Dependence of psychophysical threshold on rate of applied force to the upper first molar in humans.

OBJECTIVE: The study aims to investigate the dynamic perception of a force applied to the upper first molar for different rates of force increase. DESIGN: Six volunteers (four male and two female; mean age, 27.2±2.4 years) with full natural dentition (except for the third molars) participated in this study. The psychophysical threshold for a force applied to the right maxillary first molar and the reaction time corresponding to each threshold were measured for rate of force increase of 103.74, 236.23, 354.58, 478.22 and 584.63 mNs(-1). The physical impulse, which is the integral of force over time, was calculated for each threshold. RESULTS: Psychophysical thresholds in the upper first molar increased with the rate of force increase. The reaction time corresponding to each threshold decreased with increasing force rate. Impulses corresponding to each threshold were independent of force rate. CONCLUSIONS: In the present study, the psychophysical threshold for a force applied to a molar tooth was shown to change depending on the rate of increase of the exerted force. From the viewpoint of the impulse, the dissipated energy necessary to reach the psychophysical sensation threshold was almost constant, regardless of the rate of force increase.

Effect of transient occlusal loading on the threshold of tooth tactile sensation perception for tapping like the impulsive stimulation.

The objectives of this study were (1) to establish a reliable method for detecting the force threshold of the tooth tactile sensation while avoiding experimenter bias and (2) to examine the effect of occlusal force loading on the threshold for impulsive force stimulation in subjects with normal dentition. Twenty volunteers participated in this study (10 males and 10 females; mean age, 26.6 ± 2.9 years). To simulate the bite force during occlusal tapping, a force-loading device was designed to exert impulsive force to the occlusal surface in the direction parallel to the tooth axis. The impulsive force detection threshold of the periodontal sensation was measured before and after loading 98 N of occlusal force on the left upper first molar for 1 min. Transient mechanical loading of the upper first molar caused an increase in the absolute threshold for impulsive force. This increase did not vanish immediately, and the increment of the threshold was maintained during the remainder of the experiment. A computer-controlled method for the evaluation of tooth tactile sensation using impulsive stimulation was established. Transient occlusal force loading parallel to the tooth axis increases the threshold of periodontal sensation for mechanical impulsive stimulation.