Synthesis, structural, and optical behavior of erbium-doped silicophosphate glasses for photonics applications.

Erbium-incorporated silicophosphate glasses are very desirable in principal sectors such as photonics, optoelectronics, lasers, and illuminating diodes. The focus of the current investigation has been on determining how the erbium dopant affects the optical, physical, and structural characteristics of the silicophosphate-based glasses. The pure silicophosphate glasses and doped with various contents of erbium were prepared by the sol-gel process in this work. The noncrystalline character of the glasses synthesized was confirmed by the XRD patterns that were obtained. The optical measurement showed that the addition of trivalent erbium ions resulted in an increase in the refractive index of the samples and a decrease in their energy band gap values. It demonstrated the presence of P-O-P linkage stretching vibration modes that were both symmetrical and asymmetrical, P-O in PO4 bending vibration modes, OH group elongating and flexure vibrations, and P-O-H water absorption in glasses. The theoretical values of the optical basicity (Ʌth) increased from 0.465 to 0.472, while the values of the interaction parameter (A) decreased from 0.218 to 0.214 Š- 3 $$ {\overset{\ocirc }{\mathrm{A}}}^{-3} $$ . Silicophosphate glasses doped with trivalent erbium ions show promise as optoelectronic and optical filter system materials.

Experimental optical properties explained by density functional theory of the natural red algae for dye-sensitized solar cells application.

The present study investigates the usage of a novel natural dye derived from red algae of Morocco in dye-sensitized solar cells (DSSCs) for the first time. The main pigments responsible for sensitizing the semiconductor TiO2 coatings in the red algae were identified as phycoerythrin, carotenoid, and chlorophyll. The efficiency of a DSSC made from red algae was compared to that of a solar cell made from chlorophyll alone. The photovoltaic performance of the DSSC was evaluated through photocurrent density to photovoltage (J-V) characteristic analysis, and the efficiency was found to be 0.93%. To gain insights into its behavior, the absorbance and photoluminescence in a broad range were studied. Both absorbance and photoluminescence exhibited a broad-spectrum range. Additionally, electronic properties, such as HOMO, LUMO, energy gap, and chemical reactivity parameters, were studied using density functional theory (DFT) calculations.

Optical and morphological properties of Curcuma longa dye for dye-sensitized solar cells.

New experimental results of morphological and optical properties of Curcuma longa dye thin film were investigated. The thin films were deposited by physical vapor deposition technique. Morphological properties were measured using atomic force microscopy technique and they show a granular structure which above there are nanotubes shapes. Photoluminescence of Curcuma longa at low temperature was investigated and discussed for the first time. The temperature effect from 77 to 300 K of Curcuma longa thin film has been shown and luminescence was strongly observed. Photoelectrochemical parameters of the dye-sensitized solar cell based on Curcuma longa have been computed via the finite element method. The power conversion efficiency is about 0.86% obtained from short circuit current, open-circuit voltage, and fill factor of 0.13 mA/cm2, 0.52 mV, and 0.83, respectively. As a result, Curcuma longa dye can be applied to dye-sensitized solar cells.