RESUMEN
BACKGROUND: Restoration efforts have led to the return of anadromous fish, potential source of food for the Penobscot Indian Nation, to the previously dammed Penobscot River, Maine. OBJECTIVE: U.S. Environmental Protection Agency (EPA), Penobscot Indian Nation's Department of Natural Resources (PINDNR), and Agency for Toxic Substances and Disease Registry (ATSDR), measured contaminants in six species of anadromous fish. Fish tissue concentrations were then used, along with exposure parameters, to evaluate potential human and aquatic-dependent wildlife risk. METHODS: PINDNR collected, filleted, froze, and shipped fish for analysis of polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs), dioxins/furans, and per- and polyfluoroalkyl substances (PFAS). Contaminant levels were compared to reference doses (where possible) and wildlife values (WVs). RESULTS: Chemical concentrations ranged from 6.37 nanogram per gram (ng/g) wet weight (ww) in American Shad roe to 100 ng/g ww in Striped Bass for total PCBs; 0.851 ng/g ww in American Shad roe to 5.92 ng/g ww in large Rainbow Smelt for total PBDEs; and 0.037 ng/g ww in American Shad roe to 0.221 ng/g ww in Striped Bass for total dioxin/furans. PFAS concentrations ranged between 0.38 ng/g ww of PFBA in Alewife to 7.86 ng/g ww of PFUnA in Sea Lamprey. Dioxin/furans and PFOS levels indicated that there are potential human health risks. The WV for mink for total PCBs (72 ng/g) was exceeded in Striped Bass and the WV for Kestrel for PBDEs (8.7 ng/g) was exceeded in large Rainbow Smelt. Mammalian wildlife consuming Blueback Herring, Striped Bass, and Sea Lamprey may be at risk based on PFOS WVs from Canada. IMPACT: Anadromous fish returning to the Penobscot River potentially could represent the restoration of a major component of tribal traditional diet. However, information about contaminant levels in these fish is needed to guide the tribe about consumption safety. Analysis of select species of fish and risk calculations demonstrated the need for a protective approach to consumption for both humans and wildlife. This project demonstrates that wildlife can also be impacted by contamination of fish and their risks can be as great or greater than those of humans. A One Health approach addresses this discrepancy and will lead to a healthier ecosystem.
RESUMEN
Passive sampling methods offer several advantages over traditional grab water sampling techniques, including time-integrative results which better represent long-term concentrations at the site and separation of the freely dissolved fraction of the contaminant which offers insight into the associated risk. This paper describes the performance of a newly developed equilibrium regimen passive sampler designed specifically for per- and polyfluoroalkyl substances (PFAS), called PFAS INSIGHT®. The sampler is effective in sampling ionic (sulfonates and carboxylates) and non-ionic (PFAS precursors) PFAS from aqueous solutions with detection limits similar or lower (depending on the analyte) to those achievable with conventional water sample analysis. Results include laboratory characterization of sorbent adsorption kinetics and adsorption isotherms for 15 PFAS analytes with carbon chain lengths of 4-12, the effects of the sample matrix on PFAS partitioning, and sorbent extraction efficiency. Results from PFAS INSIGHT® field deployments demonstrate good agreement between the concentrations calculated from the passive sampler data and the concentrations measured directly in conventional water samples. Approximately 35% of the passive sampling results were within 2-fold of the conventional water sample concentrations, 71% within 5-fold, and 88% within 10-fold.
Asunto(s)
Fluorocarburos , Agua Subterránea , Contaminantes Químicos del Agua , Agua/análisis , Monitoreo del Ambiente/métodos , Contaminantes Químicos del Agua/análisis , Fluorocarburos/análisisRESUMEN
The quality of embedded systems is demonstrated by the performed tests. The quality of such tests is often dependent on the quality of one or more testing tools, especially in automated testing. Test automation is also central to the success of agile development. It is thus critical to ensure the quality of testing tools. This work explores how industries with agile processes can learn from safety-critical system development with regards to the quality assurance of the test framework development. Safety-critical systems typically need adherence to safety standards that often suggests substantial upfront documentation, plans and a long-term perspective on several development aspects. In contrast, agile approaches focus on quick adaptation, evolving software and incremental deliveries. This article identifies several approaches of quality assurance of software development tools in functional safety development and agile development. The extracted approaches are further analyzed and processed into candidate solutions, i.e., principles and practices for the test framework quality assurance applicable in an industrial context. An industrial focus group with experienced practitioners further validated the candidate solutions through moderated group discussions. The two main contributions from this study are: (i) 48 approaches and 25 derived candidate solutions for test framework quality assurance in four categories (development, analysis, run-time measures, and validation and verification) with related insights, e.g., a test framework should be perceived as a tool-chain and not a single tool, (ii) the perceived value of the candidate solutions in industry as collected from the focus group.
RESUMEN
Per- and polyfluoroalkyl substances (PFAS) are a large class of chemicals widely used for many commercial and industrial applications and have resulted in contamination at sites across globally. Pump-and-treat systems, groundwater extraction, and ex situ treatment using granular activated carbon (GAC) are being implemented, either in full or pilot scale, to treat PFAS-impacted groundwater and drinking water. The only current method of regenerating spent GAC is to reactivate it at temperatures greater than 1000 °C, which requires large amounts of energy and is quite expensive. This research focused on development and demonstration of an effective GAC regeneration technology using a solvent-based method for PFAS-laden GAC used in water treatment. Two different organic solvents (ethanol and isopropyl alcohol) with 0.5% and 1.0% ammonium hydroxide (NH4OH) as a base additive were tested to determine the most effective regenerant solution to remove PFAS from the contaminated GAC. Based on column tests using laboratory-contaminated GAC with perfluorooctanoic acid (PFOA) and perfluorooctanoic sulfonate (PFOS), the solvent-base mix (SBM) of ethanol with 0.5% NH4OH was found to be the optimum performing regenerant solution. The GAC life span assessment showed that solvent-regenerated GAC performed similar to virgin GAC without losing its optimal performance of PFAS sorption. Further, the solvent-regenerated GAC showed optimal performance even after four cycles of solvent regenerations tested using the optimum SBM. Average percent removal in laboratory-contaminated GAC using the optimum SBM was 65% and 93% for PFOS and PFOA, respectively. Four field-spent GAC samples were also regenerated using the optimum SBM. Percent removal from these samples was found to be in range of 55%-68%. The type of GAC used, level of contamination and type of PFAS present, water type and quality, and the presence of co-contaminants may have influenced the removal capacity. Distillation experiments have shown that it is feasible to concentrate the spent solvent prior to disposal, which reduces the amount of PFAS-contaminated solvent waste produced in regeneration cycles.
Asunto(s)
Fluorocarburos , Contaminantes Químicos del Agua , Purificación del Agua , Carbón Orgánico , Fluorocarburos/análisis , Solventes , Tecnología , Contaminantes Químicos del Agua/análisisRESUMEN
Development of on-site treatment strategies for PFAS-containing investigation derived waste (IDW) will decrease the potential for secondary release following off-site disposal, lower disposal costs, and promote more effective long-term management of PFAS-laden waste. Herein, we report the application of a simple, drop-in treatment that utilizes one of two PFAS sorbents: bituminous granular activated carbon (GAC) or strong base anion exchange resin (IX) and a small circulation pump to adsorb and concentrate PFAS impacted mass from liquid IDW collected from two sites with disparate water chemistries and synthetic IDW amended with PFAS-containing aqueous film forming foam (AFFF). Bench scale intermittent circulation experiments revealed that bituminous granular activated carbon (GAC, 0.5 mg/mL) removed up to 97.0 ± 1.4% and 96.4 ± 0.5% of PFOS and PFOA, respectively, in both site-derived IDW sources. Improved performance was observed in experimental treatments containing a strong base anion exchange resin (IX, 0.5 mg/mL), where up to 99.4 ± 0.1% and 96.7 ± 0.2% of PFOS and PFOA were removed, respectively. High chloride concentrations (20 g/L) reduced removal of short chain perfluorocarboxylates (PFBA and PFHxA) using GAC or IX, but high salt concentrations had negligible effects on the removal of PFOA, PFBS, PFHxS, or PFOS. Excellent scalability was observed in mesoscale experiments, where the majority of amended PFAS mass was removed from synthetic IDW within five days of vessel circulation using two different PFAS-capture configurations. Combined PFOS and PFOA concentrations were reduced to levels below 0.07 µg/L using either GAC or IX for both configurations. Results generated in this study support the application of this approach as an economical strategy for potential waste volume reduction in IDW destined for off-site disposal.
Asunto(s)
Fluorocarburos , Contaminantes Químicos del Agua , Purificación del Agua , Carbón Orgánico , Fluorocarburos/análisis , Agua , Contaminantes Químicos del Agua/análisisRESUMEN
To study hydrocarbon biodegradation in marsh sediments impacted by Macondo oil from the Deepwater Horizon well blowout, we collected sediment cores 18-36 months after the accident at the marshes in Bay Jimmy (Upper Barataria Bay), Louisiana, United States. The highest concentrations of oil were found in the top 2 cm of sediment nearest the waterline at the shorelines known to have been heavily oiled. Although petroleum hydrocarbons were detectable, Macondo oil could not be identified below 8 cm in 19 of the 20 surveyed sites. At the one site where oil was detected below 8 cm, concentrations were low. Residual Macondo oil was already highly weathered at the start of the study, and the concentrations of individual saturated hydrocarbons and polycyclic aromatic hydrocarbons continued to decrease over the course of the study due to biodegradation. Desulfococcus oleovorans, Marinobacter hydrocarbonoclasticus, Mycobacterium vanbaalenii, and related mycobacteria were the most abundant oil-degrading microorganisms detected in the top 2 cm at the oiled sites. Relative populations of these taxa declined as oil concentrations declined. The diversity of the microbial community was low at heavily oiled sites compared to that of the unoiled reference sites. As oil concentrations decreased over time, microbial diversity increased and approached the diversity levels of the reference sites. These trends show that the oil continues to be biodegraded, and microbial diversity continues to increase, indicating ongoing overall ecological recovery.