RESUMEN
Research on the development of new lightweight Al-Li alloys using a selective laser melting process has great potential for industrial applications. This paper reports on the development of novel aluminum-lithium alloys using selective laser melting technology. Al-Cu-Li-Mg-Ag-Sc-Zr pre-alloyed powders with lithium contents of 1 wt.%, 2 wt.% and 3 wt.%, respectively, were prepared by inert gas atomization. After SLM process optimization, the microstructure and mechanical properties of the as-printed specimens were investigated. The densifications of the three newly developed alloys were 99.51%, 98.96% and 92.01%, respectively. They all had good formability, with the lithium loss rate at about 15%. The as-printed alloy with 1% Li content presented good comprehensive properties, with a yield strength of 413 ± 16 MPa, an ultimate tensile strength of 461 ± 12 MPa, and an elongation of 14 ± 1%. The three alloys exhibited a layered molten pool stacking morphology and had a typical heterostructure. The columnar crystals and equiaxed fine grains were alternately arranged, and most of the precipitated phases were enriched at the grain boundaries. The change in Li content mainly affected the precipitation of the Cu-containing phase. When the Li content was 1 wt.%, the following occured: θ phase, T1 phase and TB phase. When Li increased to 2 wt.%, T1 and T2 phases precipitated together. When Li reaches 3 wt.%, δ' phase precipitated with T2 phase. This study provides useful guidance for the future SLM forming of new crack-free and high-strength Al-Li alloys.
RESUMEN
In this paper, micron-sized TiB2/AlZnMgCu(Sc,Zr) composites were fabricated by selective laser melting (SLM) using directly mixed powder. Nearly fully dense (over 99.5%) and crack-free SLM-fabricated TiB2/AlZnMgCu(Sc,Zr) composite samples were obtained and its microstructure and mechanical properties were investigated. It is found that the laser absorption rate of powder is improved by introducing micron-sizedTiB2 particles, then the energy density required for SLM forming can be reduced, and the densification can finally be improved. Some crystalline TiB2 formed a coherent relationship with the matrix, while some broken TiB2 particles did not, however, MgZn2 and Al3(Sc,Zr) can perform as intermediate phases to connect these non-coherent surfaces to aluminum matrix. All these factors lead to an increase in strength of the composite. The SLM-fabricated micron-sized TiB2/AlZnMgCu(Sc,Zr) composite finally shows a very high ultimate tensile strength of ~646 MPa and yield strength of ~623 MPa, which are higher than many other aluminum composites fabricated by SLM, while maintaining a relatively good ductility of ~4.5%. The fracture of TiB2/AlZnMgCu(Sc,Zr) composite is occurred along the TiB2 particles and the bottom of the molten pool. This is due to the concentration of stress from the sharp tip of TiB2 particles and the coarse precipitated phase at the bottom of the molten pool. The results show that TiB2 plays a positive role in AlZnMgCu alloys fabricated by SLM, but finer TiB2 particles should be studied.
