RESUMEN
This paper reports on the absolute response of a Fuji BAS-TR image plate to relatively low-energy protons (<0.2 MeV) and carbon ions (<1 MeV) accelerated by a 10-TW-class compact high-intensity laser system. A Thomson parabola spectrometer was used to discriminate between different ion species while dispersing the ions according to their kinetic energy. Ion parabolic traces were recorded using an image plate detector overlaid with a slotted CR-39 solid-state detector. The obtained response function for the protons was reasonably extrapolated from previously reported higher-ion-energy response functions. Conversely, the obtained response function for carbon ions was one order of magnitude higher than the value extrapolated from previously reported higher-ion-energy response functions. In a previous study, it was determined that if the stopping range of carbon ions is comparable to or smaller than the grain size of the phosphor, then some ions will provide all their energy to the binder resin rather than the phosphor. As a result, it is believed that the imaging plate response will be reduced. Our results show good agreement with the empirical formula of Lelasseux et al., which does not consider photo-stimulated luminescence (PSL) reduction due to the urethane resin. It was shown that the PSL reduction due to the deactivation of the urethane resin is smaller than that previously predicted.
RESUMEN
We report the generation of ultrashort bright electron pulses directly driven by irradiating a solid target with intense femtosecond laser pulses. The duration of electron pulses after compression by a phase rotator composed of permanent magnets was measured as 89 fs via the ponderomotive scattering of electron and laser pulses, which were almost at the compression limit due to the dispersion of the electron optics. The electron pulse compression system consisting of permanent magnets enabled extremely high timing stability between the laser pulse and electron pulse. The long-term RMS arrival time drift was below 14 fs in 4 h, which was limited by the resolution of the current setup. Because there was no time-varying field to generate jitter, the timing jitter was essentially reduced to zero. To demonstrate the capability of the ultrafast electron pulses, we used them to directly visualize laser pulse propagation in a vacuum and perform 2D mapping of the electric fields generated by low-density plasma in real time.
RESUMEN
This article reports the development of a compact Thomson parabola spectrometer for laser-accelerated ions that can measure angular distribution with a high energy resolution and has a variable measurable energy range. The angular-resolved energy spectra for different ion species can be measured in a single shot, and the sampling angle can be selected from outside the vacuum region. The electric and magnetic fields are applied to the ion dispersion by using a permanent magnetic circuit and annulus sector-shaped electrodes with a wedge configuration. The compact magnetic circuit consists of permanent magnets, fixed yokes, and movable yokes. The magnetic flux is intentionally leaked to the movable yokes, allowing the magnetic field to be adjusted from 53 mT to 259 mT. The annulus sector-shaped electrodes with a wedge configuration provide better trace separation for high-energy ions, retain the lower-energy part of the ion signal, and subject ions passing through all pinholes to an equivalent Lorentz force. The magnetic and electric fields are designed for measuring protons and carbon ions with an energy range of 0.1-5 MeV. The spectrometer allows for the adjustment of the observable energy range afterward according to the parameters of the accelerated ion.
RESUMEN
Alpha particles generated by 7Li(p,α)4He and 19F(p,α)16O reactions are selectively detected in the presence of abundant primary protons by reducing the proton sensitivity of CR-39 using a potassium hydroxide-ethanol-water (PEW) etching solution. These nuclear reactions are induced in a LiF crystal using the laser-accelerated protons (4 × 1011 protons/pulse with a maximum energy of 3.3 MeV) generated and accelerated by the interaction of a 40-fs laser pulse with a polyethylene thin film target at a peak intensity of 5 × 1019 W/cm2. Subsequent etching of the CR-39 in the PEW solution (KOH: 17 wt. %; C2H5OH: 25 wt. %; H2O: 58 wt. %) permits the selective detection of 4.0 MeV alpha particles, which is independently confirmed by an experiment using alpha particles from an 241Am source. The described method is expected to be useful for research into nuclear reactions in laser plasma.
RESUMEN
We have demonstrated that a pulsed electromagnetic wave (Sommerfeld wave) of subterahertz frequency and 11-MV/m field strength can be induced on a metal wire by the interaction of an intense femtosecond laser pule with an adjacent metal foil at a laser intensity of 8.5×10^{18}W/cm^{2}. The polarity of the electric field of this surface wave is opposite to that obtained by the direct interaction of the laser with the wire. Numerical simulations suggest that an electromagnetic wave associated with electron emission from the foil induces the surface wave. A tungsten wire is placed normal to an aluminum foil with a gap so that the wire is not irradiated and damaged by the laser pulse, thus making it possible to generate surface waves on the wire repeatedly.
RESUMEN
This note points out a missed correction to the math on p. 5648 of [Appl. Opt.5, 5647 (2016)APOPAI0003-693510.1364/AO.55.005647].
RESUMEN
To efficiently eliminate picosecond pre-pulses that accompany ultrashort pulses emitted from high-power chirped-pulse-amplification laser systems, we have developed a high-performance plasma mirror system. By reducing the reflectivity of the antireflection coating on the substrate for the plasma mirror to the limit of current technology (â¼0.006%), we achieved the highest pre-pulse contrast enhancement reported to date for a single plasma mirror of 104 at 1 ps before the pulse peak. By optimizing the laser incidence to the plasma mirror and the laser fluence, the reflectivity of the plasma mirror has been improved to 70%. The contrast improvement indicates extensibility to 100 PW class lasers by doubling this plasma mirror system. Contrast enhancement of 108 should be possible without a serious reduction in energy (no more than 50%).
RESUMEN
A laser ion source that produces shortly bunched ion beam is proposed. In this ion source, ions are extracted immediately after the generation of laser plasma by an ultra-short pulse laser before its diffusion. The ions can be injected into radio frequency (RF) accelerating bucket of a subsequent accelerator. As a proof-of-principle experiment of the ion source, a RF resonator is prepared and H2 gas was ionized by a short pulse laser in the RF electric field in the resonator. As a result, bunched ions with 1.2 mA peak current and 5 ns pulse length were observed at the exit of RF resonator by a probe.
RESUMEN
The temporal evolutions of electromagnetic fields generated by the interaction between ultraintense lasers (1.3×10(18) and 8.2×10(18)W/cm(2)) and solid targets at a distance of several millimeters from the laser-irradiated region have been investigated by electron deflectometry. For three types of foil targets (insulating foil, conductive foil, and insulating foil onto which a metal disk was deposited), transient changes in the fields were observed. We found that the direction, strength, and temporal evolution of the generated fields differ markedly for these three types of targets. The results provide an insight for studying the emission dynamics of laser-accelerated fast electrons.
RESUMEN
Terahertz pulses trapped as surface waves on a wire waveguide can be flexibly transmitted and focused to sub-wavelength dimensions by using, for example, a tapered tip. This is particularly useful for applications that require high-field pulses. However, the generation of strong terahertz surface waves on a wire waveguide remains a challenge. Here, ultrafast field propagation along a metal wire driven by a femtosecond laser pulse with an intensity of 10(18)â W/cm(2) is characterized by femtosecond electron deflectometry. From experimental and numerical results, we conclude that the field propagating at the speed of light is a half-cycle transverse-magnetic surface wave excited on the wire and a considerable portion of the kinetic energy of laser-produced fast electrons can be transferred to the sub-surface wave. The peak electric field strength of the surface wave and the pulse duration are estimated to be 200â MV/m and 7â ps, respectively.
RESUMEN
We demonstrate that, from a 10-µm metal wire irradiated by a 10(19) W/cm2 laser pulse, fast electrons form a nearly perfect circular beam around the wire and propagate along it. The total charge and diameter of the electron beam are maintained over a propagation distance of 1 m. Moreover, the electron beam can be guided along a slightly bent wire. Numerical simulations suggest that a relatively weak steady electric field, which does not decay for several nanoseconds, is generated around the wire and plays a key role in the long-distance guidance.
RESUMEN
We report the first direct measurement of the emission duration of laser-accelerated fast electrons from the surface of a solid target irradiated by a high-intensity femtosecond laser pulse. The emission duration is determined by autocorrelation measurement using the Coulomb repulsive forces that act on two equivalent electron pulses. The emission duration depends on the laser pulse duration for laser pulses of 200-690 fs. Numerical modeling of three-dimensional charged particle dynamics indicates that the emission duration of fast electrons is almost equal to the duration of the laser pulse.
RESUMEN
A diode-pumped, actively Q-switched 2.8 µm fiber laser oscillator with an average output power of more than 12 W has been realized through the use of a 35 µm core erbium-doped ZBLAN fiber and an acousto-optic modulator; to our knowledge, this is the first 3 µm pulsed fiber laser in the 10 W class. Pulse energy up to 100 µJ and pulse duration down to 90 ns, corresponding to a peak power of 0.9 kW, were achieved at a repetition rate of 120 kHz.
Asunto(s)
Erbio/química , Rayos Láser , Fibras Ópticas , ColorRESUMEN
We have experimentally demonstrated that fast electrons emitted from a metallic wire irradiated by a 5 × 10(18) W/cm(2) laser pulse can be collimated along the wire, and that their intensity is significantly enhanced in the axial direction of the wire. As the wire length is increased up to 30 mm from the laser focal spot, the angular divergence of the emitted electrons with energies of hundreds of keV decreases to 65 mrad. Numerical simulations reveal that the electrons are trapped by the transient electric field surrounding the wire and guided along the axial direction.
RESUMEN
We have developed a diode-pumped tunable 3 µm fiber laser with a cw output power of the order of 10 W with the use of an erbium-doped ZBLAN fiber. A tunability range of 110 nm (2770 to 2880 nm) with an output power between 8 and 11 W was demonstrated. As the pump power was increased, the center of the wavelength range was shifted toward longer wavelengths, but the width of the wavelength range was largely unaffected. The total tunability range for various pump power levels was 170 nm (2710 to 2880 nm). To our knowledge, this is the highest performance (output power and tunability) obtained from a tunable 3 µm fiber laser.
RESUMEN
A simple technique for single-shot microscopic electron imaging was demonstrated for the study of intense femtosecond laser-produced plasmas. Passed through a permanent magnet lens designed for 110-keV electrons, hot electrons emitted from the plasma produced by a single laser pulse of 0.8 mJ with intensity of 3 × 10(16) W/cm(2) were successfully imaged. Analyzing this image, we found that electrons were emitted from an area of 3 µm in diameter. At higher laser intensity of 10(18) W/cm(2), distinct structures were observed in and near the focal spot of the laser; that is, the electrons were emitted from several separate spots. These results show that laser-plasma electron imaging is promising for studying the interactions of femtosecond lasers with high-density plasmas.
RESUMEN
We report the first experimental demonstration of longitudinal compression of laser-accelerated electron pulses. Accelerated by a femtosecond laser pulse with an intensity of 10¹8 W/cm², an electron pulse with an energy of around 350 keV and a relative momentum spread of about 10⻲ was compressed to a 500-fs pulse at a distance of about 50 cm from the electron source by using a magnetic pulse compressor. This pulse was used to generate a clear diffraction pattern of a gold crystal in a single shot. This method solves the space-charge problem in ultrafast electron diffraction.
RESUMEN
A 24 W liquid-cooled CW 3 microm fiber laser with a multimode-core Er-doped ZBLAN fiber has been developed. The output power of 24 W and an optical-to-optical efficiency of 14.5% (with respect to incident pump power) were obtained with 975 nm diode pumping. Efficient cooling was implemented by a combination of fluid cooling over the entire length of the fiber and conductive cooling at both end faces of the fiber. Consequently, stable high-power operation was demonstrated. To our knowledge, this is the highest output power obtained by a 3 microm fiber laser. Furthermore, the high power can be further scaled up, since the output power in the present work is limited only by the available pump power.
RESUMEN
The characteristics of THz pulse radiation from argon clusters irradiated with intense femtosecond laser pulses have been investigated. The average power of the THz pulses radiated from argon clusters is approximately 40 times greater than that from argon gas. The enhancement of the THz radiation originates from large laser absorption by the clusters. The polarization state and the angular distribution of the power of the THz pulses show no dependence on laser polarization, which suggests that the radiation originates from laser-induced charge separation along the laser propagation direction.
Asunto(s)
Argón/química , Argón/efectos de la radiación , Rayos Láser , Iluminación/métodos , Transferencia de Energía , Dosis de Radiación , Radiación TerahertzRESUMEN
Highly stable operation of a two-stage multipass Ti:sapphire amplifier (a four-pass pre-amplifier and a four-pass power amplifier) for a 100-mJ-class chirped-pulse amplification system has been demonstrated by passive stabilization. By optimizing the ratio of pump energies to the two amplifiers and the optical losses artificially inserted into the second power amplifier, a root-mean-square fluctuation in pulse energy of 0.3% was achieved, which was 5 times lower than that of the pump laser. This is the lowest pulse-to-pulse fluctuation, to the best of our knowledge, obtained by the 100-mJ-class Ti:sapphire amplifiers.