RESUMEN
A 3D reduced graphene oxide (3D-rGO), a self-supported, efficient, and low-cost sorbent, was synthesised and employed in a solid-phase extraction (SPE) cartridge. As a proof of concept, it was applied to remove diclofenac from aqueous solution. After applying statistical methods to systematically investigate key parameters for optimizing the 3D-rGO cartridge performance, it reached removal and elution efficiencies of 100 % and 90 %, respectively. This SPE cartridge presented advantages compared to traditional ones as the smaller amount of material into the cartridge (mass twenty times smaller), in addition to the ability of eliminating sorbent preconditioning, reducing the use of solvents, and making the process environmentally friendly with a faster operation. Also, it presented improved reproducibility after several cycles of reuse, and finally a lower cost of production unveiled by a cost-benefit analysis. Analysis with scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectrometry, Raman, and Fourier transform infrared spectroscopy in attenuated total reflectance mode suggested that the 3D framework morphology with a high content of carbon at the surface and some residual oxygen-containing groups are the protagonists in this performance. Therefore, 3D-rGO has the potential to be a highly efficient sorbent in analytical procedures using SPE for environmental contaminants in water and effluent samples.
Asunto(s)
Grafito , Reproducibilidad de los Resultados , Extracción en Fase Sólida , AguaRESUMEN
The development of efficient advanced functional materials is highly dependent on properties such as morphology, crystallinity, and surface functionality. In this work, hierarchical flowerlike nanostructures of SrTiO3 have been synthesized by a simple template-free solvothermal method involving poly(vinylpyrrolidone) (PVP). Molecular dynamics simulations supported by structural characterization have shown that PVP preferentially adsorbs on {110} facets, thereby promoting the {100} facet growth. This interaction results in the formation of hierarchical flowerlike nanostructures with assembled nanosheets. The petal morphology is strongly dependent on the presence of PVP, and the piling up of nanosheets, leading to nanocubes, is observed when PVP is removed at high temperatures. This work contributes to a better understanding of how to control the morphological properties of SrTiO3, which is fundamental to the synthesis of perovskite-type materials with tailored properties.
RESUMEN
An experimental investigation on how the bulk and surface sensitivities of gold nanohole arrays fabricated by interference lithography affect the degree of white light beam collimation is presented. The optical transmission response of nanohole arrays has been recorded by focused and collimated beam transmission spectra. The results show that both the bulk and surface sensitivities for the collimated case are much larger than for the focused case. In particular, the shape of the spectra was dependent on the degree of beam collimation. The results showed that improved sensing performance (around 3.5 times) and higher figure of merit (around 4.4 times) can be obtained by simply adjusting the incident/collection experimental conditions in transmission measurements.