Tuning the Spin Transition and Carrier Type in Rare-Earth Cobaltates via Compositional Complexity.

There is growing interest in material candidates with properties that can be engineered beyond traditional design limits. Compositionally complex oxides (CCO), often called high entropy oxides, are excellent candidates, wherein a lattice site shares more than four cations, forming single-phase solid solutions with unique properties. However, the nature of compositional complexity in dictating properties remains unclear, with characteristics that are difficult to calculate from first principles. Here, compositional complexity is demonstrated as a tunable parameter in a spin-transition oxide semiconductor La1- x(Nd, Sm, Gd, Y)x/4CoO3, by varying the population x of rare earth cations over 0.00≤ x≤ 0.80. Across the series, increasing complexity is revealed to systematically improve crystallinity, increase the amount of electron versus hole carriers, and tune the spin transition temperature and on-off ratio. At high a population (x = 0.8), Seebeck measurements indicate a crossover from hole-majority to electron-majority conduction without the introduction of conventional electron donors, and tunable complexity is proposed as new method to dope semiconductors. First principles calculations combined with angle resolved photoemission reveal an unconventional doping mechanism of lattice distortions leading to asymmetric hole localization over electrons. Thus, tunable complexity is demonstrated as a facile knob to improve crystallinity, tune electronic transitions, and to dope semiconductors beyond traditional means.

Elucidating the Impact of Li3InCl6-Coated LiNi0.8Co0.15Al0.05O2 on the Electro-Chemo-Mechanics of Li6PS5Cl-Based Solid-State Batteries.

Li6PS5Cl has attracted significant attention due to its high Li-ion conductivity and processability, facilitating large-scale solid-state battery applications. However, when paired with high-voltage cathodes, it experiences adverse side reactions. Li3InCl6 (LIC), known for its higher stability at high voltages and moderate Li-ion conductivity, is considered a catholyte to address the limitations of Li6PS5Cl. To extend the stability of Li6PS5Cl toward LiNi0.8Co0.15Al0.05O2 (NCA), we applied nanocrystalline LIC as a 180 nm-thick protective coating in a core-shell-like fashion (LIC@NCA) via mechanofusion. Solid-state batteries with LIC@NCA allow an initial discharge specific capacity of 148 mA h/g at 0.1C and 80% capacity retention for 200 cycles at 0.2C with a cutoff voltage of 4.2 V (vs Li/Li+), while cells without LIC coating suffers from low initial discharge capacity and poor retention. Using a wide spectrum of advanced characterization techniques, such as operando XRD, XPS, FIB-SEM, and TOF-SIMS, we reveal that the superior performance of solid-state batteries employing LIC@NCA is related to the suppression of detrimental interfacial reactions of NCA with Li6PS5Cl, delamination, and particle cracking compared to uncoated NCA.

Bismuthene - Tetrahedral DNA nanobioconjugate for virus detection.

In this work, we present an electrochemical sensor for fast, low-cost, and easy detection of the SARS-CoV-2 spike protein in infected patients. The sensor is based on a selected combination of nanomaterials with a specific purpose. A bioconjugate formed by Few-layer bismuthene nanosheets (FLB) and tetrahedral DNA nanostructures (TDNs) is immobilized on Carbon Screen-Printed Electrodes (CSPE). The TDNs contain on the top vertex an aptamer that specifically binds to the SARS-CoV-2 spike protein, and a thiol group at the three basal vertices to anchor to the FLB. The TDNs are also marked with a redox indicator, Azure A (AA), which allows the direct detection of SARS-CoV-2 spike protein through changes in the current intensity of its electrolysis before and after the biorecognition reaction. The developed sensor can detect SARS-CoV-2 spike protein with a detection limit of 1.74 fg mL-1 directly in nasopharyngeal swab human samples. Therefore, this study offers a new strategy for rapid virus detection since it is versatile enough for different viruses and pathogens.

Turn-On Solid-State Fluorescent Determination of Zinc Ion by Quinoline-Based Covalent Organic Framework.

A new quinoline-based COF (covalent organic framework), obtained by Povarov reaction, containing 2,6-diisopropylphenyl moieties as substituents over the heterocyclic ring is described for detecting Zn2+ in aqueous solution. The introduction of the mentioned bulky phenyl rings into the network favors an increase of the distance between the reticular sheets and their arrangement, obtaining a new material with an alternating AB type stacking. The new material exhibits good selectivity to detect Zn2+ by fluorescence emission in aqueous solutions up to a concentration of 1.2 × 10-4 m of the metal ion. In order to have a deeper insight into the interaction between the COF and the zinc cation, a thorough spectroscopical, microscopical, and theoretical study is also presented and discussed in this communication.

Physical Delithiation of Epitaxial LiCoO2 Battery Cathodes as a Platform for Surface Electronic Structure Investigation.

We report a novel delithiation process for epitaxial thin films of LiCoO2(001) cathodes using only physical methods, based on ion sputtering and annealing cycles. Preferential Li sputtering followed by annealing produces a surface layer with a Li molar fraction in the range 0.5 < x < 1, characterized by good crystalline quality. This delithiation procedure allows the unambiguous identification of the effects of Li extraction without chemical byproducts and experimental complications caused by electrolyte interaction with the LiCoO2 surface. An analysis by X-ray photoelectron spectroscopy (XPS) and X-ray absorption spectroscopy (XAS) provides a detailed description of the delithiation process and the role of O and Co atoms in charge compensation. We observe the simultaneous formation of Co4+ ions and of holes localized near O atoms upon Li removal, while the surface shows a (2 × 1) reconstruction. The delithiation method described here can be applied to other crystalline battery elements and provide information on their properties that is otherwise difficult to obtain.

Alpha-Germanium Nanolayers for High-Performance Li-ion Batteries.

The exfoliation of tridimensional crystal structures has recently been considered a new source of bidimensional materials. The new approach offers the possibility of dramatically enlarging the library of bidimensional materials, but the number of nanolayers produced so far is still limited. Here, we report for the first time the use of a new type of material, α-germanium nanolayers (2D α-Ge). The 2D α-Ge is obtained by exfoliating crystals of α-germanium in a simple one-step procedure assisted by wet ball-milling (gram-scale fabrication). The α-germanium nanolayers have been tested as anode material for high-performance LIBs. The results show excellent performance in semi-cell configuration with a high specific capacity of 1630 mAh g-1 for mass loading of 1 mg cm-2 at 0.1 C. The semi-cell was characterized by a constant current rate of 0.5 C during 400 cycles and different scan rates (0.1 C, 0.5 C, and 1 C). Interestingly, the structural characterization, including Raman spectroscopy, XRPD, and XPS, concludes that 2D α-Ge largely retains its crystallinity after continuous cycling. These results can be used to potentially apply these novel 2D germanium nanolayers to high-performance Li-ion batteries.

Iron Oxyhydroxide-Covalent Organic Framework Nanocomposite for Efficient As(III) Removal in Water.

The presence of heavy metal ions in water is an environmental issue derived mainly from industrial and mineral contamination. Metal ions such as Cd(II), Pb(II), Hg(II), or As(III) are a significant health concern worldwide because of their high toxicity, mobility, and persistence. Covalent organic frameworks (COFs) are an emerging class of crystalline organic porous materials that exhibit very interesting properties such as chemical stability, tailored design, and low density. COFs also allow the formation of composites with remarkable features because of the synergistic combination effect of their components. These characteristics make them suitable for various applications, among which water remediation is highly relevant. Herein, we present a novel nanocomposite of iron oxyhydroxide@COF (FeOOH@Tz-COF) in which lepidocrocite (γ-FeOOH) nanorods are embedded in between the COF nanoparticles favoring As(III) remediation in water. The results show a remarkable 98.4% As(III) uptake capacity in a few minutes and impressive removal efficiency in a wide pH range (pH 5-11). The chemical stability of the material in the working pH range and the capability of capturing other toxic heavy metals such as Pb(II) and Hg(II) without interference confirm the potential of FeOOH@Tz-COF as an effective adsorbent for water remediation even under harsh conditions.

Imaging Phase Segregation in Nanoscale LixCoO2 Single Particles.

LixCoO2 (LCO) is a common battery cathode material that has recently emerged as a promising material for other applications including electrocatalysis and as electrochemical random access memory (ECRAM). During charge-discharge cycling LCO exhibits phase transformations that are significantly complicated by electron correlation. While the bulk phase diagram for an ensemble of battery particles has been studied extensively, it remains unclear how these phases scale to nanometer dimensions and the effects of strain and diffusional anisotropy at the single-particle scale. Understanding these effects is critical to modeling battery performance and for predicting the scalability and performance of electrocatalysts and ECRAM. Here we investigate isolated, epitaxial LiCoO2 islands grown by pulsed laser deposition. After electrochemical cycling of the islands, conductive atomic force microscopy (c-AFM) is used to image the spatial distribution of conductive and insulating phases. Above 20 nm island thicknesses, we observe a kinetically arrested state in which the phase boundary is perpendicular to the Li-planes; we propose a model and present image analysis results that show smaller LCO islands have a higher conductive fraction than larger area islands, and the overall conductive fraction is consistent with the lithiation state. Thinner islands (14 nm), with a larger surface to volume ratio, are found to exhibit a striping pattern, which suggests surface energy can dominate below a critical dimension. When increasing force is applied through the AFM tip to strain the LCO islands, significant shifts in current flow are observed, and underlying mechanisms for this behavior are discussed. The c-AFM images are compared with photoemission electron microscopy images, which are used to acquire statistics across hundreds of particles. The results indicate that strain and morphology become more critical to electrochemical performance as particles approach nanometer dimensions.

Exfoliation of Alpha-Germanium: A Covalent Diamond-Like Structure.

2D materials have opened a new field in materials science with outstanding scientific and technological impact. A largely explored route for the preparation of 2D materials is the exfoliation of layered crystals with weak forces between their layers. However, its application to covalent crystals remains elusive. Herein, a further step is taken by introducing the exfoliation of germanium, a narrow-bandgap semiconductor presenting a 3D diamond-like structure with strong covalent bonds. Pure α-germanium is exfoliated following a simple one-step procedure assisted by wet ball-milling, allowing gram-scale fabrication of high-quality layers with large lateral dimensions and nanometer thicknesses. The generated flakes are thoroughly characterized by different techniques, giving evidence that the new 2D material exhibits bandgaps that depend on both the crystallographic direction and the number of layers. Besides potential technological applications, this work is also of interest for the search of 2D materials with new properties.