Intraoperative Cone Beam Tomography and Navigation for Displaced Acetabular Fractures: A Comparative Study.

OBJECTIVES: To evaluate the accuracy of reduction of the acetabular articular surface using an intraoperative computed tomography scanner (O-Arm) and screw navigation compared with a classical open technique. DESIGN: Prospective matched cohort study. SETTING: Tertiary referral center. PATIENTS/PARTICIPANTS: Adult patients with acute acetabular fractures were included in the study. All patients were treated by 2 senior surgeons using intraoperative imaging and screw navigation. MAIN OUTCOME MEASUREMENTS: The primary outcome measure was articular reduction. Secondary outcomes were radiation dosage, operative variables [operative time, time for image acquisition, intraoperative bleeding (cell saver), number of surgical plates, and number of screws], and postoperative variables (first postoperative day pain on the visual analog scale, postoperative transfusion, and hemoglobin change). P < 0.05 was considered statistically significant. RESULTS: Thirty-five patients were treated in the inclusion period (2016-2017) and were matched to 35 cases in our database (2013-2016). Mean age was 43 years, and the most common fracture type was a both-column fracture (OTA/AO type C). Postoperative image analysis showed that reduction was achieved in 87.1% of the cases in the O-Arm group versus 64.7% in the control group (P < 0.05). Mean gap of the articular fragments was 3.6 mm in the O-Arm group compared with 5.6 mm (P = 0.01) in the control group. There was no significant difference between the 2 groups in regards to all other studied variables except a decrease in intraoperative blood loss and transfusions and an increase in surgical time with the O-Arm group. Finally, the total radiation dose was decreased using the intraoperative O-Arm compared with a routine postoperative computed tomography scan (dose length product in O-Arm: 498 mGy.cm; dose length product in historical group: 715 mGy.cm). CONCLUSIONS: Using intraoperative imaging and screw navigation for displaced acetabular fractures allow screw navigation with increasing articular surface reduction accuracy. Operative and anesthesia times were not increased, whereas radiation exposure to the patient was significantly decreased. We recommend the use of intraoperative imaging for the treatment of displaced acetabular fractures. LEVEL OF EVIDENCE: Therapeutic Level III. See Instructions for Authors for a complete description of levels of evidence.

Five to thirteen year results of a cemented dual mobility socket to treat recurrent dislocation.

PURPOSE: Dual mobility (DM) socket has been associated with a low rate of dislocation following both primary and revision total hip arthroplasty (THA). However, little is known about the long-term efficiency of DM in the treatment of THA instability. The purpose of this retrospective study was to evaluate the outcome of a cemented DM socket to treat recurrent dislocation after a minimum of five year follow-up. METHODS: The series included 51 patients with a mean age of 71.3 ± 11.5 (range, 41-98) years presenting with recurrent dislocation (mean 3.3). A single DM socket design was used consisting of a stainless steel outer shell with grooves with a highly polished inner surface articulating with a mobile polyethylene component. The femoral head was captured in the polyethylene component using a snap-fit type mechanism, the latter acting as a large unconstrained head inside the metal cup. RESULTS: At the minimum five year follow-up evaluation, 18 of the 51 patients deceased at a mean of 4.8 ± 2.3 years, three were lost to follow-up at a mean of 1.4 years, seven had been revised at a mean of 4.7 ± 3.1 years (range, 1.5-9.1), and the remaining 23 were still alive and did not have revision at a mean of 8.2 ± 2.4 years (range, 5-13 years). Of the seven revision, three were performed for further episodes of dislocation (at the large bearing for one patient and intra-prosthetic for two patients) after a mean 5.9 ± 2.9 years (range, 2.7-9.1), whereas two were performed for late sepsis and two for aseptic loosening of the acetabular component. Radiographic analysis did not reveal any further loosening on the acetabular side. The survival rate of the cup at ten years, using re-dislocation as the end-point, was 86.1 ± 8.4% (95% confidence interval, 69.7-100%). The survival rate of the cup at ten years, using revision for any reason as the end-point, was 75.2 ± 9.3% (95% confidence interval, 56.9-93.5%). CONCLUSION: A cemented dual mobility cup was able to restore hip stability in 94% of patients presenting with recurrent dislocating hips up to 13-year follow-up with none of the complications associated with constrained devices, as mechanical failure occurred in only 3.9% of the patients of this series. The overall reduced survival using revision for any reason as the end-point at ten years was related to this specific patients population that had various co-morbidities.

Normal Range of Patellar Tendon Elasticity Using the Sharewave Elastography Technique: An In Vivo Study in Normal Volunteers.

In-vivo investigation of tendon mechanical properties in healthy subjects using Shear Wave Elastography (SWE) techniques is a relatively new field of study. This work aims to evaluate the elastic properties of the patellar tendon in various knee range of flexion. Twenty healthy adult subjects were enrolled in the study. Shear wave speed (SWS) in the patellar tendon was measured in three different positions: Knee extended, knee semi-flexed (30°), and knee flexed (90°). Mean shear modulus was 50.9 +- 33.1 kPa in knee extension position, 137.5 +- 50.7 kPa in 30° flexion position, and 226.5 +- 60.3 kPa in 90° flexion position. The lowest shear modulus was obtained at rest with the knee in a fully extended position. These results are in agreement with those previously reported on Achilles tendon and triceps muscles. Shear modulus values obtained in our study could be considered as baseline values for further investigations in adults.

Thoracic outlet syndrome: definition, aetiological factors, diagnosis, management and occupational impact.

INTRODUCTION: Thoracic outlet syndrome is a controversial cause of neck and shoulder pain due to complex mechanisms involving muscular dysfunction and nerve compression. Although management of thoracic outlet syndrome must be based on a multidisciplinary approach, physicians and occupational therapist should be familiar with the principles of diagnosis and treatment. METHOD, RESULTS AND CONCLUSION: The purpose of this article is to review the definitions, diagnosis and management of this syndrome. A particular emphasis was described on the links between the workplace and the individual in the pathogenesis, prevalence in the workforce and the course of this disease.