RESUMEN
BACKGROUND: Formalin is widely used to fix histological preparations and as preservatives in embalming solutions and is an age-long practice in medical laboratories. It is generally accepted that the risk of contracting infections is relatively high among medical laboratory workers and pathologists. Recent studies have, however, suggested that formalin does not effectively inactivate all kinds of microbes in formalin-fixed tissue (FFT). Long time preserved tissues in formalin may develop growth of microbes on the surface of the formalin. AIMS AND OBJECTIVES: The purpose of the study is to determine the growth of microorganisms on the surface of FFTs. MATERIALS AND METHODS: Fifty-one containers of 10% formalin with fixed tissues and undiscarded formalin solution not containing tissues of years 2013-2015 (17 in each year) were selected, and samples for inoculation onto the cysteine lactose electrolyte deficient agar plates were taken from the surface of the FFT using sterile cotton tips. The growth of the colonies was checked for after 48 h. RESULTS: Out of 51 samples from 2013 to 2015, 17 had shown growth of microbial colonies. Six out of 17 samples of 2013, 7 out of 17 of 2014 and 4 out of 17 samples of 2015 had colonies of microbes on agar plates. Gram-negative bacilli, Bacillus subtilis and micrococci were mostly found. CONCLUSION: There were viable microbes on the surfaces of formalin solution containing pathology tissue. Since cross-contamination by microbes may occur during regrossing or processing, protocols to decrease cross-contamination should be instituted.
RESUMEN
Background. Maximum sealing ability or adhesion of endodontic sealers can be achieved after effective removal of the smear layer. Endodontic irrigants assist in adequate removal of the smear layer, improving the retention mechanism. The aim of this study was to evaluate the effect of two different root canal irrigation solutions (5.25% NaOCl followed by 17% EDTA and QMix) on the apical sealing ability of two different root canal sealers (MTA Fillapex and Adseal). Methods. Forty-six single-canal teeth were divided into 4 experimental groups of 10 teeth each and a positive and negative group of 3 teeth each. The root canals were prepared using step-back technique. The teeth in groups 1 and 2 were irrigated with 5.25% NaOCl followed by 17% EDTA and the teeth in groups 3 and 4 were irrigated with QMix. Finally all the teeth were flushed with sterile saline and dried using paper points. Obturation was accomplished by gutta-percha using lateral condensation technique. MTA Fillapex sealer was used in groups 1 and 3 whereas Adseal was used in groups 2 and 4. Dye penetration method was used to evaluate apical leakage. Data were analyzed with Kruskal-Wallis and Mann-Whitney U tests using SPSS 14. Statistical significance was set at P < 0.05. Results. Group 3 showed maximum amount of apical leakage (3.7±0.3 mm) whereas group 2 exhibited the least amount of apical leakage (2.1 ± 0.4 mm) among all the experimental groups. Significant differences were found in the amount of apical leakage between all the groups (P = 0.00001). Conclusion. Within the limitations of this study, 5.25% sodium hypochlorite followed by 17% EDTA and Adseal resulted in the best apical seal.
RESUMEN
AIMS: This study examined the setting time, compressive strength, and pH of white mineral trioxide aggregate (MTA) mixed with various additives: Calcium chloride (CaCl2), calcium formate (CaF), disodium hydrogen orthophosphate (Na2HPO4). MATERIALS AND METHODS: Group 1 (Control) was obtained by mixing MTA with distilled water. In Groups 2 and 3, MTA containing 10% CaCl2 and 20% CaF, respectively, was mixed with distilled water. In Group 4, MTA was mixed with 15% Na2HPO4. Setting time, compressive strength, and pH of each group were examined. STATISTICAL ANALYSIS USED: Analysis was done using Statistical Package for Social Sciences (SPSS) version 14. A P-value < 0.05 was considered statistically significant. Comparison of mean values was done using analysis of variance (ANOVA) with post-hoc Games-Howell test. RESULTS: The setting time of test groups were significantly shorter than that of control group (P < 0.001). The compressive strengths of test groups were lower than that of control group (P < 0.001). The pH value obtained for Groups 3 and 4 were higher than that of the control group (P < 0.001). CONCLUSIONS: Study result showed that additives significantly reduced the setting time of MTA and also maintained the pH at a high value. However, there was not much improvement in the compressive strength of the material.
