Nutritional Management of Patients With Enterocutaneous Fistulas: Practice and Progression.

The management of enterocutaneous fistulas (ECF) can be challenging because of massive fluid loss, which can lead to electrolyte imbalance, severe dehydration, malnutrition and sepsis. Nutritional support plays a key role in the management and successful closure of ECF. The principle of nutritional support for patients with ECF should be giving enteral nutrition (EN) priority, supplemented by parenteral nutrition if necessary. Although total parenteral nutrition (TPN) may be indicated, use of enteral feeding should be advocated as early as possible if patients are tolerant to it, which can protect gut mucosal barrier and prevent bacterial translocation. A variety of methods of enteral nutrition have been developed such as fistuloclysis and relay perfusion. ECF can also be occluded by special devices and then EN can be implemented, including fibrin glue application, Over-The-Scope Clip placement and three-dimensional (3D)-printed patient-personalized fistula stent implantation. However, those above should not be conducted in acute fistulas, because tissues are edematous and perforation could easily occur.

Current progress of source control in the management of intra-abdominal infections.

Intra-abdominal infection (IAI) is a deadly condition in which the outcome is associated with urgent diagnosis, assessment and management, including fluid resuscitation, antibiotic administration while obtaining further laboratory results, attaining precise measurements of hemodynamic status, and pursuing source control. This last item makes abdominal sepsis a unique treatment challenge. Delayed or inadequate source control is an independent predictor of poor outcomes and recognizing source control failure is often difficult or impossible. Further complicating issue in the debate is surrounding the timing, adequacy, and procedures of source control. This review evaluated and summarized the current approach and challenges in IAI management, which are the future research directions.

Application of a 3D-printed "fistula stent" in plugging enteroatmospheric fistula with open abdomen: A case report.

BACKGROUND: Open abdomen (OA) has been generally accepted for its magnificent superiority and effectiveness in patients with severe trauma, severe intra-abdominal infection, and abdominal compartment syndrome. In the meantime, OA calls for a mass of nursing and the subsequent enteroatomospheric fistula (EAF), which is one of the most common complications of OA therapy, remains a thorny challenge. CASE SUMMARY: Our team applied thermoplastic polyurethane as a befitting material for producing a 3D-printed "fistula stent" in the management of an EAF patient, who was initially admitted to local hospital because of abdominal pain and distension and diagnosed with bowel obstruction. After a series of operations and OA therapy, the patient developed an EAF. CONCLUSION: Application of this novel "fistula stent" resulted in a drastic reduction in the amount of lost enteric effluent and greatly accelerated rehabilitation processes.

Impaired Coagulation Status in the Crohn's Disease Patients Complicated with Intestinal Fistula.

BACKGROUND: Intestinal fistula is one of the common complications of Crohn's disease (CD) that might require surgical treatment. The clinical characteristics and outcomes of CD with intestinal fistula are much different from CD alone. This study was to investigate whether the coagulation status of CD is changed by intestinal fistula. METHODS: Data were retrospectively analyzed for 190 patients with a definitive diagnosis of CD who were registered at the Jinling Hospital between January 2014 and September 2015. Baseline clinical characteristics and laboratory indices of initial admission and 7 days after intestinal fistula resections were collected. Student's t-test and the Wilcoxon rank-sum test were used to compare differences between the two groups. RESULTS: Compared with CD patients without intestinal fistula, prothrombin time (PT) in patients with intestinal fistula was significantly longer (12.13 ± 1.27 s vs. 13.18 ± 1.51 s, P < 0.001 in overall cohort; 11.56 ± 1.21 s vs. 12.61 ± 0.73 s, P = 0.001 in females; and 12.51 ± 1.17 s vs. 13.37 ± 1.66 s, P = 0.003 in males). Platelet (PLT) count was much lower in intestinal fistula group than in nonintestinal fistula group (262.53 ± 94.36 × 109/L vs. 310.36 ± 131.91 × 109/L, P = 0.009). Multivariate logistic regression showed that intestinal fistula was significantly associated with a prolonged PT (odds ratio [OR] = 1.900, P < 0.001), a reduced amount of PLT (OR = 0.996, P = 0.024), and an increased operation history (OR = 5.408, P < 0.001). Among 65 CD patients receiving intestinal fistula resections, PT was obviously shorter after operation than baseline (12.28 ± 1.16 s vs. 13.02 ± 1.64 s, P = 0.006). CONCLUSIONS: Intestinal fistula was significantly associated with impaired coagulation status in patients complicated with CD. Coagulation status could be improved after intestinal fistula resections.

3D-printed "fistula stent" designed for management of enterocutaneous fistula: An advanced strategy.

Enterocutaneous fistulas (ECFs) are great challenges during the open abdomen. The loss of digestive juice, water-electrolyte imbalance and malnutrition are intractable issues during management of ECF. Techniques such as "fistula patch" and vacuum-assisted closure therapy have been applied to prevent contamination of open abdominal wounds by intestinal fistula drainage. However, failures are encountered due to high-output fistula and anatomical complexity. Here, we report 3D-printed patient-personalized fistula stent for ECF treatment based on 3D reconstruction of the fistula image. Subsequent follow-up demonstrated that this stent was well-implanted and effective to reduce the volume of enteric fistula effluent.