Usefulness of the preoperative thoracic inlet angle in comparison to the T1 slope for predicting cervical kyphosis after laminoplasty.

PURPOSE: Thoracic inlet angle (TIA) is a sagittal radiographic parameter with a constant value regardless of posture and is significantly correlated with the sagittal balance of the cervical spine. However, the practical use of TIA has not been studied. This study aimed to investigate the usefulness of the preoperative TIA for predicting the development of kyphotic deformity after cervical laminoplasty in comparison to the preoperative T1 slope (T1S). METHODS: A total of 98 patients who underwent cervical laminoplasty without preoperative kyphotic alignment were included (mean age, 73.7 years; 41.8% female). Radiography was evaluated before surgery and at the 2-year follow-up examination. The cervical sagittal parameters were measured on standing radiographs, and the TIA was measured on T2-weighted MRI in a supine position. Cervical alignment with a C2-C7 angle of ≥ 0° was defined as lordosis, and that with an angle of < 0° was defined as kyphosis. RESULTS: Postoperative kyphosis occurred in 11 patients (11.2%). Preoperatively, the kyphosis group showed significantly lower values in the T1S (23.5° vs. 30.3°, p = 0.034) and TIA (76.1° vs. 81.8°, p = 0.042). We performed ROC curve analysis to clarify the impact of the preoperative TIA and T1S on kyphotic deformity after laminoplasty. The optimal cutoff angles for TIA and T1S were 68° and 19°, respectively, with similar diagnostic accuracy. CONCLUSION: This study demonstrated the clinical utility of the preoperative TIA for predicting the risk of postoperative kyphotic deformity after cervical laminoplasty. These findings suggest the importance of the preoperative assessment of thoracic inlet alignment in cervical spine surgery.

Refined scan protocol for the evaluation of pulmonary perfusion standardized image quality and reduced radiation dose in dynamic chest radiography.

PURPOSE: Dynamic chest radiography (DCR) is a novel imaging technique used to noninvasively evaluate pulmonary perfusion. However, the standard DCR protocol, which is roughly adapted to the patient's body size, occasionally causes over- or underexposure, which could influence clinical evaluation. Therefore, we proposed a refined protocol by increasing the number of patient body mass index (BMI) categories from three to seven groups and verified its usefulness by comparing the image sensitivity indicators (S-values) and entrance surface doses (ESDs) of the conventional protocol with those of our refined protocol. METHODS: This retrospective observational study included 388 datasets (standing position, 224; supine position, 164) for the conventional protocol (December 2019-April 2021) and 336 datasets (standing position, 233; supine position, 103) for the refined protocol (June-November 2021). The conventional protocol (BMI-3 protocol) divided the patients into three BMI groups (BMI < 17, 17≤BMI < 25, and BMI ≥ 25 kg/m2 ), whereas the refined protocol (BMI-7 protocol) divided the patients into seven BMI groups (BMI < 17, 17 ≤ BMI < 20, 20 ≤ BMI < 23, 23 ≤ BMI < 26, 26 ≤ BMI < 29, 29 ≤ BMI < 32, and BMI ≥ 32 kg/m2 ). The coefficients of variation (CVs) for the S-values and ESDs acquired using the two protocols were compared. RESULTS: The CVs of the S-values in the BMI-7 protocol group were significantly lower than those in the BMI-3 protocol group for the standing (28.8% vs. 16.7%; p < 0.01) and supine (24.5% vs. 17.7%; p < 0.01) positions. The ESDs of patients scanned using the BMI-7 protocol were significantly lower than those scanned using the BMI-3 protocol in the standing (1.3 vs. 1.1 mGy; p < 0.01) and supine positions (2.5 vs. 1.6 mGy; p < 0.01), although the mean BMI of the two groups were similar. CONCLUSION: We introduced the BMI-7 protocol and demonstrated its standardized image quality and reduced radiation exposure in patients undergoing DCR.

Trends in cervical laminoplasty and 30-day postoperative complications: 10-year results from a retrospective, multi-institutional study of 1095 patients.

PURPOSE: This study aimed to investigate the recent 10-year trends in cervical laminoplasty and 30-day postoperative complications. METHODS: This retrospective multi-institutional cohort study enrolled patients who underwent laminoplasty for cervical spondylotic myelopathy (CSM) or ossification of the posterior longitudinal ligament. The primary outcome was the occurrence of all-cause 30-day complications. Trends were investigated and compared in the early (2008-2012) and late (2013-2017) periods. RESULTS: Among 1095 patients (mean age, 66 years; 762 [70%] male), 542 and 553 patients were treated in the early and late periods, respectively. In the late period, patients were older at surgery (65 years vs. 68 years), there were more males (66% vs. 73%), and open-door laminoplasty (50% vs. 69%) was the preferred procedure, while %CSM (77% vs. 78%) and the perioperative JOA scores were similar to the early period. During the study period, the rate of preservation of the posterior muscle-ligament complex attached to the C2/C7-spinous process (C2, 89% vs. 93%; C7, 62% vs. 85%) increased and the number of laminoplasty levels (3.7 vs. 3.1) decreased. While the 30-day complication rate remained stable (3.9% vs. 3.4%), C5 palsy tended to decrease (2.4% vs. 0.9%, P = 0.059); superficial SSI increased significantly (0% vs. 1.3%, P = 0.015), while the decreased incidence of deep SSI did not reach statistical significance (0.6% vs. 0.2%). CONCLUSIONS: From 2008 to 2017, there were trends toward increasing age at surgery and surgeons' preference for refined open-door laminoplasty. The 30-day complication rate remained stable, but the C5 palsy rate halved.

Radiographic Predictors of Subaxial Subluxation After Atlantoaxial Fusion.

STUDY DESIGN: A retrospective study. OBJECTIVE: The aim of this study was to clarify preoperative radiographic predictors associated with the development of subaxial subluxation (SAS) after surgery. BACKGROUND: The incidence of atlantoaxial fusion for atlantoaxial instability has been increasing. SAS can develop after surgery despite atlantoaxial fusion with the optimal C1-C2 angle. We hypothesized that preoperative discordant angular contribution in the upper and subaxial cervical spine is associated with the occurrence of postoperative SAS. MATERIALS AND METHODS: Patients who underwent surgery for atlantoaxial instability with a minimum 5-year follow-up and control participants were included. The O-C2 angle, C2 slope (C2S), C2-C7 cervical lordosis (CL), and T1 slope (T1S) were measured. We focused on the angular contribution ratio in the upper cervical spine to the whole CL, and the preoperative C2/T1S ratio was defined as the ratio of C2S to T1S. RESULTS: Twenty-seven patients (SAS=11, no-SAS=16; mean age, 60.7 y old; 77.8% female; mean follow-up duration, 6.8 y) and 23 demographically matched control participants were enrolled. The SAS onset was at 4.7 postoperative years. Preoperatively, the O-C2 angle, C2-C7 CL, and T1S were comparable between the SAS, no-SAS, and control groups. The preoperative C2S and C2/T1S ratio were smaller in the SAS group than in the no-SAS or control group (C2S, 11.0 vs. 18.4 vs. 18.7 degrees; C2/T1S ratio, 0.49 vs. 0.77 vs. 0.78, P <0.05). The receiver operating characteristic curve analysis demonstrated that the C2/T1S ratio had higher specificity and similar sensitivity as a predictor of postoperative SAS than C2S (specificity: 0.90 vs. 0.87; sensitivity: 0.73 vs. 0.73). The estimated cutoff values of the C2S and C2/T1S ratio were 14 degrees and 0.58, respectively. CONCLUSIONS: The preoperative C2/T1S ratio was closely associated with postoperative SAS. Patients with a C2/T1S ratio <0.58 were at a high risk of SAS after atlantoaxial fusion. LEVEL OF EVIDENCE: Level 4.

Improved Production of Induced Pluripotent Stem Cells Using Dot Pattern Culture Plates.

The rate of cell proliferation is a crucial factor in cell production under good manufacturing practice (GMP) control. In this study, we identified a culture system for induced pluripotent cells (iPSCs) that supports cell proliferation and viability and maintains the cells in an undifferentiated state even at 8 days after seeding. This system involves the use of dot pattern culture plates that have been coated with a chemically defined scaffold which has high biocompatibility. Under cell starvation conditions, where medium exchange was not performed for 7 days or where the amount of medium exchange was reduced to half or a quarter, iPSC viability and lack of differentiation were maintained. The rate of cell viability in this culture system was greater than generally obtained by standard culture methods. The cells in this compartmentalized culture system could be induced to differentiate in a controlled and consistent manner: differentiation of endoderm occurred in a controlled and consistent manner: endoderm, mesoderm, and ectoderm could be consistently induced to differentiate in the cultures. In conclusion, we have developed a culture system that supports high viability in iPSCs and allows their controlled differentiation. This system has the potential for use in GMP-based production of iPSCs for clinical purposes.

Adhesion Characteristics of Human Pancreatic Islets, Duct Epithelial Cells, and Acinar Cells to a Polymer Scaffold.

We reported in 2018 that among several extracellular matrices, fibronectin, type I collagen, type IV collagen, laminin I, fibrinogen, and bovine serum albumin, fibronectin is particularly useful for adhesion of porcine pancreatic tissue. Subsequently, we developed a technology that enables the chemical coating of the constituent motifs of fibronectin onto cell culture dishes. In this experiment, we used islets (purity ≥ 90%), duct epithelial cells (purity ≥ 60%), and acinar cells (purity ≥ 99%) isolated from human pancreas according to the Edmonton protocol published in 2000 and achieved adhesion to the constituent motifs of fibronectin. A solution including cGMP Prodo Islet Media was used as the assay solution. In islets, adhesion was enhanced with the constitutive motifs of fibronectin compared with uncoated islets. In the functional evaluation of islets, insulin mRNA expression and insulin secretion were enhanced by the constitutive motif of fibronectin compared with non-coated islets. The stimulation index was comparable between non-coated islets and fibronectin motifs. In duct epithelial cells, adhesion was mildly promoted by the fibronectin component compared with non-coated component, while in acinar cells, adhesion was inhibited by the fibronectin component compared with the non-coated component. These data suggest that the constitutive motifs of fibronectin are useful for the adhesion of islets and duct epithelial cells.

A chemically-defined plastic scaffold for the xeno-free production of human pluripotent stem cells.

Clinical use of human pluripotent stem cells (hPSCs) is hampered by the technical limitations of their expansion. Here, we developed a chemically synthetic culture substrate for human pluripotent stem cell attachment and maintenance. The substrate comprises a hydrophobic polyvinyl butyral-based polymer (PVB) and a short peptide that enables easy and uniform coating of various types of cell culture ware. The coated ware exhibited thermotolerance, underwater stability and could be stored at room temperature. The substrate supported hPSC expansion in combination with most commercial culture media with an efficiency similar to that of commercial substrates. It supported not only the long-term expansion of examined iPS and ES cell lines with normal karyotypes during their undifferentiated state but also directed differentiation of three germ layers. This substrate resolves major concerns associated with currently used recombinant protein substrates and could be applied in large-scale automated manufacturing; it is suitable for affordable and stable production of clinical-grade hPSCs and hPSC-derived products.

Angular accuracy of plain radiographic measurements in leg alignment: Teleoroentgenogram versus orthoroentgenogram.

BACKGROUND: The purpose of the present study was to evaluate the accuracy of the measurements associated with leg alignment on a teleoroentgenogram and an orthoroentgenogram. METHODS: The models being irradiated were manufactured and represented 10° varus and 15° varus leg alignment, in which the true values of hip-knee-ankle angle (HKAA), mechanical axis (MA) length, and percentage of MA (%MA) were already known. HKAA, MA length, and %MA were measured in various radiographic conditions of the teleoroentgenogram and orthoroentgenogram. Then, the differences between the radiographic measurement values and the corresponding true values were analyzed. RESULTS: Regarding HKAA, the teleoroentgenogram provided accurate angular measurements with minimal differences between the measurement and true value in both the 10° and 15° varus models, irrespective of the radiographic condition. In the orthoroentgenogram, the modified method measured accurate HKAA; however, the standard method showed significant angular measurement errors with a 0.6° and 1.0° difference from the true value in the 10° and 15° varus models, respectively. This angular measurement error of HKAA in the standard orthoroentgenogram became significantly larger with object-to-image distance. Regarding MA length, the orthoroentgenogram exhibited accurate length measurements. In contrast, the teleoroentgenogram showed a significant length measurement error for the MA length. Regarding %MA, significant differences from the true values of 2.0% and 2.4% were observed in the modified orthoroentgenograms of the 10° and 15° varus models, respectively. The teleoroentgenogram and standard orthoroentgenogram reproduced the accurate measurement value of %MA in the 10° and 15° varus models. CONCLUSION: A teleoroentgenogram is a reliable modality for accurate angular measurements such as HKAA and %MA. An orthoroentgenogram has the potential to measure both HKAA and length accurately if the radiographic condition was modified; however, measurement error in %MA may occur.