Relationship among oral health status, bolus formation and food comfortability during consumption of model cheeses in elderly.

The aim of this study was to investigate the impact of oral impairment on chewing behaviour, food bolus properties and food comfortability during elderly consumption of model cheeses. Seventy-two elderly persons (aged 66 to 88) was recruited and classified into two groups according to dental status (poor vs. satisfactory). They showed a wide range of salivary flow rates whatever their dental status (stimulated: 0.2-3.8 mL min-1, resting: 0.1-0.8 mL min-1). Standardized bites of four model cheeses with an identical composition but different textures (soft, hard, processed and whipped) were tested. The time and number of chewing cycles required to form a bolus were measured. The rheological properties of the bolus were studied, as was saliva moistening. Food comfortability was assessed by means of a questionnaire composed of 5 sections (1-oral comfort, 2-bolus formation, 3-pain, 4-texture and 5-flavour perception). The chewing parameters measured were not modified by the oral health. However, elderly with poor dentition formed harder boluses than elderly with satisfactory dentition. Moreover, for elderly with poor dentition, the quantity of saliva incorporated into the bolus was correlated with the stimulated salivary flow rate, which was not the case for elderly with satisfactory dentition. General oral comfort and its different attributes were poorly associated with the oral health of the elderly. A multifactorial analysis performed on an average cheese showed that food comfortability is independent of changes in the hardness and moistening of the bolus, regardless of dental status. In particular, poor dental status increases the hardness of the bolus without modifying its comfortability.

Oral processing and comfort perception of soft cereal foods fortified with pulse proteins in the elderly with different oral health status.

This study investigated the oral processing and bolus formation mechanisms of two soft cereal products fortified with pulse proteins, sponge-cake (FSC) and brioche (FB), in the elderly population, and their relationship with the perception of oral comfort. Twenty subjects aged 65 and over participated in the study. They were classified in two groups according to dental status (poor vs. satisfactory) and presented varying stimulated salivary flow rate (SSF). Bolus properties (hydration ratio, apparent viscosity and particle size) were characterized after three chewing stages. Results showed that subjects with a poor dental status (DS) had a longer chewing duration for FB, while individuals with a higher SSF had a shorter duration for FSC. Compared to FSC, more saliva was added to the FB boli, and the viscosity and particle size of FB bolus were also higher. Based on the bolus particle size evolution during chewing, FB was considered to be more difficult to fragment than FSC, this latter showing a dramatic particle size reduction from the beginning of chewing. From the viscosity data, a model was used to represent the variations of the bolus structure index during chewing and a coefficient of interaction of saliva with food was defined. For both products, the perception of comfort depended more on the DS than on SSF. Bolus apparent viscosity was related to the perception of oral comfort in FSC, while the chewing duration and the bolus particle size at the beginning of chewing contributed to explain oral comfort in FB. Finally, the comparison of these results with those obtained previoulsy with standard (i.e. non enriched) sponge cake and brioche suggested that the proposed protein fortification did not challenge the oral comfort perception by the elderly.

Relationships of oral comfort perception and bolus properties in the elderly with salivary flow rate and oral health status for two soft cereal foods.

The aim of this study was to investigate food oral processing and bolus formation in the elderly population, and their relationship with the perception of oral comfort, for two soft cereal products of different composition: sponge-cake and brioche. Twenty subjects aged 65 and over participated in the study. They were classified in two groups according to dental status (poor vs. satisfactory) and presented various stimulated salivary flow rate (SSF) in each group. Food bolus properties (hydration ratio and apparent viscosity) were characterized after three chewing stages for both groups. Results showed that chewing duration did not depend on food product but rather on physiology: subjects with a poor dental status had a shorter chewing duration. For each chewing stage, sponge-cake boli showed a higher hydration ratio than brioche boli, which showed higher apparent viscosity. For sponge-cake, perception of oral comfort was primarily driven by SSF rate, irrespective of the dental status. In the case of brioche, oral comfort was also partially explained by SSF in the case of subjects with poor dental status. This result suggests that perception of oral comfort in brioche could be driven by product related attributes rather than oral health. For both foods, a phenomenological model of bolus viscosity as a function of stimulated salivary flow and chewing duration was proposed.

Bolus quality and food comfortability of model cheeses for the elderly as influenced by their texture.

The aim of this study was to examine the influence of the texture of dairy products on bolus properties and food comfortability as perceived by elderly persons. Four cheese models identical in terms of their nutritional composition but different by the type of texture (Soft, Hard, Processed and Whipped) were developed to resemble market cheese. Study was performed with a panel of 38 elderly persons without dental impairment but with variable rate of saliva flow. The time of chewing required to form the bolus was measured. The rheological properties of the bolus obtained were studied as well as the quantity of saliva incorporated. Food comfortability was assessed by means of a questionnaire asking about in-mouth comfort, bolus formation, pain, and perceived texture and flavor. Results showed that food comfortability was positively correlated to the ease of forming the bolus which depended on the food texture. Thus, the bolus formed with the Whipped product which required more saliva, was harder than the other three products and so judged the least comfortable. This product was characterized by a dry and sticky texture. On the other hand, the Soft and Processed products led to a softer food bolus that was more easily formed, and thus were judged as more comfortable. Their textures were perceived as soft, fatty and melting. This work highlights the importance of considering food bolus formation and related properties when looking for the link between food product characteristics and the enjoyment of eating in the case of the elderly population.

Ham particle size influences saltiness perception in flans.

One major issue of the food industry is reducing sodium content while maintaining food acceptability and liking. Despite extensive research in this field, little has been published on real complex food products. The aim of this study was to investigate whether the size of particles, a parameter easily adjusted in food processing, could influence the salty taste of low-salt food product. We thus evaluated the effect of ham particle sizes (4 levels, including a zero level) on salt perception and the consumer liking of flans varying in their overall salt concentrations (low- and high-salt content). Two consumer panels, composed of 107 and 77 subjects, rated, respectively, the saltiness of and liking for the developed flans (8 samples). The outcomes of this study indicated first, that the addition of ham to flans increased the salty taste perception and second, that a decrease in ham particle size (ground ham) increased the perceived saltiness. Moreover, low- and high-salt flans were equally liked, demonstrating that food manufacturers could reduce the salt contents (here, by over 15%) while maintaining consumer acceptability through the manipulation of the size of the salt-providing particles.

Fat and salt contents affect the in-mouth temporal sodium release and saltiness perception of chicken sausages.

In cooked meats, sodium chloride is involved in taste, texture and flavour release. So a reduction in the salt content may have an impact on overall perception and acceptability. The aim of this study was to evaluate the influence of composition on sodium release and saltiness intensity in chicken sausages. The rheological properties of the sausages differed according to composition. Temporal sodium release and temporal saltiness intensity were evaluated by four selected subjects when eating sausages. At each time point, the effect of the salt level in sausages on sodium release was positive and highly significant. The effect of lipids on sodium release was negative. Concerning perception, the amount of salt used had a positive effect on saltiness intensity, and lipids seemed to exert a masking effect. Generally, clear relationships between salt levels, sodium release and saltiness intensity were found but the masking effect of lipids on saltiness intensity probably also involved texture or fat perception mechanisms.

Solid cheese consumption: quantification of oral coating.

Mouth coating, defined as the residual food that sticks to the oral surface after food ingestion, plays an important role in both the delivery of food components and mouth feel and after-feel perceptions. The aim of this work was to adapt a rapid and simple instrumental method to the quantification of food remaining after the in vivo ingestion of a solid food. This method was investigated in 12 non-trained subjects who consumed four melted cheeses differing in terms of their fat and water contents. Mouth coating was determined by fluorescence measurements using curcumin, an oil-soluble dye that had been added to the cheeses during their preparation. The results obtained showed that this method was reproducible, reliable and discriminating and could be used for solid cheeses covering a broad range of textures.

Evolution of the taste of a bitter Camembert cheese during ripening: characterization of a matrix effect.

The objective of this study was to characterize the effect of ripening on the taste of a typically bitter Camembert cheese. The first step was to select a typically bitter cheese among several products obtained by different processes supposed to enhance this taste defect. Second, the evolution of cheese taste during ripening was characterized from a sensory point of view. Finally, the relative impact of fat, proteins, and water-soluble molecules on cheese taste was determined by using omission tests performed on a reconstituted cheese. These omission tests showed that cheese taste resulted mainly from the gustatory properties of water-soluble molecules but was modulated by a matrix effect due to fat, proteins, and cheese structure. The evolution of this matrix effect during ripening was discussed for each taste characteristic.

Determination of taste-active compounds of a bitter Camembert cheese by omission tests.

The taste-active compounds of a Camembert cheese selected for its intense bitterness defect were investigated. The water-soluble fraction (WSE) was extracted with pure water and fractionated by successive tangential ultrafiltrations and nanofiltration. The physicochemical assessment of these fractions led to the construction of a model WSE which was compared by sensory evaluation to the crude water-soluble extract, using a panel of 16 trained tasters. As no significant difference was perceived, this model WSE was then used directly or mixed with other cheese components for omission tests. Among the main taste characteristics of the WSE (salty, sour, umami and bitter), bitterness was found to be due to small peptides whose mass distribution was obtained by RPHPLC-MS (400-3000 Da) and whose taste properties are discussed.

Taste active compounds in a goat cheese water-soluble extract. 1. Development and sensory validation of a model water-soluble extract.

The aim of this study was to evaluate the impact of the components of a goat cheese water-soluble extract (WSE) on its flavor by both physicochemical and sensory techniques with special emphasis on taste. After characterization of the organoleptic properties of the cheese, the WSE was extracted with pure water and submitted to successive tangential ultrafiltrations and nanofiltration. The physicochemical assessment of these fractions led to the constitution of a model mixture (MWSE) compared by sensory evaluation to the crude WSE, using a panel of 16 trained members. The results of both sensory profile and triangular tests indicate no significant difference, therefore proving that the reconstitution of the WSE was correct, thereby showing the sensory neutrality of lipids and peptides smaller than 500 Da, which had not been included in the MWSE. Moreover, the cheese gustatory characteristics are comparable to those of the WSE despite weaker levels of sharpness and astringency in the extract, the respective origins of which are discussed.

Taste active compounds in a goat cheese water-soluble extract. 2. Determination of the relative impact of water-soluble extract components on its taste using omission tests.

The aim of this work was to determine the relative impact of water-soluble compounds on the gustatory properties of a goat cheese water-soluble extract (WSE). Using a semisynthetic model mixture (MWSE) previously elaborated in physicochemical and gustatory accordance with the cheese WSE (see part 1, Engel et al. J. Agric. Food Chem. 2000, 48, 4252-4259), omission tests were performed. Among the main taste characteristics of the WSE (salty, sour, and bitter), saltiness was explained by an additive contribution of sodium, potassium, calcium, and magnesium cations, whereas sourness was mainly due to a synergistic effect involving sodium chloride, phosphates, and lactic acid and bitterness was found to result from calcium and magnesium chlorides, the impact of which was partially masked by sodium chloride. In contrast, amino acids, lactose, and peptides did not have any significant impact on WSE taste properties. To quantify the contribution of the taste active compounds to bitterness and saltiness, stepwise multiple linear regressions were performed. Those contributions were expressed as a percentage of the considered taste characteristic intensity in the WSE. The model obtained allowed up to 97.4% of the perceived saltiness to be described and approximately 85% of the bitterness.

Quantitative analyses of polar components in frying oils by the iatroscan thin-layer chromatography-flame ionization detection technique.

Frying oils collected in restaurants were fractionated into a polar and a non-polar fraction by the Iatroscan thin-layer chromatography-flame ionization detection (TLC-FID) system on Chromarod S II using hexane-diethyl ether-acetic acid (97:3:1) as the solvent system. The FID responses for Iatroscan analyses of the polar and the non-polar fraction isolated from a frying oil by column chromatography on a 5% hydrated silicic acid were studied at Chromarod load levels ranging from 1 to 16 micrograms, relative to methyl heptadecanoate as the internal standard. The correction factors were relatively constant in the range 10-16 micrograms, but increased in the range 1-5 micrograms. The amount of polar material in ten commercial frying oil samples was quantitated by the Iatroscan TLC-FID technique. Good correlations were found between the results and data obtained by column chromatography and silica gel Sep-Pak cartridges.