids (LCFAs) and glycerol (GLYC), which are then used as substrates to produce biogas. The increase in FOG and LCFAs inhibits methanogenesis, and so far, most work investigating this inhibition has been carried out when FOG or LCFAs were used as co-substrates. In the current work, the inhibition of methanogenesis by FOG, LCFAs and GLYC was investigated when used as sole substrates. To gain more insight on the dynamics of this process, the change of microbial community was analysed using 16S rRNA gene amplicon sequencing. The results indicate that, as the concentrations of cooking olive oil (CO, which represents FOG) and LCFAs increase, methanogenesis is inhibited. For instance, at 0.01 g. L-1 of FOG, the rate of biogas formation was around 8 ml.L-1.day-1, and this decreased to <4 ml.L-1.day-1 at 40 g.L-1. Similar results were observed with the use of LCFAs. However, GLYC concentrations up to 100g.L-1 did not affect the rate of biogas formation. Acidic pH, temperature > = 45°C and NaCl > 3% led to a significant decrease in the rate of biogas formation. Microbial community analyses were carried out from samples from 3 different bioreactors (CO, OLEI and GLYC), on day 1, 5 and 15. In each bioreactor, microbial communities were dominated by Proteobacteria, Firmicutes and Bacteroidetes phyla. The most important families were Enterobacteriaceae, Pseudomonadaceae and Shewanellaceae (Proteobacteria phylum), Clostridiacea and Ruminococcaceae (Firmicutes) and Porphyromonadaceae and Bacteroidaceae (Bacteroidetes). In CO bioreactor, Proteobacteria bacteria decreased over time, while those of OLEI and GLYC bioreactors increased. A more pronounced increase in Bacteroidetes and Firmicutes were observed in CO bioreactor. The methanogenic archaea Methanobacteriaceae and Methanocorpusculaceae were identified. This analysis has shown that a set of microbial population is selected as a function of the substrate.

Bioaugmentation: An Emerging Strategy of Industrial Wastewater Treatment for Reuse and Discharge.

A promising long-term and sustainable solution to the growing scarcity of water worldwide is to recycle and reuse wastewater. In wastewater treatment plants, the biodegradation of contaminants or pollutants by harnessing microorganisms present in activated sludge is one of the most important strategies to remove organic contaminants from wastewater. However, this approach has limitations because many pollutants are not efficiently eliminated. To counterbalance the limitations, bioaugmentation has been developed and consists of adding specific and efficient pollutant-biodegrading microorganisms into a microbial community in an effort to enhance the ability of this microbial community to biodegrade contaminants. This approach has been tested for wastewater cleaning with encouraging results, but failure has also been reported, especially during scale-up. In this review, work on the bioaugmentation in the context of removal of important pollutants from industrial wastewater is summarized, with an emphasis on recalcitrant compounds, and strategies that can be used to improve the efficiency of bioaugmentation are also discussed. This review also initiates a discussion regarding new research areas, such as nanotechnology and quorum sensing, that should be investigated to improve the efficiency of wastewater bioaugmentation.