Function of Brønsted and Lewis acid sites in xylose conversion into furfural.

In this work, the xylose conversion and the selectivity to furfural were assessed over mesoporous sulfonic silica SBA-15-(X)SO3H catalysts doped with metal ions (X = Al(iii), Ti(iv) or Zr(iv)). The type and amount of acid sites were analyzed by adsorption of pivalonitrile. The SBA-15-(X)SO3H materials show Lewis acid sites (LAS) and two types of Brønsted acid sites (BAS) with different strengths. Type I (BAS I) belongs to terminal silanol groups, type II (BAS II) is ascribed to hydroxyl groups bonded to sulfur or transition metal, and the LAS is related to M-O bonds. Optimal reaction conditions for the most active catalyst (SBA-15-(Zr)SO3H) were 120 minutes of reaction at 160 °C, 20 wt% of catalyst, and 2.5% of xylose/solvent. Additionally, a kinetic study was carried out to calculate the rate constants, the activation energy, and the pre-exponential factor for the xylose dehydration reaction. It was found that the selectivity to furfural in sulfonic silica SBA-15-(X)SO3H catalysts was directly related to the BAS II fraction. While LAS negatively impacts the selectivity to furfural leading to the undesired reaction between furfural and xylose obtaining humins as secondary products.

Zinc-aluminum layered double hydroxide and double oxide for room-temperature oxidation of sulfur dioxide gas.

Sulfur dioxide (SO2) gas at trace levels challenges the consumption of fuel gases and cleaning of flue gases originating from diverse anthropogenic sources. We have demonstrated Zn-Al layered double hydroxide (LDH) and layered double oxide (LDO) as low-cost and effective adsorbents in removing lowly concentrated SO2 gas at room temperature. Water in the adsorbent bed significantly improved the performance, where the maximum adsorption capacity of 38.0 mg g-1 was achieved for LDO. Based on the spectroscopic findings, the adsorbed gas molecules were oxidized to surface-bound sulfate/bisulfate species, showing complete mineralization of SO2 molecules. By employing an inexpensive NaOH-H2O2 solution-based regeneration strategy, we successfully regenerated the spent LDO, significantly restoring its gas uptake capacity. The regenerated oxide exhibited an increased gas uptake capacity ranging from 38.0 to 98.5 mg g-1, highlighting the practicality and economic feasibility of our approach. LDH/LDO materials are promising regenerable adsorbents for removing low concentrations of SO2 gas in ambient conditions.

Comparison of dilute acid pretreatment of agave assisted by microwave versus ultrasound to enhance enzymatic hydrolysis.

A comparison between microwave and ultrasound irradiations in the agave pretreatment using dilute sulfuric acid as catalyst was assessed for the first time. Pretreatments were performed using a Taguchi Orthogonal Array L9 (34) to improve the hemicellulose removal and the agave digestibility. The results showed that under optimal conditions, the hemicellulose removal was superior in the pretreatment assisted with microwave (77.5%) compared to ultrasound (28.2%). Enzymatic hydrolysis yield of agave pretreated with microwave (MWOC) was 2-fold higher than agave pretreated with ultrasound (USOC). The relatively mild conditions of pretreatment with MWOC allowed to obtain a hydrolyzed free of inhibitors with a high glucose concentration (47.7 g/L) at low solids loading (10% w/v). However, these conditions did not have a significant effect over the agave pretreated with ultrasound. The pretreatment assisted with MWOC allowed to reduce time and temperature of the process compared to pretreatment with conventional heating.

Quadratic Non-Linear Optical Properties of the poly(2,5-bis(but-2-ynyloxy) Benzoate Containing the 2-(ethyl(4-((4-nitrophenyl)buta-1,3-diynyl)phenyl)amino)ethanol) Chromophore.

Excellent quadratic non-linear optical (ONL-2) properties of the poly(2,5-bis(but-2-ynyloxy) benzoate, containing a polar diacetylene as a chromophore, were found. According with the Maker fringes method, oriented polymer films showing an order parameter of ∼0.23 can display outstanding and stable Second Harmonic Generation (SHG) effects under off-resonant conditions (SHG-532 nm). Also, the macroscopic non-linear optical (NLO)-coefficients were evaluated under the rod-like molecular approximation, obtaining: χzzz(2) and χzxx(2) in the order of 280 ± 10 and 100 ± 10 pm V-1, respectively. The mechanical and chemical properties, in addition to the large ONL-2 coefficients exhibited by this polymer, make it a promising organic material in the development of optoelectronic/photonic devices.