RESUMEN
Excellent castability, significantly refined microstructure, and good mechanical properties make eutectic high-entropy alloys (EHEAs) a natural fit for rapid solidification processes, e.g., additive manufacturing. Previous investigations have focused on developing EHEAs through trial and error and mixing known binary eutectic materials. However, eutectic compositions obtained from near-equilibrium conditions do not guarantee a fully eutectic microstructure under rapid solidifications. In this work, a thermodynamically guided high-throughput framework is proposed to design EHEAs for rapid solidification. Empirical formulas derived from past experimental observations and thermodynamic computations are applied and considered phase growth kinetics under rapid solidification (skewed phase diagram). The designed alloy candidate, Co25.6Fe17.9Ni22.4Cr19.1Ta8.9Al6.1 (wt.%), contains nanostructured eutectic lamellar and shows a high Vickers hardness of 675 Hv. In addition to this specific composition, the alloy design toolbox enables the development of new EHEAs for rapid solidification without the limitation of previous knowledge.
RESUMEN
We report the development of a fully automatic large-volume 3D electron backscatter diffraction (EBSD) system (ELAVO 3D), consisting of a scanning electron microscope (ZEISS crossbeam XB 1540) with a dedicated sample holder, an adapted polishing automaton (Saphir X-change, QATM), a collaborative robotic arm (Universal Robots UR5), and several in-house built devices. The whole system is orchestrated by an in-house designed software, which is also able to track the process and report errors. Except for the case of error, the system runs without any user interference. For the measurement of removal thickness, the samples are featured with markers put on the perpendicular lateral surface, cut by plasma focused ion beam (PFIB) milling. The individual effects of both 1 µm diamond suspension and oxide polishing suspension polishing were studied in detail. Coherent twin grain boundaries (GBs) were used as an internal standard to check the removal rates measured by the side markers. The two methods for Z-spacing measurements disagreed by about 10%, and the inaccurate calibration of the PFIB system was found to be the most probable reason for this discrepancy. The angular accuracy of the system was determined to be â¼2.5°, which can be significantly improved with more accurate Z-spacing measurements. When reconstructed grain boundary meshes are sufficiently smoothed, an angular resolution of ±4° is achieved. In a 3D EBSD dataset of a size of 587 × 476 × 72 µm3, we focused on the investigation of coincidence site lattice ∑9 GBs. While bearing predominantly a pure tilt character, ∑9 GBs can be categorized into three groups based on correlative 3D morphologies and crystallography.
RESUMEN
Convergent beam electron diffraction (CBED) in transmission electron microscopy (TEM) was applied to determine local carbon concentrations in low-carbon transformation-induced plasticity (TRIP) steels. High-order Laue-zone (HOLZ) lines were experimentally obtained for comparison with simulation results. A new procedure for calculating carbon content is thus proposed. Retained austenite (RA) is classified into three types by morphology; the relationship between the carbon content and the corresponding RA morphology is discussed based on CBED results. Furthermore, results of X-Ray diffractometry measurements are also used for comparison.
RESUMEN
The goal of this paper is to analyse the effect of adding Al on the non-steady pearlite growth occurring in a Fe-C-Mn system. The results are discussed in terms of the partitioning of elements across the austenite/ferrite and austenite/cementite interfaces, and the modification of the pearlite driving force related to the change in carbon activity in austenite.
