RESUMEN
While photoelectrochemical (PEC) cells show promise for solar-driven green hydrogen production, exploration of various light-absorbing multilayer coatings has yet to significantly enhance their hydrogen generation efficiency. Acidic conditions can enhance the hydrogen evolution reaction (HER) kinetics and reduce overpotential losses. However, prolonged acidic exposure deactivates noble metal electrocatalysts, hindering their long-term stability. Progress requires addressing catalyst degradation to enable stable, efficient, and acidic PEC cells. Here, we proposed a process design based on the photoilluminated redox deposition (PRoD) approach. We use this to grow crystalline Rh2P nanoparticles (NPs) with a size of 5-10 on 30 nm-thick TiO2, without annealing. Atomically precise reaction control was performed by using several cyclic voltammetry cycles coincident with light irradiation to create a system with optimal catalytic activity. The optimized photocathode, composed of Rh2P/TiO2/Al-ZnO/Cu2O/Sb-Cu2O/ITO, achieved an excellent photocurrent density of 8.2 mA cm-2 at 0 VRHE and a durable water-splitting reaction in a strong acidic solution. Specifically, the Rh2P-loaded photocathode exhibited a 5.3-fold enhancement in mass activity compared to that utilizing just a Rh catalyst. Furthermore, in situ scanning transmission electron microscopy (STEM) was performed to observe the real-time growth process of Rh2P NPs in a liquid cell.
RESUMEN
Gamma radiation has notable impacts on the flesh of mangoes. In this research, Katimon mangoes were subjected to different levels of irradiation (0.5, 1.0, 1.5, and 2.0 kGy) using a60Co irradiator. The results showed that irradiation significantly reduced the microbial population in the mango peels, with the 1.5 kGy dose showing the most significant reduction. Irradiation also delayed ripening and extended the shelf life of the mango peels. The total fat, protein, ash, moisture, and sugar content of the mango peels were all affected by irradiation. The total protein content, ash content and moisture content increased after irradiation, while the fat content remained relatively unchanged. The sugar content increased in all samples after storage, but the non-irradiated samples had higher sugar levels than the irradiated ones. The dietary fiber content of the mango peels was not significantly affected by irradiation. The vitamin C content decreased in all samples after storage. The titratable acidity and total soluble solids content of the mango peels increased after storage, but there were no significant differences between the irradiated and non-irradiated samples. Antioxidant activity and cytotoxicity assessment highlighted the antioxidant potential and reduced toxicity of irradiated samples. Additionally, the antimicrobial effectiveness of irradiated mango peels was evaluated. The most substantial inhibitory zones (measuring 16.90 ± 0.35) against Pseudomonas sp. were observed at a radiation dose of 1.5 kGy with 150 µg/disc. To identify potential antimicrobial agents, the volatile components of mangoes irradiated with 1.5 kGy were analyzed through GC-MS. Subsequently, these compounds were subjected to in silico studies against a viable protein, TgpA, of Pseudomonas sp. (PDB ID: 6G49). Based on molecular dynamic simulations and ADMET properties, (-)-Carvone (-6.2), p-Cymene (-6.1), and Acetic acid phenylmethyl ester (-6.1) were identified as promising compounds for controlling Pseudomonas sp.
RESUMEN
Applications of abundant seawater in electrochemical energy conversion are constrained due to the sluggish oxygen evolution reaction and the corrosive chlorine oxidation reaction. Hence, it is imperative to develop an efficient anodic reaction alternative suitable for coupling with the cathodic counterpart. Due to a low thermodynamic oxidation potential, hydrazine oxidation reaction (HzOR) offers a unique pathway to overcome these challenges. Herein, spontaneously in situ reduced atomic scale Pd surface-confined to electrochemically prepared layered Co(OH)2 on carbon cloth is synthesized. This study reveals the hydrazine and Pd-dependent morphological evolution of Co(OH)2 and its Pd hybrids into nanoparticulate form. Unlike various layered double hydroxides, Pd integrated Co(OH)2 benefits from the contribution of Co(OH)2 as an active HzOR catalyst and the reductive support to host Pd, resulting in synergistically improved performances. Mass activities of Pd in alkaline and alkaline saline electrolyte are 11.24 and 9.83 A mgPd -1 at 200 mV, respectively, corresponding to the highest HzOR activities among noble metals. The optimized Pd hybrid demonstrates ≈6.5 times the current density relative to PtC (14.91 mA cm-2 at 200 mV) in alkaline saline water with hydrazine. These findings would be beneficial to realize high overpotential anodic alternatives and reduce over-dependence on freshwater for electrocatalysis.
RESUMEN
An effective strategy for improving the charge transport efficiency of p-type Cu2O photocathodes is the use of counter n-type semiconductors with a proper band alignment, preferably using Al-doped ZnO (AZO). Atomic layer deposition (ALD)-prepared AZO films show an increase in the built-in potential at the Cu2O/AZO interface as well as an excellent conformal coating with a thin thickness on irregular Cu2O. Considering the thin thickness of the AZO overlayers, it is expected that the composition of the Al and the layer stacking sequence in the ALD process will significantly influence the charge transport behavior and the photoelectrochemical (PEC) performance. We designed various stacking orders of AZO overlayers where the stacking layers consisted of Al2O3 (or Al) and ZnO using the atomically controlled ALD process. Al doping in ZnO results in a wide bandgap and does not degrade the absorption efficiency of Cu2O. The best PEC performance was obtained for the sample with an AZO overlayer containing conductive Al layers in the bottom and top regions. The Cu2O/AZO/TiO2/Pt photoelectrode with this overlayer exhibits an open circuit potential of 0.63 V and maintains a high cathodic photocurrent value of approximately -3.2 mA cm-2 at 0 VRHE for over 100 min.
RESUMEN
This work presents a hitherto unreported approach to assemble a 1D oxide-1D chalcogenide heterostructured photoactive film. As a representative system, bismuth (Bi) catalyzed 1D CdSe nanowires are directly grown on anodized 1D TiO2 nanotube (T_NT). A combination of the reductive successive-ionic-layer-adsorption-reaction (R-SILAR) and the solution-liquid-solid (S-L-S) approach is implemented to fabricate this heterostructured assembly, reported in this 1D/1D form for the first time. XRD, SEM, HRTEM, and elemental mapping are performed to systematically characterize the deposition of bismuth on T_NT and the growth of CdSe nanowires leading to the evolution of the 1D/1D heterostructure. The resulting "treelike" photoactive architecture demonstrates UV-visible light-driven electron-hole pair generation. The photoelectrochemical results highlight: (i) the formation of a stable n-n heterojunction between TiO2 nanotube and CdSe nanowire, (ii) an excellent correlation between the absorbance vis-à-vis light conversion efficiency (IPCE), and (iii) a photocurrent density of 3.84 mA/cm2. This proof-of-concept features the viability of the approach for designing such complex 1D/1D oxide-chalcogenide heterostructures that can be of interest to photovoltaics, photocatalysis, environmental remediation, and sensing.
RESUMEN
Ultrafine niobium oxide nanocrystals/reduced graphene oxide (Nb2O5 NCs/rGO) was demonstrated as a promising anode material for sodium ion battery with high rate performance and high cycle durability. Nb2O5 NCs/rGO was synthesized by controllable hydrolysis of niobium ethoxide and followed by heat treatment at 450 °C in flowing forming gas. Transmission electron microscopy images showed that Nb2O5 NCs with average particle size of 3 nm were uniformly deposited on rGO sheets and voids among Nb2O5 NCs existed. The architecture of ultrafine Nb2O5 NCs anchored on a highly conductive rGO network can not only enhance charge transfer and buffer the volume change during sodiation/desodiation process but also provide more active surface area for sodium ion storage, resulting in superior rate and cycle performance. Ex situ XPS analysis revealed that the sodium ion storage mechanism in Nb2O5 could be accompanied by Nb(5+)/Nb(4+) redox reaction and the ultrafine Nb2O5 NCs provide more surface area to accomplish the redox reaction.
RESUMEN
A solvothermal method is used to deposit Pt nanoparticles on anodized TiO2 nanotubes (T_NT). Surface characterization using SEM, EDX, and XRD indicates the formation of polycrystalline TiO2 nanotubes of 110 ± 10 nm diameter with Pt nanoparticle islands. The application of the T_NT/Pt photoanode has been examined toward simultaneous electrooxidation and photo(electro)oxidation of formic acid (HCOOH). Upon UV-vis photoillumination, the T_NT/Pt photoelectrode generates a current density of 72 mA/cm(2), which is significantly higher (â¼39-fold) than that of the T_NT electrode (1.85 mA/cm(2)). This boosting in the overall current is attributable to the enhanced oxidation of formic acid at the T_NT/Pt-electrolyte interface. Further, a series of cyclic voltammetric (CV) responses, of which each anodic scan is switched to photoillumination at a certain applied bias (i.e., 0.2 V, 0.4 V, etc.), is used to identify the role of T_NT/Pt as a promoter for the photoelectrooxidation of formic acid and understand a carbon monoxide (CO)-free pathway. Chronoamperometric (j/t) measurements demonstrate the evidence of an external bias dependent variation in the time lag during the current stabilization. An analysis of the CV plots and j/t profiles suggests the existence of both the charge-transfer controlled process and the diffusion-controlled process during formic acid photoelectrooxidation.