Enhanced Transdermal Delivery of Bisoprolol Hemifumarate via Combined Effect of Iontophoresis and Chemical Enhancers: Ex Vivo Permeation/In Vivo Pharmacokinetic Studies.

Bisoprolol hemifumarate (BH) is an antihypertensive drug that is used as first-line treatment for chronic hypertension and angina pectoris. Our study was performed to enhance the transdermal delivery of BH, a hydrophilic drug active with high molecular weight, through differently prepared hydrogels. The synergistic effect of permeation enhancers and iontophoresis was investigated via both ex vivo and in vivo permeation studies. Ex vivo iontophoretic permeation studies were performed by using male albino Wistar rat skin. Cellosolve® hydrogel (F7) showed a 1.5-fold increase in Q180, Jss, and FER compared to F5 (lacking permeation enhancer). BH pharmacokinetic data were studied in human volunteers, following transdermal delivery of F7, using Phoresor® Unit II iontophoresis device, compared to conventional oral tablets. F7 showed 1.9- and 2-fold higher values of Cmax and AUC0-40, respectively compared to Concor® tablets, as well as a smaller Tmax (2.00 ± 2.00 h). The relative bioavailability of F7 was found to be 201.44%, relative to Concor® tablets, demonstrating the significantly enhanced transdermal permeation of BH from the selected hydrogel by iontophoresis, in human volunteers. Finally, results showed the successful utility of permeation enhancers combined with iontophoresis in significantly enhanced transdermal permeation of BH, despite its large molecular weight and hydrophilic nature. Therefore, this strategy could be employed as a successful alternative route of administration to conventional oral tablets.

Enhancement of Transdermal Delivery of Haloperidol via Spanlastic Dispersions: Entrapment Efficiency vs. Particle Size.

Haloperidol (Hal) is a well-known typical antipsychotic. Hepatic first pass metabolism leads to its limited oral bioavailability. This study aimed at enhancing transdermal delivery of Hal via spanlastic formulae. Hal-loaded spanlastics of Span®60 and an edge activator (EA) were successfully prepared by ethanol injection method according to a 31.41 full factorial design. In this design, independent variables were X1, EA type, and X2, Span®60 to EA ratio. Y1, percentage entrapment efficiency (EE%); Y2, particle size (PS); Y3, deformability index (DI); and Y4, percentage drug released after 4h (Q4h), were chosen as dependent variables. The Fourier-transform infrared spectral analysis showed no considerable chemical interaction between Hal and the used excipients. Both factors affected significantly all the responses except DI. Desirability of each prepared formula was calculated based on maximizing EE% and Q4h and minimizing PS. Formula F6, with X1, Tween®80, and X2, 8:2, had the highest desirability value followed by F7, with X1, Tween®80, and X2, 6:4, and both were chosen as selected formulae (SF) for further investigation. F6 (having more entrapped Hal), F7 (of smaller PS), and Hal solution in propylene glycol were subjected to ex vivo permeation test through newborn rat skin. Both formulae showed marked enhancement in drug permeation compared with drug solution. The significantly higher Q36h and J36h of F7 from F6 may indicate that the smaller particle size aided more than higher entrapment in achieving a higher permeation for Hal of 3.5±0.2µg/cm2.h. These results are promising for further investigation of this formula.

Penetration enhancer-containing spanlastics (PECSs) for transdermal delivery of haloperidol: in vitro characterization, ex vivo permeation and in vivo biodistribution studies.

Haloperidol (Hal) is one of the widely used antipsychotic drugs. When orally administered, it suffers from low bioavailability due to hepatic first pass metabolism. This study aimed at developing Hal-loaded penetration enhancer-containing spanlastics (PECSs) to increase transdermal permeation of Hal with sustained release. PECSs were successfully prepared using ethanol injection method showing reasonable values of percentage entrapment efficiency, particle size, polydispersity index and zeta potential. The statistical analysis of the ex vivo permeation parameters led to the choice of F1L - made of Span® 60 and Tween® 80 at the weight ratio of 4:1 along with 1% w/v Labrasol® - as the selected formula (SF). SF was formulated into a hydrogel by using 2.5% w/v of HPMC K4M. The hydrogel exhibited good in vitro characteristics. Also, it retained its physical and chemical stability for one month in the refrigerator. The radiolabeling of SF showed a maximum yield by mixing of 100 µl of diluted formula with 50 µl saline having 200 MBq of 99mTc and containing 13.6 mg of reducing agent (NaBH4) and volume completed to 300 µl by saline at pH 10 for 10 min as reaction time. The biodistribution study showed that the transdermal 99mTc-SF hydrogel exhibited a more sustained release pattern and longer circulation duration with pulsatile behavior in the blood and higher brain levels than the oral 99mTc-SF dispersion. So, transdermal hydrogel of SF may be considered a promising sustained release formula for Hal maintenance therapy with reduced dose size and less frequent administration than oral formula.

Novel instantly-soluble transmucosal matrix (ISTM) using dual mechanism solubilizer for sublingual and nasal delivery of dapoxetine hydrochloride: In-vitro/in-vivo evaluation.

Dapoxetine (D) suffers from poor oral bioavailability (42%) due to extensive first pass metabolism. The usefulness of transmucosal (sublingual and intranasal) drug delivery to improve bioavailability of D, a weak basic drug, has been hampered by its poor solubility in the neutral pH of the body fluids. In this study, instantly-soluble transmucosal matrices (ISTMs) of D, containing dual mechanism solubilizer (Pluronic F-127/citric acid mixture), were prepared by lyophilization technique to enhance matrix disintegration, dissolution and transmucosal permeation. The matrices were evaluated for in-vitro disintegration, wetting time, in-vitro dissolution, ex vivo transmucosal permeation, scanning electron microscopy and in-vivo studies. Dissolution studies confirmed the higher ability of ISTMs to enhance the early time point dissolution and maintain complete drug dissolution in pH 6.8 compared to conventional lyophilized matrices. The optimized ISTM gave approximately 77.54 and 88.40 folds increase of D dissolution after 1 and 3min relative to the drug powder in pH 6.8. ISTMs containing the highest F127 concentration (2%) and the lowest gelatin and mannitol concentrations (1%) exhibited the shortest in-vitro disintegration times (<10s), the fastest dissolution in the neutral pH of body fluids (∼99% in 3min) and the highest enhancement of transmucosal permeation. The relative bioavailabilities of D after sublingual and intranasal administration of ISTMs to rabbits were about 124.58% and 611.15%, respectively, in comparison to the oral market tablet. The significant increase of drug dissolution in nasal fluids, rapid permeation rate together with the improved bioavailability propose that ISTMs could be promising for intranasal delivery of drugs suffering from oral hepatic metabolism and have limited solubility in nasal fluids.

Development and evaluation of fixed dose bi therapy sublingual tablets for treatment stress hypertension and anxiety.

OBJECTIVE: A stress induced rise in the blood pressure. Some believe that patients with hypertension are characterized by a generalized state of increased anxiety. AIM: The purpose of this study is to prepare a fixed dose bi therapy using bisoprolol hemifumarate (BH) as antihypertensive drug and buspirone hydrochloride (BuHCl) as anxiolytic drug, which can be used to treat both diseases concomitantly. Using sublingual tablets is hopeful to improve the BuHCl poor oral bioavailability and to facilitate administration to patients experiencing problems with swallowing. MATERIALS AND METHODS: A total of 5mg BH and 10mg BuHCl were selected based on compatibility study. A 3×22 full factorial design was adopted for the optimization of the tablets prepared by direct compression method. The effects of the filler type, the binder molecular weight, and the binder type were studied. The prepared formulae were evaluated according to their physical characters as hardness, friability, disintegration time (new modified method and in vivo disintegration time) and wetting properties. In vitro drugs dissolute, permeation through the buccal mucosa and the effect of storage were analyzed by a new valid high pressure liquid chromatography (HPLC) method. Bioavailability study of the selected formula study was carried out and followed by the clinical. RESULTS: The optimized tablet formulation showed accepted average weight, hardness, wetting time, friability, content uniformity, disintegration time (less than 3 min). Maximum drug release could be achieved with in 10 min. In addition enhancing drug permeation through the buccal mucosa and, the maximum concentration of the drug that reached the blood was in the first 10 min which means a rapid onset of action and improved the extent of both drug's absorption. CONCLUSION: The results revealed that sublingual (F6) tablets containing both drugs would maintain rapid onset of action, and increase bioavailability. BuHCl with BH can be attributed to the marked decline in DBP and SBP. That led to a reduction in the MAP.

Microemulsion and poloxamer microemulsion-based gel for sustained transdermal delivery of diclofenac epolamine using in-skin drug depot: in vitro/in vivo evaluation.

Microemulsion (ME) and poloxamer microemulsion-based gel (PMBG) were developed and optimized to enhance transport of diclofenac epolamine (DE) into the skin forming in-skin drug depot for sustained transdermal delivery of drug. D-optimal mixture experimental design was applied to optimize ME that contains maximum amount of oil, minimum globule size and optimum drug solubility. Three formulation variables; the oil phase X1 (Capryol(®)), Smix X2 (a mixture of Labrasol(®)/Transcutol(®), 1:2 w/w) and water X3 were included in the design. The systems were assessed for drug solubility, globule size and light absorbance. Following optimization, the values of formulation components (X1, X2, and X3) were 30%, 50% and 20%, respectively. The optimized ME and PMBG were assessed for pH, drug content, skin irritation, stability studies and ex vivo transport in rat skin. Contrary to PMBG and Flector(®) gel, the optimized ME showed the highest cumulative amount of DE permeated after 8h and the in vivo anti-inflammatory efficacy in rat paw edema was sustained to 12h after removal of ME applied to the skin confirming the formation of in-skin drug depot. Our results proposed that topical ME formulation, containing higher fraction of oil solubilized drug, could be promising for sustained transdermal delivery of drug.

Formulation of ketotifen fumarate fast-melt granulation sublingual tablet.

The purpose of this study was to prepare sublingual tablets, containing the antiasthmatic drug ketotifen fumarate which suffers an extensive first-pass effect, using the fast-melt granulation technique. The powder mixtures containing the drug were agglomerated using a blend of polyethylene glycol 400 and 6000 as meltable hydrophilic binders. Granular mannitol or granular mannitol/sucrose mixture were used as fillers. A mechanical mixer was used to prepare the granules at 40 degrees C. The method involved no water or organic solvents, which are used in conventional granulation, and hence no drying step was included, which saved time. Twelve formulations were prepared and characterized using official and non official tests. Three formulations showed the best results and were subjected to an ex vivo permeation study using excised chicken cheek pouches. The formulation F4I possessed the highest permeation coefficient due to the presence of the permeation enhancer (polyethylene glycol) in an amount which allowed maximum drug permeation, and was subjected to a pharmacokinetic study using rabbits as an animal model. The bioavailability of F4I was significantly higher than that of a commercially available dosage form (Zaditen solution-Novartis Pharma-Egypt) (p > 0.05). Thus, fast-melt granulation allowed for rapid tablet disintegration and an enhanced permeation of the drug through the sublingual mucosa, resulting in increased bioavailabililty.

Improvement of dissolution properties of Carbamazepine through application of the liquisolid tablet technique.

The aim of the work was to improve the dissolution properties of the practically insoluble antiepileptic drug, Carbamazepine (CBZ) by adopting the liquisolid compaction technique. Reported liquid load factors, and excipient ratios were used to calculate the required amounts of excipients necessary to prepare the compacts or tablets according to a mathematical model. Avicel PH 102, and Aerosil 200 were used as the carrier and the coating materials, respectively, and explotab was used as disintegrant to prepare four tablet formulae, out of which formula 1 was successfully compressed into tablets. The dissolution patterns of liquisolid CBZ tablets, carried out according to the USP, were comparable to those of Tegretol. The protection of male albino mice against the convulsion, induced by electroshock, was lower in case of liquisolid tablets compared to Tegretol suspension and tablets probably due to the precipitation of CBZ in the silica pores resulting from its high dose.