A cell bank paradigm for preclinical evaluation of an analogous cellular product for an allogeneic cell therapy.

Toward the translation of allogeneic cell therapy products, cell banks are needed not only to manufacture the final human product but also during the preclinical evaluation of an animal-based analogous cellular product (ACP). These cell banks need to be established at both the master cell bank (MCB) level and the working cell bank (WCB) level. Inasmuch as most of the development of cell therapy products is at academic centers, it is imperative that academic researchers understand how to establish MCBs and WCBs within an academic environment. To illustrate this process, using articular cartilage as the model, a cell bank for an ACP was developed (MCBs at passage 2, WCBs at passage 5) to produce self-assembled neocartilage for preclinical evaluation (constructs at passage 7). The cell bank system is estimated to be able to produce between 160 000 and 400 000 constructs for each of the six MCBs. Overall, the ACP cell bank yielded constructs that are analogous to the intended human product, which is critical toward conducting preclinical evaluations of the ACP for inclusion in an Investigational New Drug application to the FDA.

Mechanical Evaluation of Commercially Available Fibrin Sealants for Cartilage Repair.

OBJECTIVE: Fibrin sealants are routinely used for intra-articular surgical fixation of cartilage fragments and implants. However, the mechanical properties of fibrin sealants in the context of cartilage repair are unknown. The purpose of this study was to characterize the adhesive and frictional properties of fibrin sealants using an ex vivo model. DESIGN: Native bovine cartilage-bone composites were assembled with a single application of Tisseel or Vistaseal. Composites were tested in tension and lap shear. In addition, the coefficient of friction (COF) was measured in a native cartilage annulus model alone and with minced cartilage. Finally, the effect of a double application of fibrin sealant was evaluated. RESULTS: There were no significant differences in tensile modulus, ultimate tensile strength (UTS), shear modulus, or ultimate shear strength (USS) between the 2 fibrin sealants. Both fibrin sealants demonstrated a UTS and USS of <8 and <30 kPa, respectively. There were no differences in COF between the sealants when tested alone or with minced cartilage. A double application of fibrin sealant did not alter the mechanical properties compared with a single application of fibrin sealant. CONCLUSIONS: Fibrin sealant adhesive properties are not affected by the sealant type studied or the number of applications in a bovine cartilage-bone model. Fibrin sealant tribological properties are not affected by sealant type or the addition of minced cartilage. The adhesive properties of Tisseel and Vistaseal were less than those desired for the in vivo fixation of cartilage repair implants. These findings motivate the development of an improved cartilage-specific adhesive for cartilage repair applications.

Topographical Characterization of the Young, Healthy Human Femoral Medial Condyle.

OBJECTIVE: The medial femoral condyle of the knee exhibits some of the highest incidences of chondral degeneration. However, a dearth of healthy human tissues has rendered it difficult to ascertain whether cartilage in this compartment possesses properties that predispose it to injuries. Assessment of young, healthy tissue would be most representative of the tissue's intrinsic properties. DESIGN: This work examined the topographical differences in tribological, tensile, and compressive properties of young (n = 5, 26.2 ± 5.6 years old), healthy, human medial femoral condyles, obtained from viable allograft specimens. Corresponding to clinical incidences of pathology, it was hypothesized that the lowest mechanical properties would be found in the posterior region of the medial condyle, and that tissue composition would correspond to the established structure-function relationships of cartilage. RESULTS: Young's modulus, ultimate tensile strength, aggregate modulus, and shear modulus in the posterior region were 1.0-, 2.8-, 1.1-, and 1.0-fold less than the values in the anterior region, respectively. Surprisingly, although glycosaminoglycan content is thought to correlate with compressive properties, in this study, the aggregate and shear moduli correlated more robustly to the amount of pyridinoline crosslinks per collagen. Also, the coefficient of friction was anisotropic and ranged 0.22-0.26 throughout the condyle. CONCLUSION: This work showed that the posteromedial condyle displays lower tensile and compressive properties, which correlate to collagen crosslinks and may play a role in this region's predisposition to injuries. Furthermore, new structure-function relationships may need to be developed to account for the role of collagen crosslinks in compressive properties.

The functionality and translatability of neocartilage constructs are improved with the combination of fluid-induced shear stress and bioactive factors.

Neocartilage tissue engineering aims to address the shortcomings of current clinical treatments for articular cartilage indications. However, advancement is required toward neocartilage functionality (mechanical and biochemical properties) and translatability (construct size, gross morphology, passage number, cell source, and cell type). Using fluid-induced shear (FIS) stress, a potent mechanical stimulus, over four phases, this work investigates FIS stress' efficacy toward creating large neocartilage derived from highly passaged minipig costal chondrocytes, a species relevant to the preclinical regulatory process. In Phase I, FIS stress application timing was investigated in bovine articular chondrocytes and found to improve the aggregate modulus of neocartilage by 151% over unstimulated controls when stimulated during the maturation stage. In Phase II, FIS stress stimulation was translated from bovine articular chondrocytes to expanded minipig costal chondrocytes, yielding a 46% improvement in aggregate modulus over nonstimulated controls. In Phase III, bioactive factors were combined with FIS stress to improve the shear modulus by 115% over bioactive factor-only controls. The translatability of neocartilage was improved in Phase IV by utilizing highly passaged cells to form constructs more than 9-times larger in the area (11 × 17 mm), yielding an improved aggregate modulus by 134% and a flat morphology compared to free-floating, bioactive factor-only controls. Overall, this study represents a significant step toward generating mechanically robust, large constructs necessary for animal studies, and eventually, human clinical studies.

Characterization of Adult and Neonatal Articular Cartilage From the Equine Stifle.

A significant portion of equine lameness is localized to the stifle joint. Effective cartilage repair strategies are largely lacking, however, recent advances in surgical techniques, biomaterials, and cellular therapeutics have broadened the clinical strategies of cartilage repair. To date, no studies have been performed directly comparing neonatal and adult articular cartilage from the stifle across multiple sites. An understanding of the differences in properties between the therapeutic target cartilage (i.e., adult cartilage) as well as potential donor cartilage (i.e., neonatal cartilage) could aid in selection of optimal harvest sites within a donor joint as well as evaluation of the success of the grafted cells or tissues within the host. Given the dearth of characterization studies of the equine stifle joint, and in particular neonatal stifle cartilage, the goal of this study was to measure properties of both potential source tissue and host tissue. Articular cartilage of the distal femur and patella (P) was assessed in regards to two specific factors, age of the animal and specific site within the joint. Two age groups were considered: neonatal (<1 week) and adult (4-14 years). Cartilage samples were harvested from 17 sites across the distal femur and patella. It was hypothesized that properties would vary significantly between neonatal and adult horses as well as within age groups on a site-by-site basis. Adult thickness varied by site. With the exception of water content, there were no significant biochemical differences among sites within regions of the distal femur (condyles and trochlea) and the patella in either the adult or neonate. Neonatal cartilage had a significantly higher water content than adult. Surprisingly, biochemical measurements of cellularity did not differ significantly between neonatal and adult, however, adult cartilage had greater variance in cellularity than neonatal. Overall, there were no significant differences between neonatal and adult glycosaminoglycan content. Collagen per wet weight was found to be significantly higher in adult cartilage than neonatal when averaged across all levels. In terms of biomechanical properties, aggregate modulus varied significantly across the condyles of adult cartilage but not the neonate. Neonatal cartilage was significantly less permeable, and the Young's modulus of neonatal cartilage was significantly higher than the adult. The tensile strength did not vary in a statistically significant manner between age groups. An understanding of morphological, histological, biochemical, and biomechanical properties enhances the understanding of cartilage tissue physiology and structure-function relationships. This study revealed important differences in biomechanical and biochemical properties among the 17 sites and among the six joint regions, as well as age-related differences between neonatal and adult cartilage. These location and age-related variations are informative toward determining the donor tissue harvest site.

The tribology of cartilage: Mechanisms, experimental techniques, and relevance to translational tissue engineering.

Diarthrodial joints, found at the ends of long bones, function to dissipate load and allow for effortless articulation. Essential to these functions are cartilages, soft hydrated tissues such as hyaline articular cartilage and the knee meniscus, as well as lubricating synovial fluid. Maintaining adequate lubrication protects cartilages from wear, but a decrease in this function leads to tissue degeneration and pathologies such as osteoarthritis. To study cartilage physiology, articular cartilage researchers have employed tribology, the study of lubrication and wear between two opposing surfaces, to characterize both native and engineered tissues. The biochemical components of synovial fluid allow it to function as an effective lubricant that exhibits shear-thinning behavior. Although tribological properties are recognized to be essential to native tissue function and a critical characteristic for translational tissue engineering, tribology is vastly understudied when compared to other mechanical properties such as compressive moduli. Further, tribometer configurations and testing modalities vary greatly across laboratories. This review aims to define commonly examined tribological characteristics and discuss the structure-function relationships of biochemical constituents known to contribute to tribological properties in native tissue, address the variations in experimental set-ups by suggesting a move toward standard testing practices, and describe how tissue-engineered cartilages may be augmented to improve their tribological properties.

A Guide for Using Mechanical Stimulation to Enhance Tissue-Engineered Articular Cartilage Properties.

The use of tissue-engineered articular cartilage (TEAC) constructs has the potential to become a powerful treatment option for cartilage lesions resulting from trauma or early stages of pathology. Although fundamental tissue-engineering strategies based on the use of scaffolds, cells, and signals have been developed, techniques that lead to biomimetic AC constructs that can be translated to in vivo use are yet to be fully confirmed. Mechanical stimulation during tissue culture can be an effective strategy to enhance the mechanical, structural, and cellular properties of tissue-engineered constructs toward mimicking those of native AC. This review focuses on the use of mechanical stimulation to attain and enhance the properties of AC constructs needed to translate these implants to the clinic. In vivo, mechanical loading at maximal and supramaximal physiological levels has been shown to be detrimental to AC through the development of degenerative changes. In contrast, multiple studies have revealed that during culture, mechanical stimulation within narrow ranges of magnitude and duration can produce anisotropic, mechanically robust AC constructs with high cellular viability. Significant progress has been made in evaluating a variety of mechanical stimulation techniques on TEAC, either alone or in combination with other stimuli. These advancements include determining and optimizing efficacious loading parameters (e.g., duration and frequency) to yield improvements in construct design criteria, such as collagen II content, compressive stiffness, cell viability, and fiber organization. With the advancement of mechanical stimulation as a potent strategy in AC tissue engineering, a compendium detailing the results achievable by various stimulus regimens would be of great use for researchers in academia and industry. The objective is to list the qualitative and quantitative effects that can be attained when direct compression, hydrostatic pressure, shear, and tensile loading are used to tissue-engineer AC. Our goal is to provide a practical guide to their use and optimization of loading parameters. For each loading condition, we will also present and discuss benefits and limitations of bioreactor configurations that have been used. The intent is for this review to serve as a reference for including mechanical stimulation strategies as part of AC construct culture regimens.