Differences in nature killer cell response and interference with mitochondrial DNA induced apoptosis in moxifloxacin environment.

OBJECTIVES: As antibiotics become more prevalent, accuracy and safety are critical. Moxifloxacin (MXF) have been reported to have immunomodulatory effects on a variety of immune cells and even anti-proliferative and pro-apoptotic effects, but the mechanism of action is not fully clear. METHODS: Peripheral blood mononuclear cells (PBMC) from experimental groups of healthy adults (n = 3) were treated with MXF (10ug/ml) in vitro for 24 h. Single-cell sequencing was performed to investigate differences in the response of each immune cell to MXF. Flow cytometry determined differential gene expression in subsets of most damaged NK cells. Pseudo-time analysis identified drivers that influence MXF-stimulated cell differentiation. Detection of mitochondrial DNA and its involvement in the mitochondrial respiratory chain pathway clarifies the origin of MXF-induced stress injury. RESULTS: Moxifloxacin-environmental NK cells are markedly reduced: a new subset of NK cells emerges, and immediate-early-response genes in this subset indicate the presence of an early activation response. The inhibitory receptor-dominant subset shows enhanced activation, leading to increased expression of cytokines and chemokines. The near-mature subset showed greater cytotoxicity and the most pronounced cellular damage. CD56bright cells responded by antagonizing the regulation of activation and inhibitory signals, demonstrating a strong cleavage capacity. The severe depletion of mitochondrial genes was focused on apoptosis induced by the mitochondrial respiratory chain complex. CONCLUSION: NK cells exhibit heightened sensitivity to the MXF environment. Different NK subsets upregulate the expression of cytokines and chemokines through different activation pathways. Concurrently, MXF induces impairment of the mitochondrial oxidative phosphorylation system, culminating in apoptosis.

Spatio-temporal microbial regulation of aggregate-associated priming effects under contrasting tillage practices.

Tillage intensity significantly influences the heterogeneous distribution and dynamic changes of soil microorganisms, consequently shaping spatio-temporal patterns of SOC decomposition. However, little is known about the microbial mechanisms by which tillage intensity regulates the priming effect (PE) dynamics in heterogeneous spatial environments such as aggregates. Herein, a microcosm experiment was established by adding 13C-labeled straw residue to three distinct aggregate-size classes (i.e., mega-, macro-, and micro-aggregates) from two long-term contrasting tillage histories (no-till [NT] and conventional plow tillage [CT]) for 160 days to observe the spatio-temporal variations in PE. Metagenomic sequencing and Fourier transform mid-infrared techniques were used to assess the relative importance of C-degrading functional genes, microbial community succession, and SOC chemical composition in the aggregate-associated PE dynamics during straw decomposition. Spatially, straw addition induced a positive PE for all aggregates, with stronger PE occurring in larger aggregates, especially in CT soil compared to NT soil. Larger aggregates have more unique microbial communities enriched in genes for simple C degradation (e.g., E5.1.3.6, E2.4.1.7, pmm-pgm, and KduD in Nitrosospeera and Burkholderia), contributing to the higher short-term PE; however, CT soils harbored more genes for complex C degradation (e.g., TSTA3, fcl, pmm-pgm, and K06871 in Gammaproteobacteria and Phycicoccus), supporting a stronger long-term PE. Temporally, soil aggregates played a significant role in the early-stage PEs (i.e., < 59 days after residue addition) through co-metabolism and nitrogen (N) mining, as evidenced by the increased microbial biomass C and dissolved organic C (DOC) and reduced inorganic N with increasing aggregate-size class. At a later stage, however, the legacy effect of tillage histories controlled the PEs via microbial stoichiometry decomposition, as suggested by the higher DOC-to-inorganic N and DOC-to-available P stoichiometries in CT than NT. Our study underscores the importance of incorporating both spatial and temporal microbial dynamics for a comprehensive understanding of the mechanisms underlying SOC priming, especially in the context of long-term contrasting tillage practices.

Composition and contents of fatty acids and amino acids in the mycelia of Lentinula edodes.

With the global shortages of animal protein foods, mycoprotein as a low-cost alternative source of protein by its high-protein and low-fat content has become a development trend. Lentinula edodes (L. edodes) is a healthy food with high protein and low fiber. This work evaluated the nutritional value of L. edodes mycelia, and determined the composition and contents of fatty acids and amino acids. Eleven saturated fatty acids (SFAs) and 12 unsaturated fatty acids (UFAs) were detected in the mycelia of L. edodes. The UFA content accounted for 75.7% and 73.1% of the total fatty acid content in the mycelia of strains 18 and 18N44, respectively. Linoleic acid was the major polyunsaturated fatty acid (PUFA) in the mycelia, accounting for 91.0% and 86.3% of the UFAs, respectively. The mycelia of the two strains contained 17 types of amino acids, and the essential amino acids were sufficient (357.92 ± 0.42 and 398.38 ± 4.52 mg/g pro, respectively), both close to the WHO/FAO reference protein pattern value. The most abundant essential amino acid was Lys, and the limiting amino acids were Met + Cys and Ile, respectively. The SRC values in the mycelia of the two strains were 68.07 and 54.86, and the EAAI values were 67.70 and 74.42, respectively, both being close to those of ovalbumin. It is concluded that L. edodes mycelia are rich in easily absorbed high-quality proteins and PUFAs, and can be used as a source for meat analog required by vegetarians. This study provides a scientific basis for the further utilization of mycelial resources.

Manipulation of Charge Dynamics for Efficient and Bright Blue Perovskite Light-Emitting Diodes with Chiral Ligands.

Perovskite light-emitting diodes (PeLEDs) emerge as a promising class of optoelectronic devices for next-generation displays and lighting technology. However, the performance of blue PeLEDs lags far behind that of their green and red counterparts, including the unachieved trade-off between high efficiency and high luminance, severe efficiency roll-off, and unsatisfactory power efficiency. Here, a multi-functional chiral ligand of L-phenylalanine methyl ester hydrochloride is strategically introduced into quasi-2D perovskites, which can effectively passivate defects, modulate the phase distribution, improve photoluminescence quantum yield, guarantee high-quality film morphology, and enhance charge transport. Furthermore, ladder-like hole transport layers are established, boosting charge injection and balance. The resultant sky-blue PeLEDs (the photoluminescence peak is 493 nm and the electroluminescence peak is 497 nm) exhibit an external quantum efficiency of 12.43% at 1000 cd m-2 and a record power efficiency of 18.42 lm W-1 , rendering that the performance is among the best blue PeLEDs.

Large-Area Flexible Printed Thin-Film Transistors with Semiconducting Single-Walled Carbon Nanotubes for NO2 Sensors.

Development of large-area, low-cost, low-voltage, low-power consumption, flexible high-performance printed carbon nanotube thin-film transistors (TFTs) is helpful to promote their future applications in sensors and biosensors, wearable electronics, and the Internet of things. In this work, low-voltage, flexible printed carbon nanotube TFTs with a large-area and low-cost fabrication process were successfully constructed using ultrathin (∼3.6 nm) AlOx thin films formed by plasma oxidation of aluminum as dielectrics and screen-printed silver electrodes as contact electrodes. The as-prepared bottom-gate/bottom-contact carbon nanotube TFTs exhibit a low leakage current (∼10-10 A), a high charge carrier mobility (up to 9.9 cm2 V-1 s-1), high on/off ratios (higher than 105), and small subthreshold swings (80-120 mV/dec) at low operation voltages (from -1.5 to 1 V). At the same time, printed carbon nanotube TFTs showed a high response (ΔR/R = 99.6%) to NO2 gas even at 16 ppm with a faster response and recovery speed (∼8 s, exposure to 0.5 ppm NO2), a lower detection limit (0.069 ppm NO2), and a low power consumption (0.86 µW, exposure to 16 ppm NO2) at a gate voltage of 0.2 V at room temperature. Moreover, the printed carbon nanotube devices exhibited excellent mechanical flexibility and bias stress stability after 12,000 bending cycles at a radius of 5 mm and a bias stress test for 7200 s at a gate voltage of ±1 V, which originated from the ultrathin and compact AlOx dielectric and the super adhesion force between screen-printed silver electrodes and polyethylene terephthalate substrates.