Rheological analysis and measurement of neutrophil indentation.

Aspects of neutrophil mechanical behavior relevant to the formation of adhesive contacts were assessed by measuring the dependence of the contact area between the cell and a spherical substrate under controlled loading. Micropipettes were used to bring neutrophils into contact with spherical beads under known forces, and the corresponding contact area was measured over time. The neutrophil was modeled as a viscous liquid drop with a constant cortical tension. Both the equilibrium state and the dynamics of the approach to equilibrium were examined. The equilibrium contact area increased monotonically with force in a manner consistent with a cell cortical tension of 16-24 pN/microm. The dynamic response matched predictions based on a model of the cell as a growing drop using published values for the effective viscosity of the cell. The contact pressure between the cell and substrate at equilibrium is predicted to depend on the curvature of the contacting substrate, but to be independent of the impingement force. The approach to equilibrium was rapid, such that the time-averaged stress for a two-second impingement was within 20% of the equilibrium value. These results have implications for the role of mechanical force in the formation of adhesive contacts.

Neutrophil adhesive contact dependence on impingement force.

Neutrophil capture and recruitment from the circulation requires the formation of specific receptor/ligand bonds under hydrodynamic forces. In the present study we examine bond formation between beta2-integrins on neutrophils and immobilized ICAM-1 while using micropipettes to control the force of contact between the cell and substrate. Magnesium was used to induce the high affinity conformation of the integrins, and bond formation was assessed by measuring the probability of adhesion during repeated contacts. Increasing the impingement force caused an increase in the contact area and led to a proportional increase in adhesion probability (from approximately 20 to 50%) over the range of forces tested (50-350 pN). In addition, different-sized beads were used to change the force per unit area in the contact zone (contact stress). We conclude that for a given contact stress, the rate of bond formation increases linearly with contact area, but that increasing contact stress results in higher intrinsic rates of bond formation.