Characterization of yeast mutant strains for starter culture in Arabica coffee fermentation.

Arabica coffee is the most popular and best-selling type of coffee. During coffee fermentation, microorganisms are essential for the production of metabolites and volatile compounds that affect coffee flavor quality. This work aimed to study the mutation, selection, and characterization of the Wickerhamomyces anomalus strain YWP1-3 as a starter culture to enhance the flavor quality of Arabica coffee. The results revealed that six mutants could produce relatively high levels of the pectinase enzyme on pectin agar media and exhibited high activity levels, ranging from 332.35 to 415.88 U/ml in mucilage broth. Strains UV22-2, UV22-3, UV41-1 and UV32-1 displayed higher levels of amylase activity than did the wild type. The UV22-2 and UV22-3 mutants exhibited the highest pectin degradation indices of 49.22% and 45.97%, respectively, and displayed significantly enhanced growth rates in nitrogen yeast base media supplemented with various sugars; thus, these mutants were evaluated for their ability to serve as a starter for fermentation of Arabica coffee. The cupping scores of coffees derived from UV22-2 and UV22-3 were 83.5 ± 1.5 and 82.0 ± 2.14, respectively. The volatile compounds in the roasted coffee fermented by UV22-2 were analyzed by GC‒MS, which revealed higher levels of furfuryl alcohol and furfuryl acetate than did the other samples. These findings suggested that UV22-2 could be an influential starter culture for Arabica coffee fermentation.

Influence of Different Extraction Methods on the Changes in Bioactive Compound Composition and Antioxidant Properties of Solid-State Fermented Coffee Husk Extracts.

In brewing coffee, a huge amount of food waste is generated; that waste, coffee husks in particular, should be comprehensively exploited. They offer a rich source of bioactive compounds such as caffeine, chlorogenic acid, and trigonelline. The aim of this study was to investigate the effects of extraction methods on the bioactive compounds and antioxidant activity of such waste. Coffee husks in this study were fermented with S. cerevisiae based on a solid-state fermentation technique. The study method included ethanolic or water extraction with varied controllable factors, i.e., temperature (60, 100°C) and extraction technique. Bioactive contents were investigated with the Folin-Ciocalteu assay and 1H-NMR spectroscopy. The antioxidant activity was investigated with DPPH and FRAP assays. Results show that yields were the highest in the extract of fermented coffee husks at 100°C. The highest levels of bioactive contents (total trigonelline content at 3.59% and antioxidant activity at 23.35% (DPPH) and 25.9% (FRAP)) were found in the ethanolic extract of fermented coffee husks at 60°C. The bioactive content and bioactivity, including antioxidant activity, depended on different raw materials, preparation methods, and extraction conditions. This study illustrates the potential for using food waste such as coffee husks as a sustainable source of bioactive compounds or bioactive extracts.

New approach for screening of microorganisms from Arabica coffee processing for their ability to improve Arabica coffee flavor.

The purpose of this research was to isolate microorganisms from coffee fermentation processes and screen them for their potential to improve the flavor of Arabica coffee using a new approach that included pectin degradation ability and growth in mucilage broth. All of the studied microorganisms were isolated from 38 different samples of fresh coffee cherries, coffee mucilage and coffee pulp. A total of 262 microbial isolates were obtained and subjected to screening using pectinase screening agar medium for pectinolytic organisms. The results of the pectinase production test showed that 18 yeast isolates were found to produce pectinase that could degrade the pectin present in solid media. The sugar assimilation profiles and growth of selected strains in mucilage broth were studied. Therefore, 18 isolates from the selected yeasts were subjected to molecular identification by the use of 18S rRNA gene sequencing. The diversity of the yeast isolates was studied, and they were identified as Wickerhamomyces anomalus, Naganishia liquefaciens, Pichia kudriavzevii, Kazachstania naganishii and Kazachstania sp. Moreover, isolates SWU3YWP1-3, SWU3YSK9 and INFCY1-4 were used as a seed culture for Arabica coffee fermentation. The cupping sensory scores of the control (without yeast inoculation) and those inoculated with three isolated yeast strains that were determined by Q-Arabica Graders were 73.75, 84.75, 80.25 and 75.00, respectively. Unique flavors and aromas were detected. This is the first report of screening microorganisms from the Arabica coffee fermentation process by the combination of various properties with success in improving the quality of coffee beverage.

One-Pot Ionic Liquid-Mediated Bioprocess for Pretreatment and Enzymatic Hydrolysis of Rice Straw with Ionic Liquid-Tolerance Bacterial Cellulase.

Ionic liquid (IL) pretreatment of lignocellulose is an efficient method for the enhancement of enzymatic saccharification. However, the remaining residues of ILs deactivate cellulase, therefore making intensive biomass washing after pretreatment necessary. This study aimed to develop the one-pot process combining IL pretreatment and enzymatic saccharification by using low-toxic choline acetate ([Ch][OAc]) and IL-tolerant bacterial cellulases. Crude cellulases produced from saline soil inhabited Bacillus sp. CBD2 and Brevibacillus sp. CBD3 were tested under the influence of 0.5-2.0 M [Ch][OAc], which showed that their activities retained at more than 95%. However, [Ch][OAc] had toxicity to CBD2 and CBD3 cultures, in which only 32.85% and 12.88% were alive at 0.5 M [Ch][OAc]. Based on the specific enzyme activities, the sugar amounts produced from one-pot processes using 1 mg of CBD2 and CBD3 were higher than that of Celluclast 1.5 L by 2.0 and 4.5 times, respectively, suggesting their potential for further application in the biorefining process of value-added products.

Differential effects of inorganic salts on cellulase kinetics in enzymatic saccharification of cellulose and lignocellulosic biomass.

Inorganic salt pretreatment of lignocellulosic biomass has proven to be an efficient way to increase the efficiency of enzymatic saccharification. However, it is not clear that this improvement is the result of modification of the lignocellulosic substrate after pretreatment, or removal of inhibitor, or enhancement of cellulase or a combination of these events. Therefore, this study aimed to analyze the effects of inorganic salts on kinetics of cellulase enzymes (celluclast 1.5L and accellerase 1500). Two substrates rich in cellulose content [carboxymethylcellulose (CMC), avicel (AV)] and lignocellulose substrate [sugarcane bagasse (SB)] were considered. The enzymatic saccharification was carried with and without the addition of inorganic salts (NaCl and KCl) at 0.5 M and 1.0 M concentration. The kinetic parameters, Km and Vm, were determined to mechanically understand the pattern of inhibition and enhancement of inorganic salts on enzymatic saccharification. The kinetics parameters of celluclast 1.5L and accellerase 1500 for hydrolysis of CMC and AV with NaCl showed uncompetitive inhibition. Whereas, influences of KCl on both cellulase were differentiated to function in inhibition or enhancement modes when challenged with different substrates. On the other hand, enzymatic hydrolysis efficiencies of SB using both cellulases were enhanced under addition of NaCl and KCl, by increasing Vm of celluclast 1.5L from 0.303 to 0.635 mg/mL min (0.5 M KCl) and accellerase 1500 from 0.383 to 0.719 mg/mL min (1.0 M NaCl). The details of kinetic analysis in this work revealed the mechanism of inorganic salts on cellulase kinetics to be involved in substrate modification and removal of inhibitor.

Organic acid pretreatment of oil palm trunk: effect on enzymatic saccharification and ethanol production.

Effective lignocellulosic biomass saccharification is one of the crucial requirements of biofuel production via fermentation process. Organic acid pretreatments have been gained much interests as one of the high potential methods for promoting enzymatic saccharification of lignocellulosic materials due to their lower hazardous properties and lower production of inhibitory by-products of fermentation than typical chemical pretreatment methods. In this study, three organic acids, including acetic acid, oxalic acid, and citric acid, were examined for improvement of enzymatic saccharification and bioethanol production from oil palm trunk biomass. Based on response surface methodology, oxalic acid pretreated biomass released the maximum reducing sugar of 144 mg/g-pretreated biomass at the optimum condition, which was higher than untreated samples for 2.30 times. The released sugar yield of oil palm trunk also corresponded to the results of FT-IR analysis, which revealed the physical modification of cellulose and hemicellulose surface structures of pretreated biomass. Nevertheless, citric acid pretreatment is the most efficient pretreatment method to improve bioethanol fermentation of Saccharomyces cerevisiae TISTR 5606 at 1.94 times higher than untreated biomass. These results highlighted the selection of organic acid pretreatment as a potential method for biofuel production from oil palm trunk feedstocks.

Production, purification and characterization of an ionic liquid tolerant cellulase from Bacillus sp. isolated from rice paddy field soil

Background: Lignocellulosic biomass is a renewable, abundant, and inexpensive resource for biorefining process to produce biofuel and valuable chemicals. To make the process become feasible, it requires the use of both efficient pretreatment and hydrolysis enzymes to generate fermentable sugars. Ionic liquid (IL) pretreatment has been demonstrated to be a promising method to enhance the saccharification of biomass by cellulase enzyme; however, the remaining IL in the hydrolysis buffer strongly inhibits the function of cellulase. This study aimed to isolate a potential IL-tolerant cellulase producing bacterium to be applied in biorefining process. Result: One Bacillus sp., MSL2 strain, obtained from rice paddy field soil was isolated based on screening of cellulase assay. Its cellulase enzyme was purified and fractionated using a size exclusion chromatography. The molecular weight of purified cellulose was 48 kDa as revealed by SDS-PAGE and zymogram analysis. In the presence of the IL, 1-ethyl-3-methylimidazolium acetate ([C2mim][OAc]) concentration of 1 M, the cellulase activity retained 77.7% of non-IL condition. In addition, the optimum temperature and pH of the enzyme is 50°C and pH 6.0, respectively. However, this cellulase retained its activity more than 90% at 55°C, and pH 4.0. Kinetic analysis of purified enzyme showed that the Km and Vmax were 0.8 mg/mL and 1000 μM/min, respectively. Conclusion: The characterization of cellulase produced from MSL2 strain was described here. These properties of cellulase made this bacterial strain become potential to be used in the biorefining process.

Mathematical model of Chlorella minutissima UTEX2341 growth and lipid production under photoheterotrophic fermentation conditions.

To reduce the cost of algal biomass production, mathematical model was developed for the first time to describe microalgae growth, lipid production and glycerin consumption under photoheterotrophic conditions based on logistic, Luedeking-Piret and Luedeking-Piret-like equations. All experiments were conducted in a 2 L batch reactor without considering CO(2) effect on algae's growth and lipid production. Biomass and lipid production increased with glycerin as carbon source and were well described by the logistic and Luedeking-Piret equations respectively. Model predictions were in satisfactory agreement with measured data and the mode of lipid production was growth-associated. Sensitivity analysis was applied to examine the effects of certain important parameters on model performance. Results showed that S(0), the initial concentration of glycerin, was the most significant factor for algae growth and lipid production. This model is applicable for prediction of other single cell algal species but model testing is recommended before scaling up the fermentation of process.